BWN/Rs. 1.99 Lacs/Special repair of VIP Launge in the Ch. Bansi Lal Air Strip at Bhiwani in Bhiwani Distt.

Amount

Providing and filling in position bitumen mix filler of proportion 80 kg. of hot bitumen, 1 kg. of cement and 0.25 cubic metre of coarse sand for expansion joints(HSR 6.57)

Providing and fixing of chicken wire mesh for avoiding cracks in plaster with necessary nail/screws etc. complete in all respect to the entire satisfaction of engineer-in-charge(HSR 11.17)

Pointing on tile brick work with cement mortar 1 :3 (1 cement : 3 fine sand):Flush/ Ruled/ Struck or weathered pointing(HSR 11.26.1)

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade New work (two or more coats) over and including water thinnable priming coat with cement primer (HSR 11.64.1)

Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength conforming to IS: 4454 - part 1 and M.S. top cover of required thickness for rolling shutters.80x1 .25 mm M.S. laths with 1.25 mm thick top cover(HSR 13.37.1)

Extra for providing mechanical device chain and crank operation for operating rolling shutters. Exceeding 10.00 sqm and up to 16.80 sqm in the area(HSR 13.39.1)

Removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete(HSR 30.21)

Finishing walls with Acrylic Smooth exterior paint of required shade: Old work (Two or more coat applied @ 1.67 litre/ 10 sqm) on existing cement paint surface(HSR 30.37.1)

Renewing glass panes and refixing existing wooden fillets Float glass panes of nominal thickness 4 mm (weight not less than 1O kg/sqm)(HSR 30.56.1)

PARDEEP KUMAR