Installation of gear coupling, installation of top bottom rollers, striking plate of 1000mm wide 19XD belt conveyor in LHCM-2 section of R-VII seam at 3n4 Incline, J.P.Colly.

Amount

Loading, transportation & unloading of complete gear coupling set(from surface), DA- oxygen cylinder from surface to site partly manually and partly with help of haulages, chain pulley block(from 74BL/-9D) to site (19XD/37L)partly manually and haulage, mechanical puller(manually) from surface to site (Distance--- approx. 2500mtr.)

Dismantling-pulling of out of order gear coupling complete from gear box & drive drum shaft after removing of gear box.

Fitting-hammering-grinding- filling of gear coupling complete on gear box.

fitting-alignment of gear box- drive drum-motor and trial run of the belt conveyor.

Loading, transportation & unloading of 20mtr ISMB-200, 50mtr ISMC-150, 50mtr ISA- 65X65X6, DA-oxygen cylinder from surface to 19XD/37L in R- VII seam with help of haulages.

Necessary cleaning near loop take up area of 19XD belt.

Removal of belt at loop take up, jointing & tensioning of belting of 19XD belt conveyor and trial run.

Dismantling of loop structure complete & removal of loop drums-loop trolley from belt.

Nessecary Fabrication of worn out loop take up unit of 6 mtr long and Fixed drum unit base frame by usage of (ISMB-200 & 250 joist, ISMC-150 & 125 Channel, IAS- 90*90*8 & 65*65*6 angle, Ms plate-20 mm thick) at site

Fittings of loop take-up frame and fixed drum unit at site

Nessecary Fabrication of worn out Movable trolley for loop take up unit by using (ISMB-200 joist &MS plate-20 mm thick) at site Fitting of loop trolley with 01 no drum at site

Fittings of loop trolley with 01 drum at site

Nessecary fabrication and fitting of worn out tension arrangement frame by usge of (ISMB-200 joist IAS-65*65*6 angle, Ms plate-20 mm thick) at site

Transportaing, Laying, Lapping, Jointing & Tensioning of about 12 mtr. Belting on loop take up and trial run.

Transportation of 60 nos. 1000mm Bottom rollers, 40 nos top roller, 3 nos. decking plate (1.5mX1.5m), 12mm plate (2mX2m), Oxygen and DA cylinder from surface to site at 19XD/50L

Fitting of Bottom rollers after proper alignment of foot stools

Fitting of top rollers after proper alignment of structures

Fitting of decking plates at drive head and tail end

Fitting of striking plate at discharge point after necessary fabrication

Supply of DA cylinder

Supply of Oxygen Cylinder

Total impact of GST for the purpose of CTC

K R ENTERPRISE

N.K. ENTERPRISE