Loading
Loading…
Loading…
Eligibility, documents, scope, Go/No-Go checksEligibility, required documents, scope of work and Go/No-Go checks for this tender, in one click.
Tender Value
₹3.2 Cr
EMD Value
₹6.4 L
Closing Date
12 Nov 2026, 3:00 pm
Eligibility, documents, scope, Go/No-Go checksEligibility, required documents, scope of work and Go/No-Go checks for this tender, in one click.
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
SOUTH
14 conditions · 2 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N OR 'V' Whichever is less; where. V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per ANNEXURE-XXXIII, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender.
Defination of Similar Work :- Trenching,Cable laying,Location and /or signal foundation/erection/termination/wiring in connection with any signalling work
7 conditions
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Tender document, Scope of work & GCC 2022 are attached with the tender.
Signaling work in connection with different CTR/TTR works in South section of Mumbai Division.
CR-BB-SNT-SOUTH-2026-95~CR
CR-BB-SNT-SOUTH-2026-95
Open
Works - General
18 Months
Mumbai, Maharashtra
₹0
₹6.4 L
14 Oct 2026
14 Oct 2026
29 Oct 2026
28 items across 1 schedule · ₹2,60,05,379.32 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | Digital current clamp meter to measure current leaksparasitic draws down to 1 mA and electric load from 1mA to 100 Amp AC/DC, and voltages from 0 to 600 VAC/DC, small jaw size to measure current in signalingcircuits, 4 digit display. make FLUKE/ GTC/KOICO/Stanley or superior with better specification mentioned with allaccessories like test lead, batteries and carrying case,sample may got approved from consignee beforesupply.(Inspection Agency Cosignee) | Numbers 22.00 | — | 24,430.43 | 5,37,469.46 |
| 2 | HP Scanjet Enterprise Flow N9120 fn2 Document Scanner (For Signalling Circuit Scanning)(Inspection Agency Cosignee) | Numbers 2.00 | — | 2,63,291.04 | 5,26,582.08 |
| 3 | "Rubber Gloves for Electrical Purposes For use at working Voltage 1000V, AC rms, class 0, red in color, AZC/ RC category. Material description as per Annexure C. Material make is NOVAX or Raychem or Honeywell or Enespro or CATU. Material shall be procured from OEM or his authorized dealers with tender specific authorization only. (Inspection Agency Cosignee) | Pair 65.00 | — | 3,717 | 2,41,605 |
| 4 | "PT-E850TKW PC + KEYBOARD Printer, Display on Keyboard, Adaptor (Included) , TZE-Tapes supported(From 6MM to 36MM) + Tubes ( 2.5mm to 6.5mm ) + Half-Auto cut+ Li-Ion Battery (Optional) + Wi-Fi + 36 mm Black on white tape 1no + one ink Ribbon included + Barcoding + P-touch Editor Software + High Resolution Featuring Distributed Printing+ White PVC Tube 3.5mmx100mtr 5No- Make- Brother, Model- PT-E850TKW.- HSN Code- 84433290.(Inspection Agency Cosignee)" | Set 3.00 | — | 1,15,050 | 3,45,150 |
| 5 | Execution of S & T work related to Signalling/enginnering maintainance/block activities, in one job five unskilled manpower have to be provided for S&T work as per Railway site engineer instruction. (Inspection Agency Cosignee) | Job 1500.00 | — | 4,020.27 | 60,30,405 |
| 6 | Casting of cement concrete to protectS&T equipments and laid cables,above pipes, Signal store etc byconcrete mixture of cement, sand,stone in the ratio of 1:2:4 using 25mm graded stone aggregate as perinstruction of site in charge ofrailways. Concrete is to be castedwith the help of suitable sizeshuttering form as per siterequirement. Concrete is to be curedfor sufficient time as per standardpractices on railways(Inspection Agency Cosignee) | cum 40.00 | — | 4,761.25 | 1,90,450 |
| 7 | Tool bag for technician of S&T department as per specification and drawing attached as per Annexure-B(Inspection Agency Cosignee) | Numbers 1000.00 | — | 579.61 | 5,79,610 |
| 8 | High speed steel twist drill bit dia 7mm/13 mmsuitable forbattery operated drill machine make Eibenstok. Drill bitmake: MAKITA/BOSCH/FEINorOther reputedbrand(Inspection Agency Cosignee) | Numbers 500.00 | — | 396.9 | 1,98,450 |
| 9 | Deflector set for Digital axel counter ,each set consists of 2 delfector plateseach suitable for protecting TX and RXcoil(Inspection Agency Cosignee) | Numbers 909.00 | — | 3,894 | 35,39,646 |
| 10 | Repairing of location foundation with masonary work.This also includes cleaning the locations, sand filling inthe location and plastering inside the location.(Inspection Agency Cosignee) | Numbers 150.00 | — | 2,850.76 | 4,27,614 |
| 11 | Supply of Siemens AFTC S (11m-50nos, 16m- 100nos) , alpha(20 nos), equipotential bonds(30nos) as per site requirement (Inspection Agency Cosignee) | Numbers 200.00 | — | 19,610 | 39,22,000 |
| 12 | Water proof Point machine Cover fitting accessories and detection trolley instructing material as per annexure.(Inspection Agency Cosignee) | Set 149.00 | — | 2,832 | 4,21,968 |
| 13 | Supply of Modified fixing assembly for Frauscher makeMSDAC sensors to arrest excess vibratioas perdrawing No. (RST 12160) (Inspection Agency Cosignee) | Numbers 1600.00 | — | 1,289.25 | 20,62,800 |
| 14 | Rail core drill machine batteries as per attached technical specification/data sheet(Inspection Agency Cosignee) | Numbers 6.00 | — | 39,173.68 | 2,35,042.08 |
| 15 | Rechargeable Handheld Telecom TDR Cable Fault Locator(Inspection Agency Cosignee) | Numbers 3.00 | — | 93,322.9 | 2,79,968.7 |
| 16 | Set of nylon cable ties, One set consist 02 items 94000 nos. 1) Nylon cable tie size 100x2.5 mm Qty 88000 Nos. 2) Nylon cable tie size 150x3.6 mm Qty 6000 Nos. (Note Each type of nylon cable ties to be supplied in packets of 100n nos. only)(Inspection Agency Cosignee) | Set 5.00 | — | 12,680.28 | 63,401.4 |
| 17 | " BOPP BROWN TAPE FOR SIGNAL SEALING SIZE 96 mm width, 100 meters length,thickness 55 micron,Inner diameter of core 75 mm and Thickness of Adhesive Coating 25 Micron make BOPP,IC WINNER,ARO,SCOTCH,ADERE(Inspection Agency Cosignee)" | Numbers 4000.00 | — | 217.12 | 8,68,480 |
| 18 | Steel Stool with round top, 4 legs, foot rest and in ready to use form(Inspection Agency Cosignee) | Numbers 30.00 | — | 1,900 | 57,000 |
| 19 | Copper Lug 25 sqmm with double hole for AFTC track lead As per Drg. No. R Excise Duty - ST- 12090. Make - Braco,Dowells, Shakti, Fixwell or similar (Inspection Agency Cosignee) | Numbers 2000.00 | — | 80.24 | 1,60,480 |
| 20 | Copper Lug 25 sqmm with single hole for AFTC track lead As per Drg. No. R Excise Duty - ST- 12090. Make - Braco,Dowells, Shakti, Fixwell. (Inspection Agency Cosignee) | Numbers 2100.00 | — | 33.04 | 69,384 |
| 21 | Panel push button for Siemens 2019 signal panelwith contact making assembly of various colour Red,Grey, Blue, Yellow & Blue white dot etc complete (Inspection Agency Cosignee) | Numbers 1500.00 | — | 173.46 | 2,60,190 |
| 22 | Supply of DWC/HDPE pipe with one snap fit coupler 'O' ring confirming to IS 14930 (Part 2: 2001) Non metallic, normal duty, pliable with protection against chemical attack and fire resistant, anti rodent, in 6 meter length of size 50 mm inner dia.(Inspection Agency Cosignee) | Metre 690.00 | — | 389.76 | 2,68,934.4 |
| 23 | Siemens Electric Point Operating Machine, nontrailable, 143MM throw (immunity level 160V-IP 67) to operate on 110V DC , complete with lock and detector slides and cable terminal box , Siemens Make as per BSG-antr-9i. (Inspection Agency Cosignee) | Numbers 6.00 | — | 2,79,176.2 | 16,75,057.2 |
| 24 | Supply of 24-40V/10A DC-DC Converters suitable for M/s HBL make IPS systems and confirming to RDSO specification. RDSO/SPN/165/2012 Ver 3.0 or latest with RDSO specification make HBL(Inspection Agency RDSO) | Numbers 12.00 | — | 25,370 | 3,04,440 |
| 25 | Supply of DC-DC Convertor 24-40V DC/10A as per RDSO/SPN/165/2012(Ver3.0) or latest, including all accessories required for making a slot in the DCDP, holding Statcon IPS DC-DC convertor of lower rating, compatible for DC-DC Convertor 24-40V DC/10A working at rated Load. Make STATCON.(Inspection Agency- RDSO) | Numbers 25.00 | — | 21,830 | 5,45,750 |
| 26 | "Safety shoes of various sizes as perIS 15298(Part2):2011/ISO20345:2004 with followingfeatures.1) Steel toe cap confirmingto IS 5852 with minimum impactenergy of 200 Joules.2) Oil ,chemical& heat resistance ,antistatic, antisleep &electric hazard smooth uppermash fabric for cooling effect. 3)Double density directly injected .Some of reputed brand are Bata,Liberty, Action, Relaxo(Inspection Agency Cosignee) | Numbers 1000.00 | — | 1,330.45 | 13,30,450 |
| 27 | MAIN COVER ASSEMBLY complete - for TWS 220 MM POINT Machine comprising of Main cover, CRANK HANDLE HOLE SUB. ASSY, KEY HOLE LOCK SUB. ASSY, DOOR LOCK, RUBBER GASKATE of MAIN COVER ASSY, WIRING DIAGRAM PLATE, OIL INSTRUCTION LABEL, LOCKING PIECE B, RUBBER PACKING (KEY HOLE LOCK), RUBBER GASKET (C.H. HOLE LOCK ASSY.), CRANK HANDLE HOLE LOCK BASE, CRANK HANDLE HOLE LOCK LID, PIN (for C.H. HOLE LOCK S/A), RUBBER GASKET (.. HOLE LOCK ASSY, LOCKING. Modification in cover as per consignee requirement may required to be done. Paint Powder coated(Inspection Agency Cosignee) | Numbers 100.00 | — | 5,753.68 | 5,75,368 |
| 28 | Galvanization charges for main cover(Inspection Agency Cosignee) | Numbers 100.00 | — | 2,876.84 | 2,87,684 |
| Schedule total | ₹2,60,05,379.32 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
GCC_April-2022.pdf
ATTACHMENT
CORRECTIONSLIP1to11GCC2022_compressed.pdf GCC CORRECTION SLIP 1 TO 11
ATTACHMENT
FINALNEWTENDERDOC2026-95_1.pdf
ATTACHMENT
CORRECTIONSLIP1to11GCC2022_compressed.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .