Street Lighting Tender Results

long life LED street light made up of pressure die-cast aluminium housing with high efficiency LEDs as lighting source and lens embeded PC cover having top opening separate driver compartment with IP66 protection and automated lighting fixture that uses integrated sensor to deduct motion or changes in light level brightness upto 50% and once sensor detected the motion it comes to 100% for few minuts then again comes down upto 50% brightness and illuminaying an area only when necessary with high efficiency long life LEDs with In- built electronic driver complete housed in pressure die-cast aluminium housing covered with polycarbonate cover with IP66 degree of protection and provision of 3 core pvc insulated and pvc sheathed twisted three core flexible copper wire of 1.0 sqmm from LED fitting connector to GI bracket outlet. "

Supplying, installation, Testing & Commissioning of Street light LED fixture powder coated pressure die cast aluminium body with driver as per the requirement with Driver fficiency >85%, Input voltage: 140-270 Volt AC, frequency 50/60 hz, Operating temp range -5 0C to 50 0C, internal urge protection of 5 KV L,N,E as per IEC 61000-4-5, Driver efficiency >85%,THD 10% as per IEC 61000-3-2, P. F.≥0.95, IP-66,IK-10, CRI >70, under voltage and over oltage protection, EMIEMC As per CISPR -15, lenses for beam angle as per IESNA type I/II/III as per the width of the road and the project requirement., suitable to fit in up to 65mm dia pipe, life time (LED, Driver & electrical circuitry) of minimum 50000 Burning Hours with 70% of initial Lumen maintained till life ends as per LM80 extrapolation IES TM-21-11 report, CCT 3000°K / 4000°K / 5700°K /6500°K (As per ANSI Bin),SDCM (Standard Deviation Colour atching) 5, Maximum power consumption should not more than the specified rating and Fixture shall be of relevant BIS standard complete in all respect i/c external connections with 1.5 sq.mm FRLS/HFFR, PVC insulated copper conductor single core cable and earthing etc. as required with Minimum 5 year OEM warranty. System lumen efficacy ≥105 120 lm/Watt output .LM79 & LM80 Test report and all testing required for LED fixtures as per BIS shall be submitted. hape size and CCT shall be as approved by Engineer-in-Charge as per requirement. (Thermal management: heat sink of aluminium housing such that LED junction temperature shall not rise above 90°C).

90W LED STREET LIGHT FITTING LED Street Light Fittings complete unit with LED assembly Constant current driver Epoxy coated housing optics and mounting accessories Wattage- 90 Watts OR nearest higher wattage is acceptable Fitting should be suitable for mounting on 40 mm OR 50 mm diameter pipe Clamps OR fixtures required for mounting if any should be provided by the supplier Note- a- Offered make shall be mentioned in the offer The same make shall be supplied in case of PO is placed b- General specifications for LED light fittings are at Annexure-A c- Test Certificate shall be furnished with supply d- Warranty Certificate for minimum 3 years from the date of supply shall be furnished with supply In case of failure of material during warranty period the vendor shall repair OR replace the faulty material without any financial implication to SAIL-VISL Bhadravathi

eProcurement System Government of Maharashtra Created By: Pratiksha Katkar Created Date/Time: 11-Dec-2025 09:02 AM Tender Title: Providing Street Light by LED Street Light At Nagafdevala Tal PachoraDist Jalgaon Tender ID: 2025_JALGA_1253651_1