Loading
Loading…
Loading…
9,902 results • Best match
Urgent maintenance to EI in various offices at Civil Station Idukki General Electrical Work
OD216929/2024-2025:Supply, conveyance, installation, testing and commissioning of wall bracket fittings complete with all accessories and lamps etc. and giving connections with required length of 16/0.20mm 3 core copper conductor flex wire conforming to relevant ISS or extending the original wiring and giving connection etc. as required. (Luker Wall Light_MAIRA_LWL110-1_7W or equivalent)
Civil, Plumbing and Electrical work for Construction of Model AYUSH OPD Building at SAD Khirpai at Nischintapur PHC in the district of PASCHIM MEDINIPUR, West Bengal
Civil, Plumbing and Electrical work for Construction of Model AYUSH OPD Building at SAD Khirpai at Nischintapur PHC in the district of PASCHIM MEDINIPUR, West Bengal (Civil and electrical works)
Construction of 05 additional class room, 1 lab, boundary, gate, toilet block and renovation work including internal electrical work at Govt. HS Dhanwas Kalan block (UDISE Code 23300110804) at Rajgarh.
Construction of 05 additional class room, 1 lab, boundary, gate, toilet block and renovation work including internal electrical work at Govt. HS Dhanwas Kalan block (UDISE Code 23300110804) at Rajgarh.
GENERAL-PWD Roads Maintenance Division Kannur-Urgent Replacement of 3 KVA UPS. UPS-General Electrical Work
Electrification
Electrical work for development of new passenger halt station named Nilkunthia between RGX-RGA in PKU-HLZ section.
21 21 Laying of LT cable/cables in underground along Metre 2750.00 148.43 408182.50
please refer BOQ
SITC of wall/free standing floor mounted dust and vermin proof compartmentalized cubical panel for electrical Works, made out of CRCA sheet. Other parameters required as per point (a) Thickness of sheet shall not be less than 1.6 mm up to 600 mm length/width of any compartment and be of 2.0 mm above 600 mm. Load bearing structure shall be of 2.0 mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartment shaving bolted type doors with/without detachable extension type structure (b) Panel shall be duly treated for derusting in 7 tank process with de phosphating and with powder coating of minimum 70 microns on both side of panel in desired shade The panel having PU/Neoprene rubber gasket of not less than 3mm thickness, required hardware, separate detachable gland plate M.S. base channel (min 75mm), hinged door with locking arrangement for equipment/switchgear c) Interconnection between bus bar and switch gears/cable shall be rigidly supported and made out by flexible copper wires (upto 125 amp) and by solid bus bar (> 125). (d) Only outer area on all sides shall be measured & panel to be fabricated only from CPRI approved fabricator CPRI Test certificates to be submitted) All as per pre approved by Engineer in charge.
