CONSTRUCTION OF BOUNDARY WALL FROM MAGAZINE POST TO CSD GATE AT 111 INF BN TA KUMAON AND IRON GATE AT THE ENTRY OF MT PARK OF 641 SATA BTY AT NEW CANTT PRAYAGRAJ.

Amount

Excavation in trenches, not exceeding 1.5m wide and not exceeding 1.5m in depth, for foundation etc or for shaft, wells, cesspits, manhole, pier holes , laying of cable etc not exceeding 10 sqm on plan and getting out in soft /loose soil complete all as specified and directed. Note :- For the digging of soil, JCB machine will not be allow at site, it will be done by labour only and contractor will be responsible to repair the existing cable , pcc plinth etc without extra cost which will be damaged during execution of work.

M&L for plain cement concrete 1:4:8, type D2 using 40 mm graded crushed stone aggregate as in foundation filling, sub base of floor complete all as specified and directed.

Removing excavated materials exceeding 50m and not exceeding 250 Mtr & depositing where directed at a level n.exc 1.5m above the starting point, complete all as specified & directed.

Returning, filling in including spreading, levelling watering and well ramming in layers not exc. 25cm thick complete all as specified and directed.

Use & waste of formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified and as directed

Use & waste of formwork to sides of pillars, posts, struts, piers, columns and stanchions with rough finished surface complete all as specified and as directed

Use & waste of form work to sides and soffit of floor or roof beams, beam haunching, girders, bressumers, lintels, cantilevers, shelves including supports, overhangs, etc rough finished complete all as specified and as directed

M&L TMT bar 10 mm dia and over, cut to length, bent to shape required ,including cranking ,bending spirally for hooping for columns, hooking end and binding with and including mild steel wire and annealed not less than 0.9 mm dia or securing with clips complete all as specified and directed.

All as per item no 8 but 5mm dia and over up to and including 10mm dia in stirrups, spacers and binders complete all as specified and directed.

M&L for Reinforced cement concrete 1:2:4 using 20 mm graded stone aggregate as in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete with necessary form work complete all as specified and directed. Note:- Reinforcement & formwork to be measured & paid separately under respective item.

M&L for Reinforced cement concrete 1:2:4 using 20 mm graded stone aggregate as in Columns, pillars, piers, posts and struts with necessary form work complete all as specified and directed. Note:- Reinforcement & formwork to be measured & paid separately under respective item.

M & L for Reinforced cement concrete design mix M-25 using 20 mm graded stone aggregates in lintels over 1.5m clear span, beams and cantilevers complete all as specified and directed. Note:- Reinforcement to be measured & paid separately under respective item.

M&L for brick work with fly ash bricks old size , straight or curved on plan exceeding 6M mean radius, built in cement mortar 1:6 complete all as specified and directed

M&L for rendering 15mm thick in CM 1:4 on fair faces of brick work or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed.

M&L for Preparation of newly plastered surfaces of wall and applying two coats of cement based paint over & including a coat of primer complete all as specified and directed.

S&F PVC (SWR) pipes, Single socketed, in any length with rubber ring joints, fixed to walls 110 mm bore complete all as specified and directed.

S&F mild steel work with angle iron, flat iron, channel etc. as in post and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire etc, flat iron fillets (For securing wire mesh etc) including all necessary drilling, bolting or riveting etc, and similar articles conforming to Fe-290 Gde E-165 complete all as specified and directed.

M&L for preparation of new or previously untreated surfaces of steel or iron of any description over 10cm width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

M&L for galvanized 2 strand 2.24 mm dia steel barbed wire, barbed with 2mm dia barbs at 75mm (approx.) spacing and straining and fixing to any type of post, straining bolts, including securing or tying at crossing with and provision of galvanised mild steel wire, staples or steel pins etc. complete all as specified and as shown on the drawing including straining bolts complete all as specified, directed and shown on drawings. Note:-Each line of wire to be measured separately

M&L for Granite 20mm thick (of any type) work (table rubbed and polished) for wall lining (veneering to wall) 12mm thick in cement mortar (1:3) and pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite over 10 mm thick rendering in cement mortar 1:4 complete all as specified and directed.

M&L for 10mm thick rendering in CM 1:4 on brick or concrete surface and finished even & fair complete all as specified and directed.

Supply & laying of XLPE cable of size 10 Sqmm 2 core Insulated screened PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor using lugs both end of cable& wrapping pvc tape over XLPE insulation cable and testing complete all as specified & directed. Note :- Excavation & earth work, sand cushioning, bricks protection where required shall be measured & paid separately)

Supply and laying sub class 'B' bricks laid dry and flat across the length of cable for protection of cable complete all as specified and directed.

M & L for sand cushioning with Ganga Sand to underground cable (8 cm thick before laying and 15 cm thick after laying the cable complete all as specified & directed. Note:- Punned thickness of sand shall be measured for payment.

M&L in replacement for GI tubing 'light grade' of 40 mm dia with all necessary fittings laid in trenches/under road crossing/fixed on pole/wall/under floor as garden post including 2 Nos Mild steel FI 35 x 3 mm size to support pipe with pole complete all as specified & directed.

S&F in replacement pole box junction three phase of size 297x 250 x 130 mm, made of 2 mm MS sheet factory painted with synthetic enamel paint, and in built locking arrangement, out door type , fix to pole with suitable MS clamp comprising of aluminium busbar 16 Amp 04 Nos fix on epoxy insulated support and including MCB 6 Amp 10 KA 240 volt complete all as specified and directed.

S&F in replacement of PVC insulated PVC sheathed stranded weather proof flat twin core cable with aluminium 2.5 Sqmm two core complete all as specified and directed.

S&F in replacement gate light 35 watt new generation IP 65 LED post top, energy saving, environmental friendly long life aesthetically designed with good indirect symmetrical light distribution, die cast aluminium landscape luminaire with high power COB LED as light source with PVC insulated & sheathed stranded copper conductor cable three core of size 2.5 Sqmm complete all as specified and directed. Make:- Havells Cat Part No. ENDURASPRING6PT35WLED757PSYMTOTG / Philips Cat No. BG200 LED 35CWPSCGRCPCSPD or equivalent make as specified in P.S.

Tara Enterprises (BID ID -3121601)

Technological Associates (BID ID -3114757)

KHALSA BUILDER (BID ID -3123539)

YASH ENTERPRISES (BID ID -3120551)