Micro-Irrigation infrastructure on Canal Command outlet RD 8000-L Shadipur Disty from the outlet to Community Pond/On-farm hydrant.

Amount

works

NS Item -Providing and fixing of three phase 50Hz ±3% rated motor frequency, 415V ± 3% rated motor voltage, with constant motor flux control, (Submersible motors shall conform to all the requirements of IS 9283) Solar A.C. Agricultural Pumps alongwith Universal Solar Pump Controller (USPC) all external part of motor used in open well submersible pump having casing of Alloy steel confirming to IS 3444 including fixing PVC insulated polymer sheathed 3 core flat type cabling in conduit, required from solar plant to solar pump through control room required to connect, including cost of and as per IS code 14220-2018 including third party nspection.Average discharge 13 LPS / Head 52 meter / minimum / minimum output rating of 15 KW duly installed on the suitable foundation. Actual pump set`s parameters will be finalized after approval of design and drawing. Solar Pumping Sets should be of the make: KSB / Shakti/ Kirloskar /CRI/Lubi/ Crompton/ WPIL, (NS Item) @ Rs 11002.53/- per HP Quantities are total sum of varrious pumps capacity in HP may varry as per design requirement for site. (NS Item)

NS Item -Providing, laying, aligning, and jointing with butt fusion welding techniques (IS 7634 (Part 2) : 2012) at all level/ depths ISI marked PE pipe of PE-80 grade and PN as per design for portable water supply as per IS 4984-2016 (amended up to date) in trenches in complete, including cost of all PE Specials, labour, sectional hydro testing (including the cost and conveyance of water to site for testing) and commissioning as per Technical Specifications and approved make as per direction of Engineer. including cost of third party inspection (Make Duraline,Reliance, jain Irrigation, Nimbus, Finolex, Hasti, or equivalent) (NS Item) a) PE 80, PN 6, SDR 26, 180mm dia pipe

NS Item -Providing, laying, aligning, and jointing with butt fusion welding techniques (IS 7634 (Part 2) : 2012) at all level/ depths ISI marked PE pipe of PE-80 grade and PN as per design for portable water supply as per IS 4984-2016 (amended up to date) in trenches in complete, including cost of all PE Specials, labour, sectional hydro testing (including the cost and conveyance of water to site for testing) and commissioning as per Technical Specifications and approved make as per direction of Engineer. including cost of third party inspection (Make Duraline,Reliance, jain Irrigation, Nimbus, Finolex, Hasti, or equivalent) (NS Item) a) PE 80,PN6 SDR 17 , 140 MM Dia pipe

NS Item -Providing, laying, aligning, and jointing with butt fusion welding techniques (IS 7634 (Part 2) : 2012) at all level/ depths ISI marked PE pipe of PE-80 grade and PN as per design for portable water supply as per IS 4984-2016 (amended up to date) in trenches in complete, including cost of all PE Specials, labour, sectional hydro testing (including the cost and conveyance of water to site for testing) and commissioning as per Technical Specifications and approved make as per direction of Engineer. including cost of third party inspection (Make Duraline,Reliance, jain Irrigation, Nimbus, Finolex, Hasti, or equivalent) (NS Item) a) PE 80,PN6 SDR 17 , 200 MM Dia pipe

NS Item -Providing and fixing Tank Type (Make of Metal) Fertilizer and Chemical Injector System confirming to IS 14483 (Part 3) of 2018 for demonstration and guiding the farmers regarding fertilization and chemicalisation of system. (rates include ventury with manifold 1.0`=1300 and 60 liter fertilizer tank= 4400 ) rate approved by Worthy Administrator, MICADA, Haryana

NS Item - Excavating trenches of required width for pipes, cables, etc including excavation for sockets, and dressing of sides, ramming of bottoms, depth up to 1.5 m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20 cm in depth, including consolidating each deposited layer by ramming, watering, etc. and disposing of surplus excavated soil as directed, within a lead of 50 m: Pipes, cables etc. exceeding 80 mm dia. but not exceeding 300 mm dia for PE pipe line to be laid in field (HSR item No 4.16.1.2)

NS Item -Providing and lowering of PE PN-10 floater to float the submersible open well pump/motor (Non Scheduled Item)

NS Item -Galvanized steel chain link both end twisted fence fabric having opening size 7.5x7.5 cm and 3.15 mm dia wire, 2.2 meter height of mesh, with 2.8 meter ht of MS Angle 50x50x5 mm supports fixing at spacing of 3 meter centre to centre, supports with MS Flat 35x5 mm. Fencing supported with MS Angle 35x35x5 at top and bottom. The M.S Angle supports shall be anchored in cement concrete (1:3:6) blocks 45x45x60 cm additional razor barbed wire fencing shall be provided at the top of mesh, fencing including gate @ Rs 2000/- per meter (N.S.Item)

NS Item -Supply Installation testing commissioning of Solar Photovoltaic Stand alone Plant conforming to MNRE specifications as amended, consisting of Mono Crystalline silicon solar cells, necessary protections, earthing, mounted on Aluminum/GI structure of suitable strength. Including lightning and surge voltage protection, Fixing of Array junction box and Main junction box with IP 65 protection and termination arrangement for incoming and outgoing cable along with glands, lugs and other accessories etc. as required, built in metering system to moniter plant performance (Amp-meter, Volt-meter, Frequency meter, Energy meter, Watt-meter, and other instrument/equipment as required) Note:- PV modules used must qualify to the latest edition of IEC PV module qualification test or equivalent BIS standards Mono Crystalline Silicon Solar Cell Modules IEC 61215/IS14286. In addition, the modules must conform to IEC 61730 Part-1- requirements for construction and Part 2 – requirements for testing, for safety qualification or equivalent IS and be mounted on fixed Aluminum/GI structure of adequate strength and design as per IEC/IS specification. Including field-based electroluminescence (EL) study be performed after receiving the modules at site and after installation. Module mounting structure (MMS) design and drawing shall be duly vetted from government institute Including third party inspection Actual parameters/capacity will be finalized after approval of design and drawing. (N.S. Item)

NS Item -Providing, fixing,testing and commissioning of pressure gauge 2` dial with Glycerin filled (N.S. Item)

NS Item -Providing fixing of Header Assembly/Manifold 3` to connect the filtration unit (loose) (Rate app. By worthy Administrator)

NS Item -Supply and erection of alfa valve (Rate approved vide XEN, CAD Kurukshetra letter No.2082/5-A dt. 29.6.2018) (N.S. Item)

NS Item -Construction of control room/regulation cum watch and ward hut as per approved design and drawing including water supply, Sanitary fittings, electric fittings, septic tank and other items as required etc (Roof covered area 20` X 20.75`) As per approved design and drawing

NS Item -Complete operation and watch and ward of the project 1 plus 3 year including operation of pump house, pipe line and accessories, electromechanical solar plants complete in all respect.

NS Item -Complete Maintenance of pump house, pipe line and accessories, electromechanical and solar plant etc complete in all respect (36 months) @ 0.5% per year of total amount excluding earth work.

NS Item -Survey, planning, design, drawing and hydroanalysis of the complete piping system, pumping units and solar plant to check adequacy of the complete MI infrastructure and vetting it from the Government institute since estimated quantities are based on the tentative design parameters, including preparation of warabandi (calculation based on @ 1% of total cost of estimate)

NS Item -Preparation and implementation of warabandi of the complete chak and Identification of training needs of the farmers, preparation of training modules on various subjects concerning operation and maintenance of the MI systems, Solar array and pumping systems and cropping pattern etc., and providing necessary training to the farmers as per the identified needs. Necessary training shall be provided to the WUA members and the staff identified by the Engineer also for all activities involved in the O and M of the complete MI System including

NS Item -Supply and Installation of valve regulated solar batteries as per iS 16270:2014 (reaffirmed 2019) have autonomy time of 15 days.

Bidder Name

Amount

Naveen Dabas(GSTN-06AGIPN0843L1Z8)

Suresh Kumar Contractor(GSTN-NA)

Rakesh Yadav Contractor(GSTN-NA)

Suresh Kumar Contractor

Naveen Dabas

Suresh Kumar Contractor

Naveen Dabas