SPECIAL REPAIR TO COMMUNITY HALL AT KADAMBA VANAM AND PROVISION OF RECREATION ROOM AT GARRISON ENGINEER (SEA BIRD) INSTALLATION AT NAVAL BASE KARWAR.

Amount

Excavating in trenches, not exceeding 1.5 m wide and not exceeding 1.5m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. not exceeding 10 sqm on plan and not exc 1.5 m in depth and getting out in hard/dence soil complete all as specified and directed

Material and Labour for Plain Cement concrete 1:4:8 using 40mm graded stone aggregate in foundations, filling and mass-concrete complete all as specified and directed

Material and Labour for providing precast cement concrete block masonary with solid blocks exceeding 10cm width, type C-1, (1:3:6) using (20mm graded stone aggregate) and set in cement mortar (1:6) complete all as specified and directed.

Material and Labour for Reinforced cement concrete (nominal mix) (1:2:4) type B1 as in Slabs supported on walls,beams and columns in floors,roofs, landings, balconies,canopies, deck slabs and inshelves and the like complete all as specified and directed

Material and Labour for Reinforced cement concrete (nominal mix) (1:2:4) type B1 as in Beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and directed

Material and Labour for Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. complete all as specified and directed

Material and Labour for Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200m thick (Horizontal or sloping) complete all as specified and directed

Material and Labour for Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed

All as per item No 08 above but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders complete all as specified and directed

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm in hard and dense soil complete all as specified and directed

Removing excavated material not exceeding 50 m and depositing where directed at a level not exceeding 1.5 m above the starting point complete all as specified and directed

Material and labour, Sand filling under floors in layers not exceeding 15cm thick each, including spreading, leveling, watering and consolidation, complete all as specified and directed.

Material and labour for 100mm thick PCC (1:4:8) type D2, as in sub base of floor complete all as specified.

Material and labour for 40mm thick Cement concrete type B-1, 1:2:4 (20mm graded aggregate) as in floor complete all as specified and directed

Material and labour for 75mm thick PCC (1:3:6) type-C2 using 40 mm graded stone aggregate as in hardstanding/plinth protection and finishing the concrete surface even and smooth without using extra cement complete all as specified and directed.

Hardcore of broken stone/boulders of gauge exceeding 63 mm but not exceeding 100 mm, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface complete all as specified and directed

Material and Labour for rendering 15 mm thick in CM (1:4) on fair faces of concrete surfaces and finished even and smooth without using extra cement complete all as specified and directed

Material and Labour for 5mm thick rendering in CM 1:3 on concrete surfaces as in ceiling surfaces complete all as specified.

Material and Labour for 15 mm thick rendering in CM 1:6 on internal surface of wall finished fair and smooth complete all as specified and directed

Material and Labour for two coat of OBD on new surface of internal wall surfaces including Priming plastered and other surfaces with alkali resistant priming paint including preperaition of surface complete all as specified and directed

Material and Labour for three coats of white wash on ceiling surfaces including preparation of new surface complete all as specified and directed

Material and labour, preparing of newly plastered surfaces of wall and applying two coats of cement based paint over a coat of primer, complete all as specified and directed.

Supply and fix auminium anodized frame for doors, windows, ventilators with one or more rebates including joining cleat for fixing etc. complete all as specified and directed.

Supply and fix aluminium anodised door shutters, aluminium section weighing 0.55 kg/m including necessary joining cleats, glazing clips, rubber neoprene packing, handles 2 Nos in each door,hinges, anodised aluminum snap beading screws etc. complete all as specified and directed.

Supply and fix 12 mm thick partical board medium density,flat pressed, single layer type or three layer type with BWR type adhesive, fixed in Aluminium frame with rubber packing & aluminium beading complete all as specified.

Dismantling plain or corrugated steel sheeting,any gauge,thickness,in roof covering of any description all as specified and directed.

Dismantling of wall and ceiling boards (fibre, pulp, insulation) or insulation boards /slab /blankets of any description including cover fillets complete all as specified and directed.

Dismantling wrought or mild steel work of any description not otherwise provided for complete all as specified and directed.

Supply and fix roof trusses (framed), trussed, purlins, crane gantries, rails and fastening and heavy bracket framing (Beam,tee,angle,channel or flat section) including distance pieces,cleats etc complete all as specified.

supply and fix pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall fixing with self tapping screws as per manufacturers specification complete all as specified.

Supply & Fix Aluminum snap grid false ceiling of standard aluminum section such as wall angle of size 38mmx 25mmx 2.4mm weighing 0.36 kg/Rm main/cross ties of size 36.5mmx25mmx1.4mm weighing 0.24kg/Rm grid size n exc 610x610mm suspended with 6mm dia GI wire at inter wall n exc 600mm c/c for cross and main tees fixed to roof slab/roof truss fixed with suitable size GI flat 40x3mm size 60mm long and expansion hold fasteners 12.5mm dia 40mm long etc including perforated particle board 12mm thick sheet of size n exc 610x610mm fixed in ceiling with clips to snap grid complete all as specified.

Material and labour for old decorated plastered and unplastered surfaces of walls by brooming down or steel wire brushing,scrapping down smoke ssot,mould,moss and efflorecent salt trading oil and greasy spots,filling holes,crakes with cement base putty and applying two coatss of distember oil emulsion complete and cleaning the surface in all respect complete all specified and directed.

Material and labour for preparation of old painted steel surfaces of any description not otherwise described over 10cm width or girth and applying one coat of synthetic enamel paint complete all as specified.

Material and labour for preparation of new steel surfaces and applying two coat of synthetic enamel paint over a coat of red oxide primer complete all as specified.

Taking down cement plaster on brick or concrete surfaces of wall/ceiling and likes including racking out joints, hacking for keys scrubbing down with water etc any description including removal of rubbish outside MoD land, complete all as specified and directed. Note : The rate quoted by the Contractor is deemed to be included necessary scaffolding and form works.

Supply only integral water proofing compound.

Material and labour for preparation of old painted plastered surfaces of wall/ceilings od any description over 10cm width or girth incl cornices and applying one coat of exterior emulsion paint complete all as specified.

Material and labour for preparation of new plaster surface and applying two coat of oil bound distember over a coat of primer and wall care putty complete all as specified.

Material and labour for point wiring complete with 1.5 Sqmm two single core PVC insulated, unsheathed 1100volts A grade cable with stranded copper conductor FR grade conforming to IS-694 part II with ISI mark FR grade drawn through and including suitable size rigid non metalic PVC conduit concealed with all accessories, including suitable size sunkpresses steel or cast iron terminal box with 3mm thick plastic laminated sheet top cover fixed flush with wall surface by means of brass screw and sunk cup washers for mounting of switches, sockets, fan regulators etc including providing 1.5 Sqmm PVC insulated unsheathed solid copper conductor cable as earth wire connected to metallic bodies of luminaires/fan etc at one end and to common earth dolly at other end all as specified for fan/light point for following equiment complete all as specified.

All as per item No 39 mentioned here-in-before but for One socket outlet 3 pin 5 amps on same board complete all as specified.

All as per item No 39 mentioned here-in-before but for One socket outlet 5 amps on independent board complete all as specified.

Material and Labour for point wiring complete with 4.0 Sqmm single core PVC insulated, unsheathed 1100 volts grade cable with stranded copper conductor FR grade conforming to IS-694 part II with ISI mark FR grade drawn through and including suitable size in PVC conduit with all accessories on wall/ceiling/floors/roofs etc including providing 2.5 Sqmm PVC insulated sheathed multistranded copper conductor cable as earth wire connected to metallic bodies of luminaires etc at one end and to common earth dolly at other end for one 3 pin socket outlet, 15 Amps, independent board complete all as specified.

Supply and fixing LED lights fitting 1x 22W, 220V,AC decorative box type with driver, holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete all as specified.

Supply and fixing ceiling fans complete with blades, down rods, electronic regulator and accessories, 230 V, 1200 mm sweep. Min air delivery 210 CFM with service value 6.00 BEE. Five star rated with brushless direct current motor (BLDC) complete all as specified.

Supply and fix switch piano 5 amps one way flush type , all as specified and directed.

Supply and fix switch socket combination 2 in 1, 3 pin, 5 Amps flush type, ISI marked, complete all as specified and directed.

Supply and fix switch socket combination 3 pin 16 Amps, 5 in 1 flush type, ISI marked, complete all as specified and directed.

Supply and Fixing of Socket outlet 2 in 1, 3 pin, 5Amps at required locations on the walls as directed.

Supply and fixing 1100 volts grade heavy duty 10 sq mm cable PVC insulated aluminium conductor, served with inner sheathing of PVC tape and overall PVC sheathed in service connections suspended by insulating hangers not more than 1 metre apart including 4mm suspension wire, one twin core cable flat or circular complete all as specified and directed.

Supply and fixing sheet metal enclosure MCB DB SPN 4 ways double door type with suitable bus bar complete all as specified and directed.

Supply and fixing 240 volts, 10KA 'c' curve miniature circuit breaker (MCB) SP of 5 to 32 Amps current rating complete with connection testing and commissioning complete all as specified.

Supply and fixing 240 volts, 10KA 'c' curve miniature circuit breaker (MCB) SPN of 32 Amps current rating complete with connection testing and commissioning complete all as specified.

Supply and fixing fan regulator, step type, 230 volts compatible with the fan mentioned below all as specified and directed.

Supply and fix 12W LED downligt , Sleek, square recessed 1x1 mounting complete all as specified . Make :Bajaj Cat part No.BPSLR 12W WH PRO SQ or equivalent make in Havells/CG

Supply and fix exhaust fan, steel body AC single Phase. 230V of size 300m sweep with, blades, and frame and louvers complete all as specified.

Supply and Fixing of Ceiling rose, 3 phase,PVC or polycarbonate with isolated body at the locations required for fans or lights located on the ceiling 10 feet above the ground complete all as specified.

SHRI SHIVANAND S NAYAK

H S krishna Electricals

PEGASOS ENGINEER TRADERS

KVL CONSTRUCTION

Bidder Name

ABDUL RAHIM

KVL CONSTRUCTION

PEGASOS ENGINEER TRADERS

H S krishna Electricals

SHRI SHIVANAND S NAYAK