Construction of Additional room with Toilet at D-Type Quarter, Fort Area, Moti Daman. (E-30366) (2nd Call)

Items :

Excavation for foundation upto 1.5 m depth including sorting out and stacking of useful materials and disposing off the excavated stuff upto 50 Meter lead.(C) Hard Murrum.

Providing,supplying,stacking and spreading Crushed stone aggregate for Hard Quality 10mm,20mm and 40 mm size mixed in required proportion as directed including compaction, carriage and labour cost etc. complete.

Providing and laying cement concrete 1:3:6 (1-Cement : 3- coarse sand : 6- hand broken stone aggregates 40 mmnominal size) and curing complete excluding cost of formwork in (A) Foundation and Plinth.

Providing and laying controlled cement concrete M.250 and curing complete including the cost of formwork and excluding cost of reinforcement for reinforced concrete work in (A) All work upto floor two level.

Providing TMT Bar FE 500D reinforcement for R.C.C. work including bending, binding and placing in position complete upto floor two level (below/above Plinth)

Providing, laying and constructing Brick work using common brunt clay building conventional bricks having crushing strength not less than 35 kg./sq.cm. above plinth upto all floor level in cement mortar 1:5 (1 cement : 5 sand) in true line and level including curing, scaffolding, racking out the joints etc. complete as directed by engineer in charge.

Providing 15 mm thick cement plaster in single coat on Rough (Similar)side of single or half brick walls for interior plastering upto all floor level and finished even and smooth in (ii) Cement mortar 1:4 (1-cement :4-sand) and necessary curing, scaffolding, in true line and level etc. complete as directed by Engineer in Charge.

20mm thick sand faced cement plaster on walls upto height 10 metres above ground level consisting of 12mm thick backing coat of C.M. 1:3 (1-cement : 3-sand) and 8mm thick finishing coat of C.M. 1:1 (1-cement : 1-sand) etc. complete.

Providing and laying Vitrified tiles 8 to 10 mm thick , 36'' x 36'' in flooring, skirting, treads of steps and landing laid on a bed of 12mm thick cement mortar 1:3 (1-cement : 3-coarse sand ) finishing with flush pointing in white cement and groove filling.

Providing Material, Labour and equipments for Providing and laying integral cement based water proofing treatment including preparation of surface as required for treatment of roofs, balconies, terraces etc consisting of following operations: a) Applying a slurry coat of neat cement using 2.75 kg/sqm of cement admixed with water proofing compound conforming to IS. 2645 and approved by Engineer-in-charge over the RCC slab including adjoining walls upto 300 mm height including cleaning the surface before treatment. b) Laying brick bats with mortar using broken bricks/brick bats 25 mm to 115 mm size with 50% of cement mortar 1:5 (1 cement : 5 coarse sand) admixed with water proofing compound conforming to IS : 2645 and approved by Engineer-in-charge over 20 mm thick layer of cement mortar of mix 1:5 (1 cement :5 coarse sand ) admixed with water proofing compound conforming to IS : 2645 and approved by Engineer-in-charge to required slope and treating similarly the adjoining walls upto 300 mm height including rounding of junctions of walls and slabs. c) After two days of proper curing applying a second coat of cement slurry using 2.75 kg/ sqm of cement admixed with water proofing compound conforming to IS : 2645 and approved by Engineer-in-charge. d) Finishing the surface with 20 mm thickjointless cement mortar of mix 1:4 (1 cement :4 coarse sand) admixed with water proofing compound conforming to IS : 2645 and approved by Engineer-in-charge including laying glass fibre cloth of approved quality in top layer of plaster and finally finishing the surface with trowel with neat cement slurry and making pattern of 300x300 mm square 3 mm deep. e) The whole terrace so finished shall be flooded with water for a minimum period of two weeks for curing and for final test. All above operations to be done in order and as directed and specified by the Engineer-in-Charge : including Khurra & Gola work With average thickness of 120 mm and minimum thickness at khurra as 65 mm, etc complete as directed by engineer-incharge.

Providing and fixing 18 mm thick gang saw cut, mirror polished, premoulded and prepolished, machine cut granite (Z-Black) work for kitchen platforms, vanity counters, window sills, facias and similar locations, of required size, approved shade, colour and texture laid over 20 mm thick base cement mortar 1:4 (1 cement : 4 coarse sand), joints treated with white cement, mixed with matching pigment, epoxy touch ups, including rubbing, curing, moulding and polishing to edges to give high gloss finish, chamfer work etc. complete at all levels. Granite of any colour and shade, etc complete as directed by engineer-incharge.

Providing and fixing window having extruded aluminum Colour anodized section frame main outer size 95mm x 24mm x 1.17mm (of Jindal Section no:2459 @ wt.of 0.738 Kg/mt), horizontal Three track member size 92mm x 31.75mm x 1.30mm (of Jindal Section no:8688,@ Wt.1.07 Kg/mt), vertical member of size 92mm x 31.75mm x 1.50mm (of Jindal Section no:8933,@ Wt. 1.06 Kg/mt) with sliding shutters of horizontal member size 40 mmx18mm x1.29mm (of Jindal Section no:8947@ wt.of 0.456 Kg/mt), vertical member of size 40mm x 18mm x 1.29 mm (of Jindal Section no:8949 @ wt.of 0.456Kg/mt/ with 5 mm thick transparent bronze colour tinted float glass with powder coated aluminum fittings and fixtures and transparent silicon sealant glass fixing to frame as per details etc .

Providing and fixing concealed center point to wall ceiling & floor CPVC (SDR 13.5) PIPE having National Sanitation Foundation (NSF) seal for potable water of following dia. nominal bore tube fittings and clamps including making good the wall, ceiling and floor etc. complete.

Providing and fixing to wall ceiling and floor 10.0 Kg. F/Cm2 PVC pipes of make PRINCE/SUPREME/ASTRAL/FINOLEX or equivalentas approved by Engineer in-Charge & working pressure poluthene pipes of the following outside Dia. Low densidy, complete with special falnge compression type fittings, wall clipsetc. including making good the wall ceiling and floor. 110 mm Dia.

Providing and fixing wall hung W.C pan of jaguar or equivalent with complete unit of flush tank, seat cover brackt etc. complete as directed by Engineer in charge. (M.R.). (Make Hindware, Cera, Jaquar).

Providing and fixing wash basin Cera,Hindware,Somany (550x400 mm ) counterfit , including 40 mm dia C.P. brass waste, 40 mm dia waste pipe, 15mm dia flexible pipe and rubber plugs etc. complete as directed.

Providing and fixing wall mixture cock 3 in1 of jaquar or its equivalent make as directed by engine-in-charge.

Providing and fixing shower 200x200 with 400 mm long shower stand of jaquar or its equivalent make as directed by engine-in-charge.

Providing and fixing bib cock 2 in 1 of jaquar or its equivalent make as directed by engine-in-charge.

Providing and fixing angle cock of jaquar or its equivalent make as directed by engine-in-charge.

Providing and fixing pillar cock long body of jaquar or its equivalent make as directed by engine-in-charge.

Providing and fixing hand faucet 1.5 mt of jaquar or its equivalent make as directed by engine-in-charge.

Providing and fixing cast iron (Spun) Nahni trap of the following nominal diameter of self cleaning design with C.I. screaed down or higned grating including cost of cutting and making good the walls and floor 100mm inlet and 50mm outlet.(C) 100mm dia.

Provoding and fixing flush door shutters, solid core construction with frame of first class hardwood with cross board and face veneer or plywood face panels, including anodised alluminium butt hinges with necessary screws. (B) decorative type and block board core anodised alluminium butt hinges in flush door shutters (2) 35 mm thick.

Providing and fixing FRP of 28mm thick Fibre Glass shutter with 1.5 to 2.0 mm thick fire retardent grade FRP skin in depressed panel design having extra reinforcement on sides & edges & in Gel coat finish. The core of the shutter is to be filled up with injected retardent grade polyurethane foam done in situ alongwith embedded wooden pieces for stiffening & also taking hinges & fintures. The whole FRP frame & shutter is to be water proof ,weather proof, termite proof & resistance to mild acid/alkali. Rates are to be inclusive of S.S hinges with necessary screws & alluminium S.S fixtures & fastenings & fastener sleeve.

Applying two coats of Birla (white cement based) or Asian (acrylic lapy- putty) or equivalent & two coats of primer of approved brand and manufacture on new wall surface to give an even shade including thoroughly brushing the surface free from mortar dropping and other foreign matter and sand papered smooth.

Wall painting (two coats) with plastic emulsion paint of approved brand and manufacture on undecorated wall surface to give an even shade including throughly brushing the surface free from mortar droppings and other foreign matter and sand papered smooth.

Finishing wall with weather proof exterior emulsion paint of Asian Apex or equivalent on wall surface (two coats) to give an required shape even shade after thoroughly brushing the surface to remove all dirt, and remains of loose powdered materials etc. complete as directed.

Demolition of Brick work and stone masonry including stacking of serviceable materilas and disposal of unserviceable materials with all lead and lift.(ii) In Cement Mortar.

Providing erecting and fixing double coated ISI water tank of required capacity each with all necessary fittings and connection etc. complete on terrace.

Providing and fixing Toilet accessories like towel stand, shampoo holder, soap holder etc. as required and make as directed by engineer-in-charge.

Demolition including stacking of serviceable materilas and disposal of unserviceable materials with all lead and lift. (i) R.C.C. work.

Constructing brick masonry chamber for underground C.I. Inspection chamber and bends with bricks having crushing strength not less than 35Kg/Cm2 in C.M. 1:5 C.I. cover with frame (Light duty) 455mm x 610mm intenal dimensions total weight of cover with frame to be not less than 38Kg. (Wt. of cover 23 Kg.) and Wt. of frame 15Kg. ) (R.C.C. top slabe with 1:2:4 mix (1-cement :2- coarse sand :4-graded stone aggregate 20mm size) foundation concrete 1:5:10 inside plaster 15mm thick with cement mortar 1:3 finished smooth with a floating coat of neat cement on walls and bed concrete etc. complete.(i) Inside dimensions 455mmx 610mm and 450mm deep for single pipe line.

SHIRISH RAMANLAL SHARMA (BID ID -8260)

SHIV CONSTRUCTION (BID ID -8263)

AMIN M HASNANI (BID ID -8264)