Construction of New ICDS Centre at Ansari Nagar In Ward 61

Amount

Earth work excavation in all kinds of soils except hard rock requiring blasting, inclusive of shoring, strutting and baling out water wherever necessary refilling the sides of foundation with excavated earth in layers of 15cm thick well rammed and consolidated depositing the surplus earth within compound in places as shown by the deptl.officers, clearing and leveling the site with initial lead of 10M and lift of 2M etc.Comp.SI.No.62-rate for 10m3

Supplying and filling in foundation and basement with Quarry Dust in layers of 15cum thick well rammed and consolidated including watering complying with std. specification etc.

Cement concrete 1:4:8 (one cement four sand and eight aggregates) Using 40mm gauge hard broken granite jelly for foundation inc. consolidation and dewatering for foundation wherever necessary etc.complete.

Brick work in CM 1:5 (One cement and five sand) using III class ground moulded bricks of size 8 3/4"X4 1/2"X2" including curing etc., complete For Foundation and Basement.

Brick work in CM 1:5 (one cement & five sand) using II class ground moulded bricks of size 9"X43/8"X 2 3/4" including finishing, curing,etc., complete complying with standard specification G.F

Supplying and erecting shuttering with necessary supports for plith beam with all cross brancings etc..,complete(Rcc coloumn footing plinth beam and lintel sides)

Supplying and erecting shuttering with necessary supports for plain surface such as RCC boxing side slab, and similar,RCC Slab with all cross bracings etc., complete in all floors of any height (The retrieved materials should be taken back by the contractor). The payment for centering shall be given after the concrete is laid. (Vertical Portion Only) using steel plates10m2.

Supplying and erecting shuttering with necessary supports for plain surface such as RCC boxing side slab, and similar,RCC Slab with all cross bracings etc., complete in all floors of any height (The retrieved materials should be taken back by the contractor). The payment for centering shall be given after the concrete is laid. (Lintel & Sunshade) using steel plates10m2. Bottom Only

Reinforced cement concrete 1:1 1/2 :3 (One cement One and half sand and three aggregate) using 20mm machine broken gauge bard granite jelly for RCC worksthe rate excluding the cost of reinforcement grills,centering and shuttering etc., complete in F&B

Supplying fabricating and placing in position of MS grills for reinforcement rate inc. the cost of steel for all works (the rate to include cost of binding wire also). Below 16mm Dia

Plastering with CM1:5(one cement and five sand) 12mm thick10m2.

Plastering with CM1:3(one cement and five sand) 10mm thick10m2.

Paving the floor with design Antiskirt ceramic tiles (colour and shade as directed) of size 305 mm x 305mm x 6 mm in all floors over a base layer of cement mortar 1:3 (one cement and three sand ) 20mm thick laid in-situ and pointed with same coloured cement

Paving the floor with design Rajasthan kotta tiles (colour and shade as directed) of size 610 mm x 610mm x 20mm in all floors over a base layer of cement mortar 1:3 (one cement and three sand ) 20mm thick laid in-situ and pointed with same coloured cement

Supplying and Fixing of cudappah slab 20-30mm thick.

Supplying ,fabricating and fixing in position of Alumi. Anod. natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu .Box section of folowing sizes for frame and shutter with necessary accessories such as rubber beading, Al.Clips,Best double action floor springs,Aluminium Handle on both sides ,floors topper,Tower bolt,Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beamsor Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi .surface must be anodised with mattf in is hunder electrically controlled condition in accordance with IS specification 1868 /1962 of Anodic fil thick ness of not less than 15 Microns (Fifteen) for all sections.

Supply in gand fabrication and fixing in position of anodised natural colour matt finish sliding window in two track in all floors with following sizes . All the three shutters with slinding arrangements , the bottom section should have Gutter arrangements so as to drain the water entering and made with extruded aluminium section for outer frames as shown below with necessary accessories such rubber beading . Aluminium clips, rubber beading, handle and fixing 4mm thick clear sheet glass including all required for fabrication etc. ,complete. Necessary dismantling making holes in RCC columns ,beams ,masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing as directed by the departmental officers .The Al .Surfaces is to be anodised with matt finish under electrically condition in accordance with ISI 1868/1962 specification for an

Labour charges for over head wiring from EB pole to pumproom by fixing 32mm dia GI pipe to the required height over roof slab of pumproom and as directed by EB authorities including fixing M.S. clamp set, U.Kondi, 7/20 GI wire, 7/20 PVC insulated copper wire reels, T.W. meter board, aerial board, earth plate GI Bolt of nuts, PVC Hose fuse wiring etc. complete

Wiring with 2x2.50 sq.mm PVC unheated SC Aluminium cable of 650 V grade in suitable PVC rigid pipes in wall or ceiling with PVC accessories with TW switch box in flush with wall covered by hylum sheet3mm thick and painting with suitable colour of 14 SWG TC wire for light point.

Supplying and fixing of 48” AC ceiling fan with 300mm down rod on the existing clamp with regulator with complete set

Supply and fixing of single box type 4'40W flu Fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu. Tube with PVC unsheated leads from terminals to the fitting.

Weathering Course with Concrete Broken Brick (S.I.No.278) & ( P & D) Data 54.Jelly 20mm gauge in pure slaked lime (no sand to be added) over roof slab,the proportion of brick jelly to lime being '32 to 12.5 well beated with wooden beaters for giving required slope and thickness as directed by the departmental officers.etc., complete.-1 m 3

Finishing the top of roof with one course of machine pressed tiles of size 200 mm x 200 mm x 20 mm of approved quality in Cement Mortar 1:3 (One Cement add three sand) 12 mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete

White washing two coats with freshly burnt shell lime white in colour in all floors including cost of lime and other materials brushes scaffolding charges etc.complete complying with standard specification and as directed. -100sq.m S.I.333

Painting two coats with Oil bound Distember over one coat of wall primer

Painting 2 coats with approved cement paint over cement plastered wall surface, ceiling and other new surface and including cleaning, preparing the surface and curing etc., complete.

Providing water closet 580mm size orissa type indian make with (P) Trap including ixing a pair of foot rest over a bed of brick jelly concerete in LM 1:2 using 40mm broken brick jelly 100mm thick and top plastered with CM 1:3 20mm thick etc. cost of water closet foot rest and trap each

Add GST 18%

shrihariengineering (BID ID -1245622)