DESIGN, SUPPLY, ERECTION, TESTING & COMMISSIONING OF HT- SUBSTATION HAVING METERING CUBICAL, TRANSFORMER, RMU,HT & LT CABLE, UPS & DG WITH ACCESSORIES FOR MEGA DAIRY AT TUMKUR MILK UNION, TUMKUR.

DESIGN, SUPPLY, ERECTION, TESTING & COMMISSIONING OF HT- SUBSTATION HAVING METERING CUBICAL, TRANSFORMER, RMU,HT & LT CABLE, UPS & DG WITH ACCESSORIES FOR MEGA DAIRY AT TUMKUR MILK UNION, TUMKUR.

Two/Four Pole Structure

Lightning Arrestors 3 Nos.

Metering Kiosk Panel (KEB Side)

Heat Shrinkable Type Termination Kit Outdoor Type

Heat Shrinkable Type Termination Kit Indoor Type

HT Panel 1 (VCB Panel)11 KV, 1250 AMPS,31.5 KA/ 1 SEC, 600

MVA, 4 VCB: suitable with 4 Nos. VCB

HT Panel 2 (VCB Panel)11 KV, 1250 AMPS,

VCB 600 AMPS suitable with 3 Nos. vacuum circuit breakers

3C x 300 sq. mm HT Cable Includes A) Overhead 11 kV line & metering kiosk KEB 2 runs; B) Metering kiosk (KEB) & overhead two-pole structure: 2 runs; C) Two-pole structure to incomer of HT Panel 1 2 ru...

3000 KVA , 50 C/S. Transformer

C/S. Bus Duct (Transformers to PCC Panel), Sandwiched Type LT, TPN, 5000 A rated, 1100 V grade, 50 C/S; suitable

GI Earthing Pits

Copper Earthing Pits

GI Earthing Strips for Grounding Connections

Copper Earthing Strips for Grounding Connections 40 mm x 6 mm

Caution Board for 11 kV

Caution Board for 440 Volts

Hand Gloves for 11/22 kV Operation

Electrical Operating Rod, Collapsible TypeAdequate length; 11 kV rating

Dry Chemical Powder Type Fire Extinguisher

Shock Treatment Chart, Duly Framed

PCC Panel Including Inbuilt APFC and AHF

WITH 20 MIN BATTERY BACKUP UPS for Powder Plant (Condensing) with Battery Backup

LT PDB (Distribution Panel)

1500 KVA DG Sets

1500 KVA - DG SET (EXISTING DG SET TO BE DISMANTLED,

SHIFTED, INSTALLED AT NEW LOCATION AND DO THE REQUIRED CONNECTION FULLY AS PER REQUIREMENTS AND STATUTORY NORMS)

Auto-synchronous-cum-AMF Panel for DG Sets 1500 kVA + 1500 kVA = 1 panel per set

LT Bus Duct (DG AMF/Auto Sync. Panel to PCC Panel), Sandwiched Type LT, TPN, 5000 A rated, 1100 V grade, 50 C/S; suitable

LT Power Cable 3.5C x 300 sq. mm

LT Power Cable 3.5C x 240 sq. mm

LT Power Cable 3.5C x 185 sq. mm

LT Power Cable 3.5C x 150 sq. mm

LT Power Cable 3.5C x 120 sq. mm

LT Control Cables

Instrument Cables

RUBBER MATS FOR ALL PANEL BOARDS ALONG WITH DIELECTRIC EPOXY FLOORING SMM THK (MINIMUM AREA OF PCC ROOM AND UPS ROOM TO BE CONSIDERED)

EARTHING FOR ALL HT AND LT PANELS AND ELECTRICAL SYSTEMS AND AUTOMATION SYSTEMS

GI Perforated Cable Trays Sizes as required by bidder: 150, 300, 450, 600, 750 and 1000 mm

SS WIRE MESH TYPE CABLE TRAYS (SIZES AS

REQUIRED BY BIDDER - 150MM, 300MM, 450MM,600MM, 750MM, 1000MM) (ONLY INSIDE PROCESS PLANT BUILDING)

CONDUITS OF VARIOUS SIZES AS REQUIRED BY BIDDER

CABLE GLANDS AS REQUIRED BY THE BIDDER (CONDUITS LENGTH AS PER CABLE LENGTH AS PER UNIT RATE)

External Electrification Complete Fabrication, Supply, Erection, Testing and Commissioning of External Lighting System -Polygon High Mast as per Specifications 20 m top; 150 mm top / 460 mm bottom di...

External Electrification Complete Fabrication, Supply, Erection, Testing and Commissioning of External Lighting System - Hot-dip Galvanized Conical Lighting Poles as per Specifications 6 m top; 75 mm...

External Electrification Complete Fabrication, Supply, Erection, Testing and Commissioning of External Lighting System - LED Light Fixtures for High Mast

External Electrification Complete Fabrication, Supply, Erection, Testing and Commissioning of External Lighting System - LED Light Fixtures for Lighting Pole (Solar Based)

External Electrification Complete Fabrication, Supply, Erection, Testing and Commissioning of External Lighting System - CU Cables for Street Light Fittings 4 sq. mm x 4C CU cable

External Electrification Complete Fabrication, Supply, Erection, Testing and Commissioning of External Lighting System - Cables for High Mast Light Fittings 16 sq. mm x 4C CU cable (OCR unclear)

External Lighting LT Distribution Panel

SS / MS / GI Structurals for Supports and Foundation Groutings

Air Conditioning Unit for UPS Rooms

Installation, Testing and Commissioning of Complete HT/LT Power System Including Required Statutory Approvals

CIVIL WORKS - Earth work excavation for Foundation by mechanical means for all works & depth upto 3 m, as per drawing and technical specifications, including setting out, shoring, strutting, barricadi...

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations and other similar works etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by r...

Supply and laying of brick protection for under ground cables laid in existing trench.

Sand Filling in Wells / Cable Trenches complete as per Drawing and Technical Specifications.

Providing and laying in position plain cement concrete for levelling course for all works in foundation. The granite/trap/basalt crushed graded coarse aggregates and fine aggregates as per relevant IS...

Providing and laying in position Reinforced/ Plain cement concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works & other parallel works from 0.50m t...

Providing and laying in position Reinforced cement concrete for all Foundation works. The granite/trap/basalt crushed graded coarse aggregates and fine aggregates as per relevant IS Codes machine mixe...

Providing and laying in position Reinforced cement concrete for all Super structures of building , Road works, Water works, Irrigation works & super structure works of bridges upto 3.50 m height. The ...

Providing and constructing load bearing wall with Solid Concrete blocks of size 400x200x200mm having block density more than 1800kg/m3 and minimum compressive strength of 4.00 N/mm2 conforming to IS 2...

Providing 15 mm cement plaster on the rough side of single or half brick wall of mix 1:4 (1 cement: 4 fine sand) including rounding off corners wherever required smooth rendering, providing and removi...

Providing 18 mm cement plaster in two coats under layer 12 mm thick cement plaster with cement mortar 1:5 (1 cement : 5 coarse sand) and a top layer 6 mm thick cement plaster with cement mortar 1:3 (1...

KSRB 2.8 Filling in foundation with granite / trap broken metal 100mm. and down size, with approved sand including hand packing, ramming, watering, including cost of all materials and labour with l...

Providing Thermo-Mechanically Treated bars of grade Fe-500D or more Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position, binding and anchoring to adjacen...

Providing chain link fencing 50mm size of 8 guage properly stretched between existing rectangular poles and fixed with suitable bolts & nuts, the free ends shall be welded to the pole and block pipe a...

Providing, Fabricating and fixing in position M.S. fabrication works using standard section like tubes, pipes, angles, channels, plates, bars etc as per details & drawings with necessary high tension ...

Finishing walls with 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required...

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade :Two coats on new or old work after thoroughly brooming the surface to remove all dirt, dust, mortar drops ...