SITC OF LIFTAT 32,Belvedere Road,Kolkata-32

Amount

SITC of Automatic Lift ( as per manufacturer design & as per detailed specification below) and putting into operation after final testing in the existing lift shaft complete with all accessories and repairing the damage wall / floor if any etc to complete as reqd.

Make : Lift manufacturers approved under category-I & II (as per Memorandum of PWD/Govt. of W.B vide memo no. 75-W(C)/1M-20/15 dt. 03/03/2015)

Type: Passanger Lift .

Load : 4 Passenger / 272 Kg

Control: Microprocessor based closed loop system with AC variable voltage & variable frequency ( VVVF) Drive

Machine:- Energy efficient machine, Gearless, without Machine Room

Speed: 0.5Mtr./ Sec

Floor served: G + 1

Landing: 2, all on same side

Total Rise : 4.9 Mtr (Approx.)

Operation: Microprocessor based simplex full collective with or without attendant.

Signals: Digital car position indicator,car travels direction indicator in car & at all landing with call registration indicator. COP & LOP must have stainless steel face plate silver brushed with surface mounted button. Button : All buttons on car & landing shall be luminous, on/off switch for Lift, fan, light, toggle switch or key switch for automatic/attendent mode of operation. Display type :Colour LCD / Segmented LCD. Operation Push Button for lift maintenance & service should be on top of the car.

Leveling accuracy:± 5 mm(Micro levelling arrangement )

Car inside :1100mm ( W ) x 900mm ( D ) x 2200mm (H) or as per OEM standard.

Car Entrance:Clear Opening:- 800 mm (W) x 2000 mm (H ) protected with car door.

Car Finish/Car Enclosure:

a) Rear Panel ---- Stainless Steel sheet (20 SWG) with Hairline finish (#4)

b) Side Mid Panel--- Stainless Steel sheet (20 SWG) with Hairline finish (#4)

c) Side Mid Panel--- Stainless Steel sheet (20 SWG) with Hairline finish (#4).

d) Front Panel--- Full-vision toughened glass with MS frame or Stainless Steel sheet (20 SWG) with Hairline finish (#4) as approved by E.I.C

Car Ceiling & Lighting: Stainless Steel with Mirror/hairline finish with LED lighting and Fan

Car Ventilation: Cross flow Pressure fan with anodised aluminium grill.

Car Flooring : Decorative granite flooring (As per direcion of EIC and according to this Department's Order).

Car Door: Full-vision toughened glass or Stainless Steel Telescopic automatic door provided with V3F controlled door drive system with 2D infrared curtain of light and mechanical force limiting device,with fire rating of minimum 120 minutes.

Landing Door: Full-vision toughened glass or Stainless Steel Telescopic automatic door provided with V3F controlled door drive system , with fire rating of minimum 120 minutes.

Door Opening: Automatic power oprated Full-vision toughened glass or Stainless Steel Telescopic door with full length Photocell assembly light curtain sensor.

PROTECTIVE DEVICES & OTHER ACESSORIES

ARD: Automatic rescue device complete with dry maintenance free batteries as required.for automatic evacuation to the nearest floor in case of power failure / single phasing/others.

Overload Protection:Fully loaded with overload protection.On overloading the lift car will not start with door remaining open and give audio & display indication

Emergency lighting in car: Battery operated emergency lighting in the lift car.

Intercom system: Battery operated intercom system in Lift Car, Machine Room & Control Room

Emergency Alarm: Battery operated alarm bell system in lift car and control room

Fireman switch: Fireman switch placed at ground floor

Voice Synthesizer: Voice announcement system (Voice Synthesizer) in the car to announce the position of the elevator in the hoist way as the car passes or stops at a floor served by the elevator.

Main rope - As per manufacturer's standard conforming to respective applicable IS

DIMENSION OF SHAFT & POWER SUPPLY

Available Shaft Dimension: 1600 mm (W) X 1550 mm (D)

Available Pit Depth : 750 mm

Available Overhead : 6200 mm

Electric power supply: AC 240 Volt 1-phase, 50 Hz, terminated Inear lift machinery.

N.B. Rates should be quoted with minor civil works, wall & Hole cutting on channel and mending good the damages to the original finish.

UNITED ELEVATORS PRIVATE LIMITED (BID ID -5748824)

L.T. ELEVATOR LIMITED (BID ID -5761590)