REPAIR TO SEWAGE, DRAINAGE, FENCING, OFFRS MD ACCN AND CERTAIN OTHER AREA UNDER GE KAMPTEE

Amount

Demolition of unreinforced cement concrete in ground floor & pavings not exc 15cm thick (below or above ground level) complete all as specified and directed.

Dismantling of stone slabs and tiles of any description or thickness in floors, aprons etc. laid bedded and pointed in mortar complete all as specified and as directed.

M&L for crushed stone dust filling under floorings/ pavement spread and levelled in layers not exc 15cm thick complete including watering and consolidation complete all as specified and as directed.

M&L of machine pressed precast conctete interlocking paver block colour glossy finished rubber pressed any shape and size confirming to IS 15658-2006 of 40-60mm thickness M-35 Grade with Grey cement and pigment complete all as specified and as directed.

M&L for chequered/ plain (or any approved design) cement concrete tiles colour glossy finished rubber pressed set jointed and pointed in neat cement slurry and pointed in coloured pigment over 20mm cement screed bed in cement mortar 1:6 complete all as specified and directed.

M&L for Hardcore of gauge not exc. 63mm broken stone or boulders deposited, spread and levelled in layers not exc 15cm thick, watered and rammed to a true surface complete all as specified and directed.

M&L for plain cement concrete type D2 1:4:8 (using 40mm graded stone aggregate) as in sub bases/ pavings complete all as specified and directed.

M&L for cement concrete tybe B-1, 1:2:4 (using 20mm graded stone aggregate) as in floor finish concrete surface even and smooth without using extra cement complete all as specified and as directed.

M&L for PCC 1:2:4 type B1 (using 20mm graded stone aggregate) as in cills, steps, seismic and other similar bands, plinth courses, lacing courses parapets and railing upto 60cm height, copings, kneelers, bed plates, hold fasts block, filling on pressed steel door/ frame etc complete all as specified and as directed.

M&L for forming contraction (Dummy) joints 65mm deep x 10mm wide, filled with sealing compound Grade 'B' complite all as specified and as directed.

Demolition of brick work, built in cement mortar or cement lime mortar including all quoins, pillars etc. and disposal of unserviceable materials, debris and rubbish to a distance not exceeding 50m complete all as specified and directed.

Taking down cement plaster, any description on brick or stone walls including raking out joints hacking for key, scrubbing down with water etc complete all as specified and directed.

M&L for brick work with fly ash brick, old size, straight or curved on plan exc 6m mean radius built in CM 1:6 complete all as specified and as directed.

M&L for brick work with fly ash brick, straight or curved on plan to any radius built in half brick thick wall, built in cm 1:4 (Using old size brick) complete all as specified and directed.

M&L for PCC 1:3:6 type C1 (using 20mm graded stone aggregate) as in coping including weathering throating and necessary formwork complete all as specified and directed.

M&L for rendering 15mm thick on fair faces of brick work or concrete surfaces in CM 1:4 and finished even and smooth without using extra cement complete all as specified and directed.

M&L for rendering 15mm thick on fair faces of brickwork or on concrete surfaces in cement mortar (1:6) and finishing surfaces even & smooth without using extra cement complete all as specified and directed.

Demolition of reinforced cement concrete any description and in any position not otherwise specifically provided for and disposal of unserviceable materials, debris and rubbish off the premises complete all as specified and directed.

M&L for precast RCC 1:2:4 type B1 (using 20mm graded stone aggregate) as in landings, cover slabs for manholes etc and similar articles with plain faces set in cement mortar 1:4 complete all as specified and directed.

M&L for TMT bars 10mm dia and over, cut to length, bent to shape required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

M&L for RCC M-40 modular, weather proof, designer Precast Compound Wall, manufactured with Reinforced concrete using vibro compaction method, Post and Panel System, Precast Concrete Panel, Size: 2000 X 300 X 50-80 mm thick, Reinforcement: 3 No. – 8 mm ϕ bars tied with 8 mm stirrups @ 250 c/c, Finish: Stone / smooth, Concrete: M-40 Grade (GFRC), Precast Concrete Post (H Type), Size: 2500 X 140 X 140 mm, reinforcement: 4 No. – 8 mm ϕ bars tied with 8 mm stirrups @ 200 c/c, Concrete: M-40 Grade (GFRC) including necessary excavation for post holes and PCC 1:3:6 (using 20mm graded stone aggregate), painting as reuired colour etc complete all as specified and directed. Note:- Cost of reinforcement included in the rates given.

Excavating in post holes (or similar holes) each not exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, complete all as specified and as directed.

M&L for cement concrete type B-2, 1:2:4 (Using 40mm graded stone aggregate) as in foundation, filling and mass concrete complete all as specified and directed.

S&F mild steel work as in posts and struts in fencing including cutting tops to shape as directed, drilling holes for notching of wire, etc, flat iron fillets (for securing wire mesh etc) including all necessary drilling, bolting or riveting etc and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

S&F framed work as in doors or gates of angle/ tubular or other section with gusset plates, rails braces, etc. complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering running rails and guides) hanging; also fastening and fixing complete Fe 410 -W(Gde-E- 250) quality A complete all as specified and directed.

Dismantling fencing wire mesh, any type complete all as specified and as directed.

S&F Galvanised 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc complete all as specified and directed. Note:- Each line wire to be measured.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and as directed.

Supply only chain link MS galvanisd fencing, any size or type complete all as specified and as directed.

S&F MS screw bolts of dia 5-10 mm (machine made) with hexagonal or square at one end and screwed the other end or screwed both ends, length of bolt not exc 5cm long complete all as specified and directed.

S&F 10mm dia and over round bars in chain link fencing complete all as specified and directed.

M&L for preparation of new steel surfaces of any description over 10cm in width or grith and applying two coats of synthetic enamel paint over a coat of red oxide paint complete all as specified and as directed.

M&L for two coats of white wash on newly plastered surfaces on wall complete all as specified and as directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for and removing from site of work complete all as specified and directed.

Excavating in trenches, not exc 1.5 m wide and not exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. not exc 10 sqm on plan and not exc 1.5 m in depth and getting out in soft/loose soil complete all as specified and directed.

All as per item No 35 above but depth exceeding 1.5m and not exc 3.0 m depth complete all as specified and directed.

Excavation over areas not exc 1.50m deep and getting out in soft/loose soil complete all as specified and directed.

Excavation over areas exc. 1.5m depth and not exc 3m depth complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25cm in hard/ dense soil complete all as specified and directed.

Removing excavated material (soil) not exc 50m and deposited where directed at a level not exc 1.5m above the starting point complete all as specified and directed.

Cutting into existing manholes for connecting new drains, making good to pipe and rendering, cutting out existing benching for and forming branch channel (1/2 round or 3/4 section) in cement concrete 1:2:4 type B-1 smooth finished, and reforming benching as required for 200mm internal dia of pipe complete all as specified and directed.

Demolition and breaking up of 150mm dia drain pipes (salt glazed ware, AC or RCC Pipes) set in cement mortar complete all as specified and directed.

Demolition and breaking up of 200mm dia drain pipes (salt glazed ware, AC or RCC Pipes) set in cement mortar complete all as specified and directed.

Demolition and breaking up of 300mm dia drain pipes (salt glazed ware, AC or RCC Pipes) set in cement mortar complete all as specified and directed.

M&L for concrete bed in PCC 1:3:6 type C2 (using 40mm graded stone aggregated) to drain pipes including packing under and haunching against the sides of the pipes after laying & testing for any dia of pipes complete all as specified and directed.

M&L for 150mm dia SGSW (Grade 'A') drain pipes confirming to IS, laid in trenches and jointed in CM 1:2 complete all as specified and directed.

M&L for reinforced concrete pipes, class NP2, laid and jointed complete with collar for the 200mm internal dia of pipes complete all as specified and directed.

M&L for reinforced concrete pipes, class NP2, laid and jointed complete with collar for the 300mm internal dia of pipes complete all as specified and directed.

Demolition of cement concrete (unreinforced) of any description and in any position not otherwise specifically provided complete all as specified and directed.

M&L for cement concrete 1:4:8 type D-2 (using 40mm graded stone aggregate) as in foundation filling, mass concrete complete all as specified and directed.

M&L for providing cement concrete 1:2:4 type B-1 (using 20mm graded stone aggregate) as in coping benching, bed plates and the similar including, weathering, slightly rounded or chamfered edges and throating complete all as specified and directed.

M&L for PCC 1:3:6 type C2 (using 40mm graded stone aggregate) as in surface channels and drains complete all as specified and directed.

Demolition of reinforced cement concrete any description not exc 15 cm thick complete all as specified and directed.

Taking down of PVC, pipes of any size or pattern including all fittings etc complete all as specified and directed.

S&F in repair PVC (SWR) pipes 150mm dia, single socketed in any length with rubber ring joints fixed to walls complete all as specified and directed.

S&F in repair PVC (SWR) pipes 110mm dia, single socketed in any length with rubber ring joints, fixed to walls complete all as specified and directed.

S&F in repair PVC (SWR) pipes 75mm dia complete all as specified and directed.

S&F in repair PVC (SWR) bends with access door any radius, 110mm dia complete all as specified and directed.

S&F in repair PVC (SWR) bends with access door any radius, 75mm dia complete all as specified and directed.

S&F in repair PVC (SWR) branch piece, double (double Y) equal or unequal with access door, 110mm dia complete all as specified and directed.

S&F stack clamp made out of 50x5 mm flat iron for 75mm dia of pipe complete all as specified and directed.

S&F stack clamp made out of 50x5 mm flat iron for 100mm dia of pipe complete all as specified and directed.

S&F in repairs PVC (SWR) nahani trap 75mm dia with grating including jointing with solvent cement complete all as specified and directed.

Demolition of reed lathing, single or double including battens and plaster or chicken wire lathing, RCC jali complete all as specified and directed.

S&F precast cement concrete type B0 1:2:4 (using 12.5mm graded stone aggregate) louvers and jallies 35mm thick (measured solid) including all mouldings but excluding frame and fixed complete all as specified and directed.

NOTE:- SCHEDULE OF CREDIT (Amount shall be deducted offline from the total quoted amount to workout the net contract sum to be considered for acceptance.) [(-) Rs.24,162.50]

Shri Mohan Brother

Bidder Name

M/s Rahul Traders

Shri Mohan Brother