SPECIAL REPAIR TO OFFICE COMPLEX BOUNDARY WALL WITH BARBED WIRE FENCING OF 22 UP (G) BN NCC MEERUT AT 6/1 AND 6/2 RA LINES AND SPL REPAIR TO MANHOLES SEWAGE LINE SEPTIC TANK SOAK WELL DRAINS ETC AT OFFRS MD ACCN AT SUNDER JI ENCLAVE UNDER GE (N) MEER

Amount

Excavation in trenches n.exc 1.5m wide and n.exc 1.5m deep and getting out in any type of soil complete all as specified and directed.

All as per item No 1.00 but in soft/loose soil completed all as specified & directed.

Returning filling in including spreading, levelling, watering and well ramming in layers n.exc 25cm thick in soil complete all as specified and directed.

Removal of excavated soil to a distance n.exc 50m and depositing where directed at a level n.exc 1.5m above the starting point complete all as specified and directed.

Demolition of brick work or stone/boulder masonry, build in cement mortar including all quoins, arches, pillars etc, but excluding ashlars facings, dressed stonework and precast concrete articles complete all as specified and directed.

M&L brick work with sub class 'B' bricks straight or curved on plan exc 6m mean radius with old size bricks built in cement mortar 1:4 complete all as specified and directed.

All as per item No 6.00 above but except bricks complete all as specified and directed.

Taking down cement plaster any description on brick or stone wall/ceiling etc including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed.

M&L Rendering 15mm thick on brick surfaces in cement mortar 1:3 manhole plaster finished even and smooth without using extra cement including mixing intergral water proofing compound in the proportion as mentioned in manufacturer's instructions complete all as specified and directed.

All as per item No 9.00 but in cement mortar 1:4 complete all as specified and directed.

Supply only integral water proofing compound of approved manufacturer complete all as specified and directed.

Dismantling of cast iron ,PVC or reinforced concrete drain pipes, 75/110/150/200 mm dia, jointed in cement mortar and taking out of trenches, if required, Complete all as specified and directed.

S&F 75mm bore PVC (SWR) pipes single socketed, in any length with rubber ring joints, fixed to walls complete all as specified and as directed.

S&F 110mm bore PVC (SWR) pipes single socketed, in any length with rubber ring joints, fixed to walls complete all as specified and as directed.

M&L Ultra P E,DWC (Double wall corrugated) pipe confirming IS-16098 Part-2 2013 pertaining structure wall plastics pinning system for sewage 200mm and above bore pipe SN8 and all necessary fittings and fixtures complete all as specified and directed.

Demolition of cement concrete as in bed to drain pipe including packing under and haunching against the sides of pipe or as in manhole benching/bed etc complete all as specified and directed.

M&L concrete bed to drain pipes including packing under and haunching against the sides of pipes after they are laid and tested in cement concrete 1:3:6 type C-2 for 200 mm bore pipes complete all as specified and directed.

Cutting into existing manholes for connecting new drains, making good to pipe and rendering cutting out existing benching for and forming branch channel (1/2 round or 3/4 section) in cement concrete 1:2:4 type B-1 smooth finished and forming benching as required. Internal dia of pipe 150mm complete all as specified and directed.

M&L cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in benching /coping and the like including weathering, slightly rounded or chamfered angles as directed including form work and finishing all exposed surfaces including necessary form work complete all as specified and directed.

Demolition of reinforced cement concrete (below or above ground level) complete all as specified and directed.

M&L Reinforced cement concrete type B-1, 1:2:4 using 20mm graded stone aggregate in slabs complete all as specified and directed.

S&F in repair Ready Made Precast reinforced cement concrete 1;2;4 type B1 using 20mm grade stone aggregate, factory made manhole covers of size 450x900x50mm thick, set in cement mortor 1;6 all as specified and directed.

M&L TMT steel bars 10mm dia and over in reinforcement, cut to length, bent to shape required including cranking, bending spirally or hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.9mm dia all as specified. complete all as specified and directed.

M&L TMT bars 5mm dia & over upto and over 10mm dia in stirrups spacers & binders etc all as specified and as directed.

M&L form work to soffits of suspended slabs, floor slab etc n. exc. 200mm thickness flat for rough finished surface of concrete complete all as specified and directed.

M&L precast cement concrete type B-1, 1:2:4 using 20mm graded stone aggregate as in manhole cover complete all as specified and as directed.

M&L hardcore of guage exc 63mm but n exc. 100 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rolled/rammed to a true surface complete all as specified and directed.

M&L for laying 75mm thick PCC 1:2:4 type B-O, (using 12.5mm graded crushed stone aggregates) as in floor to receive topping layer complete all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15cm thickness (below or above gound level) complete all as specified and directed.

M&L cement concrete 1:4:8 type D-2 (using 40mm crushed) graded stone aggregate in foundation filling and mass concrete complete all as specified and directed.

Cleaning of underground Horizontal sewage pipe of any dia upto 200mm (Cleaning length n.exc 30m from manhole to manhole or from manhole to septic tank) including taking off manhole cover and cleaning of manholes of any size and depth and removing waste material/sludge to a distance of n.exc 300m and burrying in a pit and replacing manhole cover in position after cleaning complete all as specified and directed.

Dewatering of Septic tank and soakage well, manhole of any depth in any position by pumping out and removing outside Military/Defence land by mechanical means (trolley mounted) and burying in pits all as directed including digging of pits in any type of soil and covering pits with earth after absorption of water and including providing and spreading required quantity of bleaching powder around the pit or dispose of waste material as per state protocol and washing the top of septic tank & soakage wells and surrounds with fresh water and sprinkling lime to make hygeinic complete all as specified and directed.

De-sludging of septic tank/Manhole of any capacity including connected intercepting chamber, manhole shaft, sludge chamber & filterbeds of any description and in anmy position by pumping out and removing of sludge outside Military/ Defence land by mechanical means (trolly mounted) and burying in pits all as directed including digging of pits in any type of soil and covering pits with earth after filling of sludge and including providing and spearding required qty of bleaching powder or dispose of waste material complete as per state protocol, including taking down of slab cover and placing the same in existing postion complete all as specified and directed.

S&F stack clamp out of 50mm by 5mm flat iron & 16mm dia round iron stays,including bolts and nuts and securing ends of stays to wall or roof for 110mm nominal bore pipe complete all as specified and directed.

All as per item No 34.00 above but of 75 mm nominal bore pipe complete all as specified and directed.

S&F 75mm bore PVC (SWR) bends of any radius, complete all as specified

S&F 110mm bore PVC (SWR) bends of any radius, complete all as specified

S&F PVC 110mm bore (SWR) branch piece, single (single Y) equal or unequal, complete all as specified

S&F CI access door cover for 75mm bore pipe incl all asseseries complete all as specified and directed by Engineer-in-Charge.

All as per item No 39.00 above but of 100mm bore pipe complete all as specified and directed.

M&L for construction of septic tanks, foundation in PCC 1:2:4, brick work in CM 1:4, RCC Slab covers including RCC precast manhole cover having 6mm plate embedded all around/fibre reinforced cover with angle iron frame Vent shaft and sludge chambers etc., for 100 users including necessary earth work in any type of soil (soft / loose / hard / dense) all as shown on drg No TD-217 sheet 1/7 to 7/7 complete all as specified and directed.

Sockage well exc in ordinary soil foundation in PCC 1:3:6 wells of honey cambed and solid in M-25 concrete including intercepting chamber screen chamber brick work in CM RCC cover slab in M-25 RR Masonary/filling with brick bats complete of size dia 2.4Mtr diaX4.5 mtr deep etc all as shown on Drg No TD-309 Sheet 1/4 to 4/4 complete all as specified and directed.

M&L brick work with sub class fly ash bricks straight or curved on plan exc 6 m mean radis built in CM 1:6 complete all as specified and directed.

M&L for applying 15 mm thick rendering using ready mix plaster bags in CM 1:4 on brick / concrete surfaces of external walls finished even and fiar, using water proofing compound @ 3% by weight of cement or as per manufacturer instructions, complete all as specified and directed : Note:- Water proofing compound shall be measured and paid sepratly Note : Contractor is required to deposit ready mix bags for 100% CA quantity to the Engr-in-Charge within 15 days of acceptance of contract

M&L preparation of new plastered surface of wall by applying 3mm thick wall care putty and making the surface smooth Finishing walls and applying Acrylic Smooth exterior paint of required shade (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm)using roller for painting complete all as specified & directed.

M&L cement concrete 1:4:8, type D2 (40mm crushed graded stone aggregate) as in 75mm thick sub base complete all as specified and directed.

M&L 60 mm thick interlocking tile (glossy finish) of laid, jointing and pointed in neat cement slurry, laid over dry sand cushioning and edges shall be secured with PCC 1:2:4 type B-0 using 12.5mm graded stone aggregate complete all as specified and as directed.

M&L for 16 mm to 18mm thick machine cut Granite stone slab BLACK or RED of any colour on vertical surface,skirting etc ,setand jointed in neat cement slurry and pointed in coloured cement to match including complete all as specified and directed.

M&L mild steel framed work as in doors or gates of angle or other section with gusset plates, rails, braces, ball bearing etc, complete, drilled for fixing of steel sheeting or other covering. Doors, etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings incl guard bars/hold fast etc ( exclusive of steel sheeting or other covering running rails and guides) and hanging also fastening and fixing complete Fe-290(Gde E-165) complete all as specified and directed.

M&L for mild steel framed work such as grills, gratings, etc. with ends of bars, shouldered and/or riveted, or forged into spikes, framed guard bars etc and similar work conforming to Fe-290 (Gde-E-165) complete all as specified and directed.

M&L flat form work to sides of concrete foundations, footing bases of columns, raft and raft beams, sides and soffits(if any) of foundation and plinth beams and similar work, veritical or to batter rough finished surface of concrete all as specified & all as directed.

M&L RCC M-25(20mm graded aggregate) for foundation including rafts, footings, foundation beams, plinth beams, bases for columns, etc, all as specified and directed.

M&L PCC 1:3:6 type C2 using 40mm graded stone aggregate as in foundation,filling, sub base/mass concrete levelling cource etc. complete all as specified and directed.

S&F in repair galvanised 2 strand, steel barbed wire 2.24 mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of stanadard rails straining bolts including securing or tying at crossings with and provision of galvanised mild steel wire staples or steel pins etc complete all as specified and directed.

M&L PCC 1:3:6, type C1 using 20mm graded stone aggregate as in bencing to drain, holdfast, padding to roof/chhajja, coping, bed block etc and the like edge slightly rounded or chamfered including necessary use and waste of form work complete all as specified and directed.

M & L applying two coats of synthetic enamel paint over a coat of red oxide primer including preparation of new or previously untreated steel surfaces of any description, over 10 cm in width or girth, not otherwise described complete all as specified and directed.

S&F concertina coil as in fencing with punched tape concertina coil upto 450 mm dia, 10 m openable length having 50 Nos rounds per 6 m length, upto 3.0 m height of wall with existing angle iron Y shaped placed 2.4 m to 3.5 m distance, stud tied with OJ staples and OJ clips to retain horizontally including necessary bolts or OJ barbed wire tied to angle iron,350 to 450 mm dia spirally round shape complete all as specified & directed.

M&L Ultra P E, DWC (Double wall corrugated) pipe confirmed IS-16098 Part-2 2013 pertaining structure wall plastics pinning system for sewage 100mm and above bore pipe SN8 and all necessary fittings and fixtures complete all as specified and directed.

M&L for construction of septic tanks, foundation in PCC 1:2:4, brick work in CM 1:4, RCC Slab covers including RCC precast manhole cover having 6mm plate embedded all around/fibre reinforced cover with angle iron frame Vent shaft and sludge chambers etc. for 200 users including necessary earth work in any type of soil (soft/loose/hard/dense) all as shown on drg No TD-217 sheet 1/7 to 7/7 complete all as specified and directed.

Soakage well exc in ordinary soil foundation in PCC 1:3:6 wells of honey cambed and solid in M-25 concrete including intercepting chamber screen chamber brick work in CM RCC cover slab in M-25 RR masonary/fitting with brick bats complete of size dia 3.6 mtr dia x 4.5 mtr deep etc complete all as specified and directed.

Shree Construction Co.