Balance work for providing LWSS to NC PC habitation of Gaonsari Gokswari in GP Goansari and Providing LWSS to NC PC habitation of C V Sunapani Khashdhar in GP Khashdhar tehsil Chirgaon Distt Shimla HP

Amount

Excavation in foundation and trenches etc.(for pipes & pits) in earth work in all kinds of soil such as pick work, jumper work, blasting soft or hard rock or by chiselling soft or hard rock where blasting is prohibited in all leads and lifts including trimming / dressing of sides and bed, stacking the excavated soil clear from the edge of excavation and returning the excavated soil after completion of work in 15cm layers when required into plinth, sides of foundation etc. consolidating each deposited layers by ramming and watering and then disposing of all surplus excavated soil complete in all respect as per direction and to the entire satisfaction of the Engineer-in-Charge.

Providing and laying cement conc. 1:3:6(1 cement:3 sand:6 graded stone agg. 40mm nominal size) and curing complete excluding cosot of form work and reinforcement of RCC work in foundation and plinth with in all leads and lifts as per direction and to the entire satisfaction of the Engineer-in-charge.

Providing and laying cement conc 1: 1½ :3 (1cement:1:1½ sand :3 graded stone agg. 20mm nominal size) and curing com-plete excludidng cosot of form work and reinforcement for RCC work in foundation and plinth with in all leads and lifts as per direction and to the entire satisfaction of the Engineer-in-charge in:-

Foundation,footing basis of columns & the likeand mass concrete.

Walls (any thickness) but not less that 0.10 Mtrs. hick including attached pilasters buttresses plinth and string course from top of foundation upto floor two levels.

P/L cement conc. 1:2:4(1 cement:2 sand:4 graded stone agg. 20mm nominal size) and curing complete excluding cosot of form work and reinforcement of RCC work in all leads and lifts as per direction and to the entire satisfaction of the Engineer-in-charge.

In suspended floor roofs landing shalves & their support balconies,beams, girders bressumers cantilevers upto floor two level

Providing form work with steel plate 3.15 m.m thick welded with angle iron 30x30x5 m.m so as to give a fair finish including centering ,shuttering, propping etc. height of propping and centering below supporting floor to ceiling upto all heights and removal of the same for in-situ reinforced conc.and plain conc.work in :-

Vertical surfaces such as walls (any thickness)portions and the like including attached pilaster buttresses plinth and string course and the like

Flat surface such as soffits and suspended floors, roofs, landings and the like: Floors etc. up to 200mm in thickness within all leads and lifts

Providing tor steel reinforcement for RCC work including bending, binding and placing in position i /c binding wire complete up to floor two level complete in all respect as per direction & to the entire satisfaction of Engineer-in- Charge upto all lead & lifts.

Providing in RCC works smooth finshing of the exposed surface with cement mortor 1:3 (1 cement:3Sand)

Boulder filling behind retaining wall/crate wall as per the satisfaction and direction of Engineer in Charge.

First class brick flooring laid dry and grouted with cement morter 1:4 (1 cement :4 sand) including finishing the joints flush.

Laying jointing of G.I pipes (L.G) ,tube fitting in trenches i/c earth work complete for inlet and scour pipe including all leads and lifts.40 mm (L.R)

Providing and fixing gun metal wheel valve (with hand wheel ) including all leads and lifts

Providing and placing in horizontal layers filtering media duly graded, screened cleaned and washed as per specified in all respectas per direction & to the entire satisfaction of Engineer-in- Charge upto all lead & lifts.

Bottom Layer: Broken stone 50mm to 75mm

Fourth layer: Bajri 20 mm to 25mm

Third layer: Bajri 6mm to 20mm

Second layer: Coarse sand, 3mm to 6mm

Top layer : Fine sand( Eff. Size 0.2mm to 0.4mm and uniformity co- effcient 2 to 3mm)

Steel work welded in built up sections,trusses & framed work i/c cutting, hoisting & fixing in position & applying a priming coat of red paint :-In grating, framed ,guards, bars, ladders, railing,brackets & similar works with in all leads and lifts as per the entire satisfaction & direction of the Engineer Incharge

White washing with lime on undecorated wall surfaces(two coats) to give an even shade I/c thoroughly brooming the surface to remove all dust dirt & other foreign matter complete with in all lead & lifts and to the entire satisfaction of the Engineer-in-Charge.

Providing and fixing Man Hole cover with frame & stair case of M.S. sheet and angle size 600x600mm(weight of Main-Hole & stair case arenot less 35kg & 75 kg). Including welding and cutting charges as per direction of Engineer in Charge.

10mm Cement plaster in single coat in fair side of brick /stone masonry for interior plastering up to floor two level including arises internal rounded angles chamfers and/or rounded angels not exceeding 80mm in earth and finished even and smooth including all leads and lifts a) 1:3 (1Cement:3sand).

Painting two coats(excluding coat) on new wood and wood based surface with enamel paint to give an even shade including cleaning the surface of dirt,dust and other foreign matter,sand papering & stoping with animal paint other then white and as per direction & satisfaction of the Engineer- in- charge upto all lead & lifts.

Providing and fixing ridges or hips 60cm over all with 0.60 thick prepainted steel sheet in roofing with bot dipped metallic zinc coated sheet with top coat of regular modified polyster (RNP) organic coating to back coat of polyster of 5 microns over 5 miscron premier coating including fixing with prepainted iron J or L hooks, bolts and nuts 6mm dia mtr.with prepainted limper and rubber washers complete with all accessories as required as per direction of Engineer-in-charge.

Supplying and fixing woven plain GI fencing of mesh 50 to 150mm to any type of standard rails strainging bolts etc. i/c provision of binding wire etc.

Providing and fixing GI sheet for roofing as per the direction of Engineer-in-charge.

Bottom Layer: Broken stone 50mm to 75mm

Laying, jointing and testing in trenches galvanized mild steel screwed and socketed pipes of following diameter and class, tube fittings in trenches i/c carriage of pipes from Sub-Divisional Store to site of work,(Earth work in trenches to be measured and paid for separately) complete in all respect and to the entire satisfaction of the Engineer-in-charge: (LR):

15mm dia (LC).

20mm dia (LC).

25mm dia (LC).

40 mm dia (LC).

Providing and fixing G.M.S tubes for interconnection between sed./tank ie G.I Elbows, tees, unions nilppes etc. & welding of iron flat both side of (scour.over flow, inlet pipes, interconnection pipes etc.) DIA.(40mm --65mm) as per direction of Engineer in Charge.

SHAHIN NEGI

AJAY CHAND SHARMA

SURINDER SINGH

NEGI RAM

sanjeev kumar

CHAIRMAN

Yogesh Chauhan

Vikram Rithwan Contractor