UPGRADATION / RENOVATION OF ROOM NO. 116 TO 122, IN THE OLD BLOCK OF U.T. STATE GUEST HOUSE, SECTOR-6, CHANDIGARH.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level: 1:2:4 (1 cement :2 coarse sand (zone-Ill) derived from naturalsources:4gradedstoneaggregate20mmnominal size derived from natural sources)

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level. Cementmortar1:4(1cement:4coarsesand)

Providing edge moulding to 18 mm thick marble stone counters, Vanities etc., including machine polishing to edge to give high gloss finish etc. complete as per design approved by Engineer-in-Charge.Marble work

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in positionwith holdfast lugs or with dash fasteners of required dia & length (hold fast lugs or dash fastener shall be paid for separately).Second class teak wood

Providing and fixing 30mm thick ISI marked flush door shutters confirming to IS : 2202 (Part I) non decoretive type, core of block board construction with frame of 1st class hard wood and well matched commercial ply veneering with vertical grains or cross bands and 4 mm thick approved veneer of greenply or equivalent make shall be fixed by pressing on both faces of shutters by providing grooves at equal intervals on both faces of the door as per existing complete in all respect and to the entire satisfaction of Engineer-in-Charge. (Based on DSR No. 9.21.1) ( Fitting shall be paid extra).

12 mm cement plaster: 1:4 (1 cement : 4 fine sand)

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer -in - charge. Nominal concrete 1:4:8 or leaner mix (including equivalent design mix)

Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge. In cement mortar

Taking out doors, windows and clerestory window shutters (steel or wood) including stacking within 50 metres lead : Of area 3 sq. metres and below

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below: 1. The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos. 2. Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs. 3. On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again f ine wet rubbed smooth, which is further allowed to dry for 12 hrs. The f inal melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.)