PROVISION OF WALL CLADDING FOR TENNIS COURT AT NEW MANGALORE

S&F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to IS.1161-1979 grade St.-240 , complete all as specified and directed

S&F Fe 410W (Gde E-250) quality A for 6mm thick mild steel Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, with riveted,bolted or welded attachment to bottom of GI pipe complete all as specified and as directed conforming to Fe-410W complete all as specified and directed

M&L for two coats of synthetic enamel paint over a coat of red oxide primer on new steel surfaces of any description, not otherwise described over 10cm width or grith after preparation complete.

S&F pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specifie

S&F for 2 mm thick polycarbonate sheet of any colour or texture as in roof covering/cladding to wall fixed with and including necessary aluminium flat/fittings as specified.

S & F 150MM UPVC Gutter including Upvc Joints, Upvc Drop, Clamp, Bolt and all connected items fixed in rain water gutter/Valley all as specified & directed.

S&F 75 mm bore PVC (SWR) pipe type 'A' with single socket fixed to wall, with MA Brackets etc all as specified

Boulder pitching, laid dry, hand packed tightly complete all as specified and as directed.

M&L 100mm thick PCC 1:3:6 Mix type C2 as in plinth protection and in path surface to be finished without using extra cement complete all as specified and as directed.

Aluminium Composite Panel (ACP ) Cladding Specification: Providing & fixing of Aluminium composite panel of approved make and colour for wall cladding for straight Brick/Rcc/stone walls & columns/beams with necessary Aluminium frame works at required level made out of 50 x 25 x 3 mm C section equalent. The panel should consist of 3 mm thermoplastic core of antitoxic LDPE sandwiched between 0.5 skins thick Aluminium sheet making a total panel thickness of 4 mm. the surfaces will be finished with PVDF based coating on topsides and service coating on reverse sides would be in polyster paint. The system shall be fixed using GI brackets, Aluminium L cleats and stainless steel bolts and nuts complete with spring washer and cap nuts and all other necessary accessories, sealing shall be done using weather sealant of Dow Corning 789 with necessary rods etc., complete with all lead & lift, as per specifications and as per directions.