Asphalt & Road Surfacing Tenders

Dismantling of the following type of road surface for laying of pipe line including sorting out and stacking of serviceable materials and disposal of unserviceable materias upto a distance of 50 m. as per instructions of Engineer -in -charge. Bitumen Road

Providing and laying 60 mm thick compacted Dense Bituminous Macadam (DBM) layer as per clause 505 of MORT&H specification, precoated stone aggregate physical requirements/grading/mix composition requirement as per Table- 500/8/9/10 respectively of MORT&H specifications for road and Bridge Works with 4.5% asphalt VG-30 penetration Grade by weight of total mix all complete as per MORT&H data book and rolled to the required specification.

[17.37]Mastic Asphalt Providing and laying 25 mm/ 50 mm thick mastic asphalt wearing course with paving grade bitumen 85/25 or VG - 30/40 @ 10.2%, fine aggregates, course aggregates, lime filler @ 17.92% of total, prepared by using mastic cooker and laid to required level and slope after cleaning the surface, including providing antiskid surface with bitumen precoated fine-grained hard stone chipping at an approximate spacing of 10 cm centre to centre in both directions, pressed into surface when the temperature of surfaces is not less than 100C, protruding 1 mm to 4 mm over mastic surface, all complete as per clause 516 of MORT&H specifications (5th Revision, 2013) [Through Rate]

Qty in asphalt Qty in asphalt asphalt Qty in asphalt

Qty in asphalt Qty in asphalt asphalt Qty in asphalt

and labour charges for applying bitumen on road surface at the rate