Loading
Loading…
Loading…
1,426 results • Best match
SPL REPAIR OF BOREWELL AT CHARDUAR PUMP HOUSE UNDER GE (N) TEZPUR
M&L for Development of tube well with compressed air and after with 25% extra capacity pump by pumping muddy water.
AUGMENTATION OF ELECT SUPPLY OF BH UNDER GE (S) TEZPUR
Supply, installation, testing and commissioning of indoor type VCB panel board 11 KV 630 A, 3-Phase, 50 Hz AC supply system made of sheet metal duly painted (powder coated) totally enclosed free standing, floor mounted type with track mounted VCB horizontal / vertical isolation and horizontal draw out type, cubical should have not less than IP-43 Class degree of protection, copper bus bar, pre-wired for controller and accessories using copper conductor, suitable for side extension in both directions and provision for cable entry / outgoing system complete and comprising of the following :- INCOMING FEEDER PANEL = 01 No. OUTGOING FEEDER PANEL = 01 Nos. BUS COUPLER PANEL = 01 Nos
Construction of New Road Dahej bye pass to azad garden T.P. ROAD (0/0 to 1/20 km.) Under Bharuch Ankleshwer Urban Development Authority (BAUDA) at Bharuch
Planting Flowering plants & Shrubs in central verge with all lead & lift, plant
Construction of Bridge at Ch 6.50 km (Working Ch 6.20 km) on Road From Gangasandra sirivara To Mallasandra (NH 206) Via Kumkumanahalli in Tumakuru Taluk.
Solar Raised Pavement Markers - Supplying & fixing of Solar Raised Pavement Markers made of polycarbonate molded body with circular shape, solar powered, LED self illumination in...
M & R to Various Roads of R & B Division, Bhuj (Annual Rate Contract) (Providing Road Furniture work)
86 1.00 Solar Stud: Supplying of Solar 2088.68 Rupees Two Each
Construction of Bridge at Ramadurg-Manvi SH-14 Km. 42.60 (Near Badami Town Bus Stand) in Badami Taluka Bagalkote Dist. Under H/A 5054-80-190-0-01-132 KRDCL Capital Exependiture for the Year 2025-26
53 . Solar Raised Pavement Markers - Supplying & fixing of Solar Raised Pavement Markers made of polycarbonate molded body with circular shape, solar powered, LED self illumination in active mode, 360 degree illumination and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face in passive mode. The marker shall support a load of 20000 kg tested in accordance to ASTM D 4280. The marker should be resistant to dust and water ingress according to IP 65 standards and should withstand tempertures in the range of 0 C to 70 C. Color of lighting could be provided in red or yellow (amber) as per requirement and typicl frequency of blinking is 1 Hz. There should be current losses of less than 20 microamperes at 2.4 V in sleepcharging mode to enhance the life of the marker and a full charge should provide for a minimum autonomy of 50 hours. The height, width and length of the marker shall not be less than 10 mm x 100 mm x 100 mm. Also, the surface diameter of the marker shall not be less than 100 mm respectively. The weight of the marker shall not exceed 0.5 kg. Fixing will be by drilling holes on the road for the shanks to go inside, without nails and using epoxy resin based adhesive and complete as directed by the Engineer . 8.32 . each 2163 2 4326