SPECIAL REPAIR TO (M O) FOR COVERSION OF LT OH LINE TO UG CABLE INCLUDING ALLIED WORKS FROM PH-1 PUMP HOUSE TO WAR MEMEORIAL, UNDER GE NORTH BANGALORE

Amount

Taking down ACSR conductors any size/type without any damage to existing pole and making good the surface complete all as directed.

Dismantling Cross - arms of MS channel or angle section support, Nuts and bolts, clamps, Anticlimbs device, danger notice board etc without any damage to existing pole and making good the surface complete all as directed.

Taking down earth wire 4 mm dia complete all as directed.

Dismantling of insulators any type and size without any damage to existing pole and making good the surface complete all as directed.

Replacement of moulded (FRP) junction box with IP 65 protection of size 300x200x80mm with 32 Amp 4 way heavy duty terminal block with 6Amp MCB SP and two number of cable entry gland of standard size with MS clamps of 25mmx3mm-02 nos with GI bolts, nuts and washers to fix with pole complete all as directed

Replacement of wiring in conduit 2 runs of FRLS PVC insulated 2.5 sq mm single core multistranded copper conductor cable and one run of 2.5 sq mm copper wire single core multistranded FRLS as earth continuity conductor drawn through and including PVC conduit 20 mm external dia fixed on poles and connecting up complete all as directed

MCCB 4 pole 415 volts 40 Amps 16 KA including lugs, cable gland and complete accessories as per site requirement complete all as directed

MCCB 4 pole 415 volts 200 Amps 36 KA adjustable type including lugs, cable gland and complete accessories as per site requirement complete all as directed

MCCB 4 pole 415 volts 250 Amps 36 KA adjustable type including lugs, cable gland and complete accessories as per site requirement complete all as directed

Earthing complete with galvanized steel earth plate electrode 60 cm x 60 cm x 6mm thick buried directly in ground vertically to a depth not less than 2.25 mtr below ground level with top edge of earth plate at a depth not less than 1.5 mtr connected to galvanized strip 25 x 4 mm as earth lead up to 7.5 mtr long by means of nuts, bolts, thimbles, check nuts and washers etc made of galvanized iron connected to earthing test point all as shown in electrical plate No 3 of SSR Part-I 2010 and as specified or indicated and testing on completion including earth work and excavation in any type of soil PCC (1:3:6) type C1 chamber, pre cost slab 40mm thick in cement concrete (1:2:4) type B1 with 8 mm dia MS bars reinforced at 10 cm centre to centre both ways including funnel with watering pipe wire mesh and lugs, including test point complete all as directed.

Supply, laying, jointing, commissioning and testing LT cable 1100 volts grade, XLPE insulated armoured and PVC bedded with stranded aluminium conductor heavy duty, including cable glands, cable lugs etc. to suit the cable size, laid in trenches, fixed along the poles bare or through G.I. Pipe laid under floors road etc, fixed concealed in walls encased in G.I. Pipe etc , complete all as directed LT Cable 150 Sq mm,3.5 core complete all as directed.

All as per item No 11.1 hereinbefore but LT Cable 120 Sq mm,3.5 core

All as per item No 11.1 hereinbefore but LT Cable 95 Sq mm,3.5 core

All as per item No 11.1 hereinbefore but LT Cable 70 Sq mm, 3.5 core

All as per item No 11.1 hereinbefore but LT Cable 50 Sq mm, 3.5 core

All as per item No 11.1 hereinbefore but LT Cable 35Sq mm, 3.5 core

All as per item No 11.1 hereinbefore but LT Cable 25 Sq mm, 3.5 core

All as per item No 11.1 hereinbefore but LT Cable 16 Sq mm, 4 core

All as per item No 11.1 hereinbefore but LT Cable 10 Sq mm, 4 core

Excavation in trenches not exceeding 1.5 m wide and not exceeding 1.5 m in deep for cable and getting in soft/loose soil complete all as directed.

Returning refilling including spreading, leveling, watering and well ramming in layers not exceeding 25 cm thickness of each layer complete all as directed.

Removing surplus spoil to a distance not exceeding 50 metre and depositing where directed at a level not exceeding 1.5 m above the starting point complete all as directed.

Sand cushioning with a layer of river sand 23 cm thick under and above the cable complete all as directed.( Note: Punned/Compacted thickness shall be measured for payment purpose)

Sub class B burnt clay bricks designation 75 (old Size) for cable protection complete all as directed.

GI tubing light grade 40mm bore with all fitting laid in trenches/walls/Roads for cable protection complete all as directed.

GI tubing light grade 25mm with all accessories for cable protection fixed on poles including necessary MS clamps, bolts and nuts etc complete all as directed.

Outdoor type double door sheet metal enclosure/Junction box with aluminium bus bar including MCCB 4 pole 415 volts 160 Amps 25 KA complete all as directed. Make: IndoAsian/Havells/Legrand/Standard/Schneider/L&T

Supply, testing and commissioning weather and vermin proof L.T. feeder pillar box (Main feeder pillar) factory fabricated outdoor cubicle/kiosk type CPRI approved and confirming to IS 5036 totally enclosed made out of 3.15 mm thick sheet metal enclosure with angle iron frame of M.S. angle 50x50x6 mm suitable for operation on 3 phase 4 wire, 440 volts 50 HZ system, with hinged panel centre opening front and rear opening doors (covers) with handles, each control switch to be fixed in each compartment with hinged door, bottom gland plate and locking arrangement consisting of sufficient Nos of circular cable entry holes at bottom only with suitable PVC/rubber bushes to prevent ingress of water/vermin etc, inside the enclosure, the required nos of holes to be fixed with chromium plated brass cable glands for cable entry and exit complete with necessary internal wiring with stranded copper conductor PVC insulated cables of adequate size,

Supply, testing and commissioning weather and vermin proof LT feeder pillar box factory fabricated outdoor cubicle/kiosk type CPRI approved and confirming to IS 5036 totally enclosed made out of 3.15 mm thick sheet metal enclosure with angle iron frame of M.S. angle 50x50x6 mm suitable for operation on 3 phase 4 wire, 440 volts 50 HZ system, with hinged panel centre opening front and rear opening doors (covers) with handles, each control switch to be fixed in each compartment with hinged door, bottom gland plate and locking arrangement consisting of sufficient Nos of circular cable entry holes at bottom only with suitable PVC/rubber bushes to prevent ingress of water/vermin etc, inside the enclosure, the required nos of holes to be fixed with chromium plated brass cable glands for cable entry and exit complete with necessary internal wiring with stranded copper conductor PVC insulated cables of adequate size,

Supply, testing and commissioning weather and vermin proof L.T. feeder pillar box factory fabricated outdoor cubicle/kiosk type CPRI approved and confirming to IS 5036 totally enclosed made out of 3 mm thick sheet metal enclosure with angle iron frame of M.S. angle 50x50x6 mm suitable for operation on 3 phase 4 wire, 440 volts 50 HZ system, with hinged panel centre opening front and rear opening doors (covers) with handles, each control switch to be fixed in each compartment with hinged door, bottom gland plate and locking arrangement consisting of sufficient Nos of circular cable entry holes at bottom only with suitable PVC/rubber bushes to prevent ingress of water/vermin etc, inside the enclosure, the required nos of holes to be fixed with chromium plated brass cable glands for cable entry and exit complete with necessary internal wiring with stranded copper conductor PVC insulated cables of adequate size

Street light fitting 60 W LED with pressure die cast housing, toughened glass and individual LEDs with secondary optics and IP 66 protection including taking down old unserviceable fittings complete all as directed. Make:- Bajaj, Cat No:- BRTFG 60W LED V3 or Equivalent of philips/Crompton /Havells

Replacement of GI pipe bracket made of 40mm bore light grade GI pipe 1.5 mtr long suitably bent to shape and fixed on pole for fixing street light fitting with 2 Nos suitable MS clamps of size 25 x 3 mm size including bolts, nuts, washers and provision of pole cap fitted to upper end part of the pole complete all as directed.

Cable jointing kit for 1.1KV grade cable for straight through joint (Cold shrinkable type) complete with jointing material and accessories suitable for 3.5 core, 25sqmm XLPE armoured aluminium conductor cable complete all as directed.

All as per item No 25.1 hereinbefore but 3.5 core x 95 Sqmm complete all as directed.

Plain cement concrete 1:3:6 type C1 with using 20mm graded stone aggregate in coping of poles including necessary form work complete all as directed.

Boring of holes under road, pavement, hard standing by trenchless technique and necessary machine including and inserting of HDPE pipe of bore 100mm dia complete all as directed.

H S S ENGINEERS AND CONTRACTORS

B5BUILDING SOLUTIONS

Vasavi Electricals

GS TRADERS