32 Channel Direct RF Transceiver Unit

32 Channel Direct RF Transceiver Unit

Bidder Name :

COST BREAK UP

32 Channel Direct RF Transceiver(32 DRFT) - ESS Unit

Test Jig a) Workstation / PC with minimum RAM of 64 GB, i9 processor 14 Gen speed of more than 4GHz, Minimum 8 cores, SSD Hard disk minimum memory of 512GB, SATA Hard disk minimum memory of 2TB. - 1 No b) Gigabit Ethernet dual channel full duplex data capture NIC card, One Number of 40 Gigabit Ethernet dual channel full duplex data capture NIC card which shall be installed in the Workstation. -1 No. c) GUI application to run on Workstation to test 32 DRFT unit. Source code shall be delivered in CD/DVD.-1 No. d) Calibration Unit-1 No. e) Mechanical housing with SMP-SMA adapters and proper locking mechanism-1 No. f) All interface cables shown in Fig 3 of SOW including mating connectors-1 Set. g) AD9084 or equivalent board -1 No.

Test Cable Assemblies a) RF Input Cables (SMP-SMP) – 2m - 70 nos b) 32 DRFT unit Control Test Cable – 2m - 2 nos c) 32 DRFT unit Power Supply Test Cable – 2m - 2 nos d) 32 DRFT unit Debug Test Cable -2m - 2 nos e) 40G/1G Optical Signal Test Cable – 3m - 2 nos f) Power Divider 1:8 with all SMA(F) Ports - 3 nos g) Attenuator Pads (SMP Type): • 1 dB - 10 nos • 2 dB - 10 nos • 3 dB - 10 nos • 6 dB - 10 nos • 10 dB - 10 nos • 20 dB - 10 nos h) Adapters: SMP-SMA(F) - 70 nos i) 50 Ohm Terminations – SMP - 70 nos j) USB JTAG Cable for FPGA Programming - 4 nos

Documents, Reports, Software & Firmware a) Project Document b) Design Document c) Simulation and Analysis Report d) Acceptance Test Plan Documents e) Test Reports f) Manual g) Software, Firmware Design Files h) Design Files

NRE Charges

Total cost

Note 1 : Only Colored cells to be filled. Other cells not to be edited

Note 2 : The total cost of Cost break up should match with the total cost in BOQ1