Constr of FOL Dump for storage of all type of FOL and Provn of drainage line for passage of water of CHDH and JCOs Mess alongwith Soakage Pit at 2 ASD (17 FAD), Kasubegu under GE (East) Fzr Cantt.

Amount

Excavation in trenches in soft/loose soil not exceeding 1.5 metre wide and not exceeding 1.5 metre deep and getting out complete all as specified and directed

M&L Hardcore of broken bricks of gauge n. exc 63mm, deposited spread and leveled in layers n exc 15 cm thick watered and rammed to a true surface complete all as specified and directed

M&L Plain cement concrete (1:4:8) type D-2 using 40mm graded stone aggregate as in foundation filling as mass concrete or in sub base of floors complete all as specified.

M&L Mild steel 10mm dia and over TMT bars as in reinforcement cut to length bent to shape required including cranking, hooking at ends and binding with mild steel wire (annealed) not less than 0.9mm dia complete all as specified.

M&L Mild steel 8mm dia TMT bars as in reinforcement cut to length bent to shape required including cranking, hooking at ends and binding with mild steel wire (annealed) not less than 0.9mm dia as in stirrups complete all as specified.

Use & waste wooden form work (rough finished) to sides of foundations footing,plinth Beams, etc complete all as specified and directed

M&L for Formwork to sides of pillars, posts, struts, piers,columns, and stanchions Square, rectangular or polygonal etc. complete all as specified and directed

M&L for Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping) complete all as specified and directed

M&L Reinforced cement concrete (Design mixed M-25) using 20mm graded stone aggregate as in columns, Footings and the like complete all as specified.

M&L Reinforced cement concrete (Design mixed M-25) using 20mm graded crushed stone aggregates as in beams, cantilevers, bressummers, lintels over 1.5 metre span and chajjas complete all as specified and directed.

M&L Reinforced cement concrete (Design mixed M-25) using 20mm graded crushed stone aggregates Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and directed.

M&L Cement concrete (1:2:4) type B-1 using 20 mm graded crushed stone aggregate as in plinth protection, 50mm thick, surfaces finished even and fair without using extra cement as in plinth protection including provision of construction joints complete all as specified and directed.

Returning filling in, including spreading, leveling, watering and well ramming in layers not exceeding 25 cm complete all as specified and directed.

Removal of surplus soil to a distance not exc 50 metre and depositing where directed at a level not exc 1.5 metre above the starting point complete all as specified.

M&L cement concrete 1:2:4 Type B-1 using 20 mm graded crushed stone aggregate in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, as directed

M&L Brick work in cement mortar 1:6 using sub class ‘B’ old size bricks, straight or curved on plan exceeding 6 metre mean radius complete all as specified.

M&L rendering/plastering, 15mm thick in cement mortar (1:4) on any face of brick walls or concrete surfaces finished even and smooth without using extra cement complete all as specified.

M&L Rendering/plastering, 15mm thick in cement mortar (1:6) on any face of brick walls or concrete surfaces, surfaces finished even and smooth without using extra cement complete all as specified.

M&L rendering/plastering, 5mm thick in cement mortar (1:3) on concrete surfaces, finished even and smooth without using extra cement as in ceiling complete all as specified.

S&F Factory made box type steel ventilator with glazing bars dovetailed or welded and with one shop coat of zinc chromate primer complete all as specified and shown on Drawing No CEJZ/TD-06/07 & CEJZ/TD-07/07.

M&L Mild steel framed work of E-165 (Fe 290) as in grills/guard bars shouldered with steel window/ ventilator frames including shop coat of red oxide primer complete all as specified.

S&F 3mm thick, plain sheet glass ordinary quality and glazing, with oil putty or with wooden beads, in squares n.exc 0.50 Sqm complete all as specified.

S&F Steel rolling shutters of 1.25mm thickness, with out ball bearing, as specified incluidng top cover, anchrong rod, hasp and staple and one shop coat of primer; erected in position as indicated, coimplete; push pull or manual type complete all as specified and directed.

S&F Saftey lever locks mild steel with 4 leavers for rolling shutters complete all as specified and directed.

M&L Sand filling under floors or in foundation including watering and consolidation

M&L 40mm thick Cement concrete typee B-1, 1:2:4 (20mm graded aggregate) as in floor, fair finished. Complete all as specified and directed.

M&L Preparation of new steel surfaces of any description, over 10cm width or girth and applying two coats of synthetic enamel paint over primed steel surfaces complete all as specified and directed.

M&L Preparation of new plastered surfaces and applying two coats of cement base paint over a coat of primer complete all as specified and directed.

M&L Preparation of newly plastered surfaces of walls & applying three coats of white washcomplete all as specified and directed.

M&L White wash in three coats on newly plastered surfaces of ceiling including preparation of surfaces complete all as specified and directed.

M&L Surface excavation n.exc (not exceeding) 30cm deep and averaging 15 deep and getting out soft/loose soil

M&L for Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658 -2006 of 60mm thickness, M-35 Grade including 25mm thick layer of fine sand complete all as specified and directed.

S&F Continous brick edging; with width equal to the length of the brick; laid dry on edge vertically complete all as specified and directed.

M&L PCC 1:3:6 type C-2 using 40mm graded stone aggregates as in foundations bed of brick drain mass concrete etc complete all as specified.

M&L for providing precast cement concrete type B-1 1:2:4 in Drain cover including necessary form work excluding reinforcement and set in CM 1:4 complete all as specified and directed.

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped end etc.

S&F as in repairs XLPE insulated, armoured,1100 volts grade, heavy duty cable of size 35 Sqmm nominal cross section, 4 core, flat or circular, PVC FRLS insulated aluminium conductor, served with inner sheathing of galvanized steel wire or tape and over-all PVC FRLS sheathed in service connections, laid in trenches, duct, through pipe, in floor, on pole including jointing and testing, complete all as specified and directed.

M&L dry and clean fine sand for cable cushioning to underground cable protection, complete all as specified. (Excavation and earth work measured separately).Note- Punned down thickness shall be measured.

S&F Cover to underground cable with one layer of bricks using sub class ‘B’ bricks (old size) laid flat across the cable complete all as specified and directed. (Excavation and earth work measured separately).

S&F Mild steel galvanised pipe, light grade, 50 mm nominal bore for passing of cable, fixed to poles/walls, laid under floor/road crossings, complete with and including clamps socket & elbow etc complete all as specified and directed.

M&L for Flame proof point wiring with 1.5 Sq mm (nominal area), one light/fan point controlled by one switch for explosive atmosphere with 1100 volt grade PVC insulated Halogen Free Retardant (HFFR) insulated & unsheathed 1.5 Sq mm stranded copper conductor cable, with continuous earth wire of 1.5 Sq mm stranded copper conductor cable PVC insulated HEER & unsheathed, drawn in & including surface ERW rigid stove enameled steel conduit not less than 20 mm dia with aluminium alloy flame proof conduit fittings and accessories including flame proof junction boxes suitable for flame proof totally enclosed (TE) rotary type switch as per requirement at site complete all as specified and directed.

S&F switch Flame proof totally enclosed rotary type with termination box in LM-6, 16 Amps single pole 250 volts and including aluminium body enclosure with threaded cover with toggle action switch operated by a surrounded knob single pole with double entieries through way suitable for 20 mm dia ERW threaded rigid steel conduit approved by CMRI as per Sudhir Cat No. RI/OA/1010-2A or equivalent in Flexpro/Blinga/Shayam Switch gear as approved by GE

S&F switch Flame proof junction box in LM-6, with plain cover 3/4"ET 2 way 20 mm dia size, approved by CMRI all as specifed and directed. Make :- Sudhir Cat No. JB/OA/104 or equivalent in Flexpro/Blinga/Shayam Switch gear as approved by GE

S&F switch Flame proof junction box in LM-6, with plain cover 3/4"ET 3 way 20 mm dia size, approved by CMRI all as specifed and directed. Make :- Sudhir Cat No. JB/OA/104 or equivalent in Flexpro/Blinga/Shayam Switch gear as approved by GE

S&F switch Flame proof junction box in LM-6, with plan cover 3/4"ET 4 way 20 mm dia size, approved by CMRI all as specifed and directed. Make :- Sudhir Cat No. JB/OA/104 or equivalent in Flexpro/Blinga/Shayam Switch gear as approved by GE

S&F Flame proof totally enclosed type Fluorescent tube light fitting 1 x 28 watt (T5) FLP-WP made of aluminium alloy LM-6 with electronic ballast bipin holder, connector block etc complete with all accessories pre wired and including connecting up with twin core twisted flexible copper conductor cable on wall/ceiling, approved by CMRI complete all as specified and directed. Make:-Sudhir/Shyam switch gear Pvt Ltd.

S&F BULK HEAD CFL light fitting flameproof type FLP-WP of 1x 26 w built in control gear box made of aluminium alloy LM6 , with all accessories, ballast, lamp holders, etc. internally prewired complete all as specified and directed.

S&F Flame proof exhaust fans single phase, 230V, 50Hz, of 380mm sweep, 1440 RPM, including Louvers, Bird Catcher & Mesh Front, approved by CMRI as per Sudhir Cat No. EF/140 or equivalent in Flexpro/Blinga/Shayam Switch gear as approved by GE.

S&F Flame proof MCB SP 'B' series upto 25 Amps 240/415 volts, 50 Hz 10KA breaking capacity, ISI marked (IS : 8828), duly approved by CMRI complete all as specified and directed. Make:- Sudhir Cat No.RI/OA/1010 or other equivalent makes as approved by GE

S&F Flame proof MCB SNP 'B' series 25 Amps 240/415 volts, 50 Hz 10KA breaking capacity, ISI marked (IS : 8828), duly approved by CMRI complete all as specified and directed. Make:- Sudhir Cat No.RI/OA/1010 or other equivalent makes as approved by GE

S&F Flame proof sheet metal enclosure for 4 way, MCB DBs SPN 240 volt double door type powder coated with bus bar, neutral link, earth bar & din rail, ISI marked, complete, including fixing of MCB/ Isolator/ RCBO/ RCCBs/ ELCBs etc, complete. (MCB/ Isolator/ RCBO/ RCCBs/ ELCBs shall be mesured and paid for separatly under respective items), duly approved by CMRI complete. Make:- Sudhir/Flexpro/Blinga as approved by GE

M&L for Earthing complete with galvanized steel plate elecrode of size 60 cm x 60cm x 6.0 mm thick burried directly in ground vertically to a depth not less than 2.5 mtr below the ground level with top edge of earth plate at a depth not less than 1.5 mtr below ground level. Earth plate surrounded by 15mm thick packed alternative layers of charcoal dust and comman salt, earth lead GI wire of 4mm dia (8 SWG) by means of bolts , nuts, check nuts and washers of galvanised iron with thimbles. The other end of GI earth wire is connected to main switch board and protected by light grade GI pipe of 15 mm bore. provision of 20mm bore light grade GI pipe for watering including GI funnel and wire mesh. Pipe shall be provided vertically upto top level of earth pit and then taken horrizontally to the earth pit. Cement concrete chamber of PCC ( 1:3:6 ) type C-2 using 40 mm graded stone aggregate.The chamber shall be constructed one metre away from edge of earth pit. 50 mm thick pre cast cover of cement concrete (1:2:4) type B-1 using 20 mm graded crushed stone aggregate and MS angle iron 50 x 50 x 6 mm frame including two coats of painting over a red oxide to exposed steel surfaces. excavation in soft / loose soil, returning filling and removal of surplus soil to a distance of 50 mtr as directed and shown in Electrical Plate No- 3 of SSR Part-1 (2009) . complete all as specified and directed.

S&F Earth continuity conductor or main earthing lead fixed to wall on batten or recess or chases or buried in ground or drawn in conduit/pipe or fixed to poles or any other indicated situation for loop earthing etc as required 4 mm dia galvanised iron or steel wire. complete all as specified and directed.

M/s Vishant Construction Co

manoj and company

S S BUILDERS

M/s Sanjiv Kumar

M/s Harkesh Kumar Bansal

M/s Bansi Lal

KAMALJIT SINGH CONTRACTOR