REPAIRS TO SECURITY WALL, CULVERT, PATHS, FENCING, BARBED WIRE AND CONCERTINA COIL, GLASS COPING ETC TO DMRL, ATC DEVATALGUTTA, RCM (MAT), DSC LINE ATC DEVATALGUTTA AND PCDA UNDER AGE B/R -II HYDERABAD

Amount

Demolition of brick work or stone/ boulder masonry, built in cement mortar including all quoins, pillars etc., as directed by the Engineer in Charge.

M&L for walling of rubble regular coursed, well bonded, bedded and solidly hearted built in CM 1:4

M&L for walling of rubble regular coursed, well bonded, bedded and solidly hearted built in CM 1:6

All as per srl item No. 3 above, but except stones

M&L for Brick work with sub class 'B' bricks, straight or curved on plan exceeding 6m mean radius built in cement mortar (1:4) including raising height of existing manholes complete all as specified and as directed.

Plain Cement Concrete Type B0 1:2:4 (using 12.5 mm graded stone aggregate) cast in situ in lintels up to 1.5 M span, cills and other similar bands, plinth courses, parapets, copings, bed plates, water troughs and the like including weathering, slightly rounded or chamfered angles and throating as directed including use and waste of form work.

Taking down cement plaster on brick or stone walls, etc., including raking out joints, hacking for key, scrubbing down with water, etc., including removal of rubbish off the premises, where directed and leaving the work clear of any plastering.

M & L for rendering 15mm thick in cement mortar (1:4) on fair faces of brick or concrete surfaces, finished even and smooth without using extra cement complete all as specified and as directed.

Raking out joints to square rubble mas, coursed or uncoursed and M & L for Raised pointing in CM 1:3

M&L broken glass coping 25mm thick in CM 1:3 on top of wall including demolition of old coping complete all as specified and as directed.

M & L for boulder pitching, laid dry, hand packed tightly and grouted with cement sand mortar 1:6

Preparing new plastered surfaces and applying Two coats of cement base paint over a coat of alkali resistant primer on surfaces of walls.

Preparing surfaces plastered or unplastered old surfaces of walls and applying one coats of cement base paint complete all as specified.

S&F mild steel work such as angle iron in posts & struts in fencing, Gate including cutting tops to shape hand rail straight portion , drilled and contersunk for balusters , nosing to steps, struts in fencing including cutting tops to shape as directed , drilling holes, notching for wire etc flat iron fillets ( for securing chain link fencing ) including all necessary drilling, bolting or riveting etc and similar work conforming to Fe-290 Gde E-165 including dismantling old steel work complete all as specified and directed.

S&F in repairs mild steel framed work such as grills, gratings etc with ends of bars shouldered and / or riveted or forged into spikes framed guard bars, ladders, framed balusters , walk ways, railing, framework or water tank and similar work conforming to Fe- 290 Gde E-165 all as specified

S & F Galvanized, 2 strand, steel barbed wire 2.24 mm dia., barbed with 2 mm dia., barbs at 75 mm spacing and straining and fixing to any type of standard rails straining bolts, including securing or tying at crossings with and provision of galvanized mild steel pins etc., including taking down the existing wire complete as directed.

S&F in repairs Razor edge concertina coil, 750mm dia, consisting of spirals with sharp edged tape of 0.5mm thick, crimped to 2.6mm dia high tensile steel wire duly galvanized as per IS 4454 with scrapper barb having 51 spirals with 125 chips (when stretched to a length of 6 metre, weight of each coil shall be 8 to 9 Kg approximately) and fixed to MS frame work 'Y' shaped and placed at 1.5m apart and tied with GI staples/clips to retain horizontal including provision of necessary bolts, nuts etc. complete all as specified and directed.

Preparation of new or previously untreated steel surfaces of any description, over 10 cm width or girth, not otherwise described and applying two coats of synthetic enamel paint (ordinary tint) over a coat of red oxide zinc chrome primer.

Preparation of old painted steel surfaces of any description over 10 cm width or girth, not otherwise described and applying one coats of synthetic enamel paint (ordinary tint) complete

Demolition of cement concrete (unreinforced ) in ground floors and pavings n. exc 15 cm thickness ( below or above ground level)

M&L for 75mm thick cement concrete type D-2, 1:4:8 (40mm graded aggregate) as in foundation, sub base for complete all as specified.

M&L 75mm thick cement concrete type B-2, 1:2:4 ( 40mm graded stone aggregate as in paths parking etc finished even and smooth without using extra cement complete

M&L 100mm thick cement concrete type B-2, 1:2:4 ( 40mm graded stone aggregate as in roads, hardstanding etc finished even and smooth without using extra cement complete

Ready made speed breakers colour in yellow, black reflectors PMMA amber colour HIP reflected (yellow, white) moulded in ABC alloy of size 350mm x 50mm x 4mm thickness, complete all as specfied and directed.

M&L for providing chequered cement concrete rubber moulded coloured tiles glossy factory made of hydraulic pressed finish of 25 mm thick and size not less than 300x300mm thick set and jointed in neat cement slurry in floors with grey cement and pigments and with 15mm thick screed bed or bedding layer in CM 1:6 including dismantling of old tiles and screed bed complete all as directed

M&L 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footpath, parks, lawn, drvie ways or light traffic parking etc of required strength, thickness & size / shape , made by table vibratory method using PU mould , laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern finishing sweeping extra sand complete all as specified and including dismantling old tiles any discription.

Renewing cement concrete chequered tiles / inter locking tiles including removing and cleaning old tiles, preparing bed and laying or setting, jointing and pointing new or old tiles, including replaced damage tiles & providing PCC (1:4:8) sub base where reqd complete all as specified and directed.

Excavating in post holes (or similar holes) each not exc 0.50 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers n.exc 25cm, watering, and removing surplus soil to a distance n.exc 50m and making good surface in soft/ loose soil.

M&L for dismantling of Chain link fencing of any thickness complete all as directed

S&F chain link fencing of any type n exc 3.0 kg per Sqm including line wires, any mesh, size and type of standards, rails, straining bolts, etc., including provision of binding wire.

M&L for welding of existing damage / broken hinges, handle, frame and any other parts of gate, rolling shutters, fencing and adding angle to posts etc to achieve smooth function complete all as specified

Removing Excavated soils exceeding 1.5 KM but not exceeding 5 KM and depositing where directed.

M & L plain Cement Concrete1:4:8 type D-2 (40mm graded aggregate) in foundation filling and mass concrete

Cleaning of drains by excavating of the filled earth. Vegetation and all foreign material average width 45 cm & avg depth 60cm and removing the excavated material to a distance exc. 50m and not exc. 250m complete all as directed.

M&L preparation of old surfaces of bricks, stone, concrete of any description over 10cm girth or width not otherwise described and applying one coat of synthetic enamel paint complete

S&F 2mm thick fibre glass reinforced translucent plain sheeting with two corrugations / 10 cm side lap fixed with shelf tapping screws and washer in roof, wall etc complete all as directed

M&L for preparation of old decorated surface of exterior wall by removing existing treatment and washing with water and applying two coats of exterior antifungal acrylic emulsion paint as per manufacturers instructions over a coat of exterior water based primer of same make all as specified and prescribed by manufacture of paint and as directed at site by Engineer-in-Charge.

Taking down carefully existing chain link fencing from post, refixing the post with PCC in base and refixing the same in existing position incluidng replace damage nut and bolts complete all as specified

M & L for 18 to 20 mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window cills, cooking platforms and like including pointing white cement (1:2) using marble dust with admixture of pigment to match the shade of granite including cutting grooves and nosing including 15mm thick screed bed in CM 1:4 complete all as specified and directed.

M&L for complete removal of existing treatment from surfaces of walls/ ceiling, washing with water and applying two coats of OBD paint as per manufacturers instructions over a coat of primer over one coats of putty 1.5mm thick layer to level the surface and finished smooth with emery paper No.180 followed by emery paper No.320 or 400 and wipe it clean complete all as specified and as directed by Eng-in-charge.

ZOOM ENTERPRISES (BID ID -3491668)

sri vishnu enterprises (BID ID -3488667)

Ravi Enterprises (BID ID -3498359)

MM PROJECTS (BID ID -3498517)

rahi consultant (BID ID -3498276)

PAVAN ENTERPRISES (BID ID -3489328)

M/s ANUSHA ENTERPRISES (BID ID -3489604)

SRI SAI ENTERPRISES (BID ID -3497985)

M/S K.SANJEEVA REDDY (BID ID -3497860)

Sai construction & services (BID ID -3489500)

M/S PAVANI ENTERPRISES (BID ID -3497901)

SUN LIGHT HOUSE (BID ID -3494603)

WELDECOR (BID ID -3489038)