Where does Jarden show up in tenders?

Brand profile

JARDEN in government tender approved make lists

JARDEN is named as an approved or preferred make in 3 government tenders tracked by Tenderkart, across 3 item listings. PWD names it most often, Jammu And Kashmir is its strongest state and it is most often listed for ZINC Flat lock Tile SystemProviding and fixing of Titanium Zinc Flat lock - 425 mm flat lock tile System in 0.7 mm thick in comprising of the following layers:Top Layer – Supply & Installation of zinc titanium Flat lock wall cladding system in pre weathered Nova finish 0.7 mm thick consisting of Fixing clips & strips made of galvanized steel.to connect the zinc panels to the decking sheet. Panel Size shall be 425X425 mm maximum. All installation is to be carried out by approved trained roofing installer. The installation team shall be fully trained and approved by the manufacturer. The sheeting Supplier shall have ISO 9001/14001 quality certifications for their manufacturing units.Pre-weathered titanium zinc with a matte subtle brushed surface in a natural medium-grey colour. The uniform medium-grey surface of Zinc originates after a chemical surface treatment following the rolling process. A temporary organic layer as a top coat is also applied to protect the surface against fingerprints (AFP). An Anti-Fingerprint coating is applied to prevent fingerprints during installation and to optimize machine processing. AFP coating shall be provided from original sheeting manufacturer with certificate. No Permanent coating or lacquer layer should be applied as a top coat. The material properties shall be as follows: Ultimate tensile strength: minimum 150 N/mm2,0.2% Proof Stress: min 110 N/mm2. All installation is to be carried out by approved trained roofing installer. The installation team shall be fully trained and approved by the manufacturer. The sheeting Supplier shall have ISO 9001/14001 quality certifications for their manufacturing units.The zinc roofing sheets shall be as per EN 988 standards .complete job.approved brand and iso certified. 2) SECOND LAYER- Anti-abrasive breathable membrane - Anti abrasive made of High density polyethylene film in grey colour. Membrane shall be 0.6 mm thick as per zinc sheeting recommendations4) FOURTH LAYER - 0.47mm TCT Hi-Tensile steel sheets profile with nominal 3.0 - 4.0 mm deep ribs at pitch of nominal 48 - 52 mm as per zinc sheeting recommendations. Purlins to be provided at a apscing of 1000-1200 mm centre to centre maximum.Purlins to be provided at a apscing of 1000-1200 mm centre to centre maximum.ZINC FLASHING IN 0.70 MM THICK.Supply & fixing of 0.7 mm zinc flashing of Maximum Girth 166mm in the same finish as thecladding finish for eaves , junctions, gables ,ridges,fascia,gutters ,etc as required for site detailing .MAKE LIST :.