Metals & Allied Products Tenders

ANTACID CHEWABLE CONTAINING DRIED ALUMINIUM HYDROXIDE IP 250MG MAG HYDROXIDE NF 250MG METHYL POLYSILOXANE 50 MG DIGENE TAB

Splint Nasal 0dot5 mm thick Aluminium

FRAME,BREAKER PLATE,1SET-1NO RHS&1NO LHS $FOR CRUSHER TRM54 TRF FRAME BREAKER PLATE,MN STEEL FOR CRUSHER NO-3 AND 4 FOR CHP,MODEL-TRM-54,SL NO. 4493,4494,MAKE-TRF (1SET=1NO LHS + 1NO RHS PLATE)

(A) DINING TABLE Dining Table: Polished finish SS Dinning Table consists of Dinning Top is made up of 1 mm thickness Stainless steel sheet of SS 304 Grade with overall dimension of 1800(L) X 700(D) X 750(H). The table top is reinforced with a 18 mm ply Board on Stainless steel frame of square section 40mmx40mmx1.6mm. Dinning top of stainless steel sheet shall be extended to the sides and a depth upto 40 mm under the table top in all directions including edge rounding, grinding and finishing etc. all complete. The Table top shall finish in such a manner to avoid any sharp edges. The table will be supported by four hollow legs made from SS 304 grade stainless steel. The hollow legs shall be of square type of size 50mmx50mmx1.6mm. These legs shall be securely welded or mechanically fastened to the underside of the tabletop frame. For additional structural stability, stainless steel cross supports shall be provided between the legs as shown in figure with 40mmx40mmx1.6mm SS square section. The table shall include rubber shoes at the bottom of each leg to prevent floor damage and ensure stability. The design shall prioritize user safety with no sharp corners or edges. The table must be structurally sound and capable of supporting a uniformly distributed load of at least 250 kg. All materials used must conform to relevant IS standards, and the finished product should be free from burrs, dents, or deformities. Note - Dimensions mentioned are indicative. Actual may vary as per site requirements

Number/Police/Stop Plate (Steel)TATA 407BQ