KMC/DR/PBPS/E/15/2025- 2026

TOTAL

Item Rate BoQ

BoQ_Ver3.0

Name of the Bidder/ Bidding Firm / Company :

PRICE SCHEDULE (This BOQ template must not be modified/replaced by the bidder and the same should be uploaded after filling the relevent columns, else the bidder is liable to be rejected for this tender. Bidders are allowed to enter the Bidder Name and Values only )

NUMBER #

The LT & HT Cable end connection of the said motor to be disconnected for dismantling the existing motor from its pump.

Supplying Fitting , fixing 6 nos. New carbon brushes with new Spring & washer.Slip ring to be skimmed & polished. Damaged carbon holder & eroded carbon brush to be replaced as per direction of Engineer-in-charge.

Supplying of 3 core 6.6KV, 400 sq.mm size HT armoured XLPE insulated aluminium cable

Supplying and making indoor belted PILC cable end termination with heat shrinkable jointing kit complete with all accessories of HT 6.6KV, 3 core , 120 sq. mm

Manufacturing, supplying and making LT metalic terminal box of desired size and dimension.

All rings are force fitted under pressure . All Studs are perfectly aligned and fitted.

Complete dismantling the slip ring unit including Carbon holder , carbon, slipring holding Attachment as per direction of engineer-in-charge.

Taking out slipring from the machine after cutting And final finishing(correction of escentricity Polishing etc.)

Following tests to be carried out of the repaired Slip-ring : I.R measurement with 1000 v megger - value should be Above 5 Mega Ohm. H.T test at 2.5 KV - leakage current should be less Than 1 MA.

Painting with one coat Zinc Chromate priming, 1st coat of synthetic enamel paint over primer, 2nd coat of synthetic paint over the 1st coat of motor body.

Finishing the end of 120 sq mm HT- PILC cables by crimping Method including Supplying and fixing dowels solder less socket, Tapes and jointing materials.

High pressure test to be done at site in presence of Engineer-in -charge and test result to be submitted in due time.

Commissioning of the said motor with the pump after reconnection of the cable inside the end box and performing No-Load Test for at least four hrs. duration as per specification & direction of the EIC.

Complete dismantling the slip ring unit including Carbon holder , carbon, slipring holding Attachment as per direction of engineer-in-charge.

Finishing the end of 400 sq mm LT cables by crimping Method including Supplying and fixing dowels solder less socket, Tapes and jointing materials as per direction of EIC.

Please Enable Macros to View BoQ information