Repair to pathway boundary wall and Entry Gate of ground adjacent to Inspection Bungalow in the Estate

M&L for rough excavation not exceeding 1.5 m deep and getting out in soft soil.

M&L Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm.

Surface dressing, n exc. 15 cm deep, clean the surface in soft soil.

Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand;

S&F of Plastic dividing strips, 1.5mm thick, width of strip 38mm.

M&L for brushing neat cement slurry with 3.0 kg of cement per sq.m & rendering 15mm thick cement plaster 1:4 on wall & surface to be finished even & smooth without using extra cement .

Removing cement mortar from and cleaning bricks, stacking for measurement including all extra handling and removal and disposing off rubbish.

M&L for primer paint one coat and exterior plastic emulsion paint two coats on surfaces of any description over 10cm girth or width, not otherwise described (Make - (Asian paints / Nerolac/ Berger) as approved by EIC.

M&L for 3mm thick wall care putty on wall (JK/ Birla putty).

M&L for Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips.

M&L Framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings framework of water tanks and similar work conforming to Fe.290.Gde-E-165

S&F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts;posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165

S&F Chain link MS galvanisd fencing, any size or type including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire .

M&L for Preparation of new surface Surfaces of any description, over 10cm in width or girth, not otherwise describedand apply one coat of red oxide zinc chrome primer and two coat of synthetic enamel paint ordinary tint.(steel surface).

M&L for cutting chases, pinning in making good to facing where require and pointing in cement morter 1:3 to ends or edges of landings, steps, cills, sunssades, shelves, lintels, etc. and cutting chases for concealed water tubing or concealed conduit wiring etc. and making good, cutting not exc 10cm grith in brick walls

M&L for wiring for circuit/submain wiring along with earth wire with the following sizes of FR is PVC insulated copper 2x4.0 sq. mm + 1x2.5 sq. mm earth wireconductor, single core cable in surface/ recessed as required in PVC conduit (Make Finolex/ Havells/ Anchor) (Incl. JB/ concelled boxes etc.)

M&L for 1.5sq.mm 2 core speaker wire in PVC conduit (Make Finolex/ DC/ Krystal) (Incl. JB/ concelled boxes etc.).