Painting Works Tenders

Supply of 12 KV, 4-way RMU (Outdoor) (CTTC) with 2 Nos. 630A load break switch (LBS) unit & 2 No. 630A vacuum circuit breaker (VCB) unit totally enclosed in not less than 2 mm, robotically welded & SF6 gas filled stainless steel tank, extensible, with current transformers, protection relays, 24 V 26 AH battery, 230V, 5 A battery charger,11000 / 230V 100VA class 0.5 resin cast auxiliary transformer for battery charger, 12Nos. of right angle boots, VPI, FPI including earth fault, over current and short circuit protection. The RMU outer shell should be totally fabricated with 14 SWG CRCA & GI sheets with powder coated painting after a 7-tank process suitable for outdoor installation.

OD44777/2026-2027:Painting with synthetic enamel paint of approved brand and manufacture of required colour to an give even shade:One or more coats on old work

Painting new iron works such as steel doors, windows, ventilators, window bars, balustrades etc., with two coats of best approved first quality and colour of synthetic enamel paint over the existing red oxide priming coat in all floors excluding cost of priming coat etc., complete complying with standard specification and as directed by the departmental officers. (The make, quality and colour of paint should be got approved by the Executive Engineer before use on works.)

wall painting of acrylic smooth paint

wall painting of acrylic smooth paint

OD189507/2025-2026:Providing and fixing of direction and place identification retro-reflectorised sign with 7 years warranty manufactured as per IRC :67 made of Type IV micro prismatic grade sheeting fixed over aluminium sheeting, 2 mm thick/ aluminium composite material sheeting 4 mm thick with area not exceeding 0.9 sqm, with suitable back supporting frame of MS angle 40x40x6 and supported on GI pipe pole 50mm NB-2 nos confirming to IS 1239 firmly fixed to the ground by means of properly designed foundation with M 15 grade cement concrete min size 40 cm x 40 cm x 60 cm, 60 cm below ground level including painting all exposed surface with 2 coats of epoxy painting over epoxy primer and as per approved drawing and clause 801 including lettering symbols etc. (Derived from MoRD spec 10.3.A.2)