Madhupur Auhati road

Amount

BRIDGE PROPER :Labour for dismanteling all members of the timber bridge (except piles) and stacking them at sutiable places as directed( all members will be under custody of the contractor till taken over by th department.)scarfing and joining piles 25 cm to 30 cm dia Dressed to heartwood 90 cm. In length includng supplying, fitting and fixing with 2 nos. of 50 mmX 10 mm MS FI clamps and 16 mm dia MS bolts and nuts etc. complete as directed

Labour for taking out old piles of the bidge and stacking them at suitable place as directed

Excavation for Structures: Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material. i. Ordinary soil: Mannual Means ( With out dewatering): Depth upto 3m

Bored cast-in-situ M35 grade R.C.C. pile excluding reinforcement complete as per drawing and technical specification and removal of excavated earth with all lifts and lead upto 1000m.'With plasticiser (Masterplast PL-1/SPL-2 or equivalent), air entraining and water reducing plasticiser ( asterplast PAE or equivalent) and accelerating plasticiser (Masterplast ACPL or equivalent) conforming to IS-9103-1999)(Pile diameter-1000mm)

Pile load test on single vertical pile in accordance with I.S. 2911 (Part IV)as per technical specifications of MORTH section no 1100 a) Initial and routine load test

Levelling course for Pile cap Providing and lying of PCC M - 15 levelling course below the pile cap. as per drawing and technical specifications 0f MORTH section

Cement concrete for reinforcement concrete in pile cap complete as per drawing and technical specifications A. RCC grade M - 25 (i ) Using concrete mixer

Reinforcement in Foundation: Supplying, fitting and placing TMT IS:1786 Fe500 D bar reinforcement in foundation complete as per drawing and technical specifications a. TMT-IS 1786 ( Fe-500 D) Primary Producer (TATA/ SAIL/ Esser Steel/ Jindal panther steel/ Shyam steel or equivalent)

Plain/Reinforced cement concrete in sub-structure complete as per drawing and technical specifications and steel shuttering formwork as per MoRTH specification A. RCC Grade M30: Height upto 5m : Case I Using concrete Mixer

Supplying, fitting and placing a. TMT IS:1786 Fe500 D bar reinforcement in substructure complete as per drawing and technical specifications a. TMT-IS 1786 ( Fe-500 D) Primary Producer (TATA/ SAIL/ Esser Steel/ Jindal panther steel/ Shyam steel or equivalent)

Supplying, fitting and fixing in position true to line and level cast steel rocker bearing conforming to IRC: 83(Pt.-1) section IX and clause 2003 of MoRTH specifications complete including all accessories as per drawing and Technical Specifications.

Supplying, fitting and fixing in position true to line and level forged steel roller bearing conforming to IRC: 83(Pt.-1) section IX and clause 2003 of MoRTH specifications complete including all accessories as per drawing and Technical Specifications.

Structural steel Built UP Girder ( BUG) : providing and launching Steel Truss of structural steel BUG super structure including painting complete as per drawing and technical specifications

Furnishing and placing Reinforced/Prestressed cement concrete in super-structure as per drawing and technical specifications including steel shuttering formwork. i. without plasticiser (A)RCC/PSC Grade M 35 CASE-(I), Using Concrete mixer (i) For T -Beam and slab, (a) Height from 5.0m to 10m

Supplying, fitting and placing a. TMT IS:1786 Fe500 D bar reinforcement in superstructure complete as per drawing and technical specifications a. TMT-IS 1786 ( Fe-500 D) Primary Producer (TATA/ SAIL/ Esser Steel/ Jindal panther steel/ Shyam steel or equivalent)

Providing and laying Cement concrete wearing coat M-30 grade including reinforcement complete as per drawing and Technical Specifications

Providing ,fitting and fixing mild steel railing complete as per drawing and Technical specification

Drainage Spouts complete as per drawing and Technical specification.

Strip Seal Expansion Joint (Providing and laying of a strip seal expansion joint catering to maximum horizontal movement upto 70 mm, complete as per approved drawings and standard specifications to be installed by the manufacturer/supplier or their authorised representative ensuring compliance to the manufacturer's instruction for installation).

Carrying out Sub Soil Investigation ( SSI), for all types of soil (except boring in rock) upto a depth of 30m or refusal ( N=100) for each foundation location as per IRC : 78-2014 and submission of SSI report to the Engineer in -Charge for approval. Preparation & submission of Design calculation & Drawings of foundations, Sub Structures, Super Structures as per relevant IRC codes and SSI report , 2 ( two) copies each of Design & Drawings of each Bridge to be submitted for approval and 8 (eight) copies after approval of competent authority.

Protection work : ' Boulder apron laid in wire crates (Providing and laying of boulder apron laid in wire crates made with 4mm dia GI wire conforming to IS: 280 & IS:4826 in 100mm x 100mm mesh (weaved diagonally) including 10% extra for laps and joints laid with stone boulders weighting not less than 40Kg each.)

Providing and laying Pitching on slopes laid over prepared filter media including boulder apron laid dry in front of toe of embankment complete as per drawing and Technical specifications as per drawing and Technical specification. i. Stone/Boulder

Providing and laying Filter material underneath pitching in slopes complete as per drawing and Technical specification as per drawing and Technical specification .

ROADS WOTRK :'Clearing and Grubbing Road Land .(Clearing and grubbing road land including uprooting rank vegetation, grass, bushes, shrubs, saplings and trees girth up to 300 mm, removal of stumps of trees cut earlier and disposal of unserviceable materials and stacking of serviceable materials to beused or auctioned up to lead of 1000metres including removal and disposal of top organic soil not exceeding 150mm thickness. By Manual Means: i-In area of light jungle

Embankment Construction with Material Obtained from Borrow Pits(Construction of Embankment with approved materials obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300.1 and 300.2 ( including compensation of earth)(Including cost of testing of materials at site and laboratory as directed by the deptt. as per technical specification (A) From private land

Construction of Sub grade and Earthen Shoulders (Construction of Sub grade and Earthen Shoulders with approved materials obtained from borrow pits, with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300.2 ( including compensation of earth)(Including cost of testing of materials at site and laboratory as directed by the deptt. as per technical specification i. From private land

Granular Sub-Base with Coarse Graded Material ( Table:- 400- 2):( Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401 ( including all lead , transporting to site) Material as per technical specification 401: (I) for grading- II Material

Water Bound Macadam: (Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with vibratory roller 8-10 tonnes in stages to proper grade and camber, applying and brooming requisite type of screening/ binding Materials to fill up the interstices of coarse aggregate, watering and compacting to the required density. ( including all lead , transporting to site ) as per technical specification 405.(A) By Manual Means: (II) Grading- II. (a) Using stone Screening type –A (13.2 mm Agg.)

Water Bound Macadam: (Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with vibratory roller 8-10 tonnes static roller in stages to proper grade and camber, applying and brooming requisite type of screening/ binding Materials to fill up the interstices of coarse aggregate, watering and compacting to the required density. ( including all lead , transporting to site ) as per technical specification clause no. 405.(B) By Manual Means: (III) Grading-III. (b) Using stone Screening type –B (11.2 mm Agg.)

Prime coat : Providing and applying primer coat with bitumen emulsion on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 1.00 kg/sqm)(Including cost of testing of materials at site and laboratory as directed by the deptt)using mechanical means ( a) 'With bitumen emulsion-CSS-1h

Tack coat :Providing and applying tack coat with Bitumen emulsion using emulsion pressure distributor at the rate of 0.2 to 0.25 kg per sqm on the prepared dry bituminous/granular surface cleaned with mechanical broom ( Including cost of testing of materials at site and laboratory as directed by the deptt)(I)'With bitumen emulsion-CSS-1h( Dry & hungry bituminous surface)

Open - Graded Premix Surfacing: Providing, laying and rolling of open - graded premix surfacing of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or cut-back or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a smooth wheeled roller 8-10 tonne capacity, finished to required level and grades.) (including carriage up to site from quarry and carriage of mixed materials upto site from mixing plant.) ( Including cost of testing materials at site and laboratory as directed by the deptt) (a) without anti stripping agent Case-I : Open-Graded Premix Surfacing using cold mix Binder( as per IRC:SP:100:2014cationic Bitumen Emulsion CMS)

Seal Coat: (Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using either Type-A or Type-B seal coats. (including carriage up to site from quarry ) (Including cost of testing of materials at site and laboratory as directed by the deptt.). as per technical specification. Without antistripping agent Case-I :Type A (Providing and laying liquid seal coat comprising of a layer of bituminous binder ( paving bitumen 60/70 or VG-30 grade, followed by a cover of crushed stone chipping of specified grade.

Retro reflectorised Traffic sign: Providing and erecting of Retro-Reflectrorised cautionary, mandatory & informatory sign as per IRC: 67 made of high intensity encapsulated lens type reflective sheeting vide clause 801.3, fixed over aluminium sheeting, 2 mm thick fixed on an angle iron of 25x25x4mm supported on a mild steel angle iron post 75mm x 75mm x 6mm firmly fixed to the ground by means of properly design foundation with M-15 grade Cement concrete 45cm x 45cm x 60cm, 60cm below ground level as per approved drawing and sign. ( All the Steel work must be Tata/Sail/or any other approved brand (a) 60cm equilateral triangle

Supplying, fitting and fixing RCC guard post size 30cm dia 150cm long, 75cm above ground and 75cm below ground, with 6-12m Tor steel main steel and 6mm TMT stirrups at 30cm c/c/ tied in position with annealed black wire, cement concrete proportion 1:2:4 with broken stone aggregate up to 20mm size including cantering moulding the top, curing, painted black and white alternately in 23cm strips up to 0.75m from the top having reflective band 2 nos. of desired shade etc. as per design and direction complete

JOGESH DAS