Providing 12 Meter Mini-mast Light pole with 6 Nos. 150W LED flood light arrangements in Arulmigu Mahadevar ThiruKovil at Thittachal in kanyakumari district

Design, supply,erection, testing and handing over of Mini Mast structure Bajaj/Philips make or equivlalent with required number of continuously tapered hot dip galvanized steel polygonal sides sections with telescopic strip joints to a total height of 12 meters capable of sustaining the maximum wind pressure at the erection site with single flange base plate secured welded in the bottom of the base mast section with vertically movable hot dip galvanized lantern carriage and accessories such as electrical junction box brackets for providing 6 Nos. of flood light luminaries with control gear box complete head frame assembley,. Pulley drive, stainless steel wire rope single/double drum self lubricating winch arrangement suitable for raising and lowering the luminaries carriage ring flexible multi core power cable including supply and fixing the following accessories in the Mast. (a) High powered power tool complete with hand held control panel and motor with push button type remote control switch suitable for 3 phase 415 V 50 Hz for raising and lowering of the lantern carriage complete to operate all fittings mounted in the base to couple with winch - 1 set(b) Feeder pillar box comprising 0.90m x 0.45m x 1.20m floor Alu frame with 40A Four Pole MCB 1 No, 63A power contactor with automatic timer arrangements & reversing starter for 3 phase motor -1 set(c) Neon aviation obstruction light (Bajaj BJAOL (2) / equivalent -1 No(d) 2 Nos of special GI earth electrodes with copper plate 300 x 300 x 3mm and copper flat (1" x ¼") interconnection as per ISS complete with earth connection -1 set(e) Hot dip galvanized lightening arrestor -1 No(f) Flood light luminaries of specially heavy type water proof Dust proof integral luminaries fitting provided with 150 W LED Light fitting Crompton / Philips make or equivalent with 150W LED bulb with drives, Alglas coated reflectors, with cable connection etc, complete as per standard specification -6 Nos (SOR.2025-26)

Supply and laying of 4 x 10 sq.mm PVC armoured LTUG cable in trench to be excavated at a depth of 0.75 m putting 0.15 m layer of sand and covering the cable completely with bricks, sand and refilling the earth to make good (SD-180)

Supply and clamping of 4 x 10 sq.mm PVC LTUG armoured LTUG cable on post or on wall with MS Clamps. (SD - 203)

Supply and fixing of 4 x 10 sq.mm brass cable gland for 4 x 10 sq.mm PVC armoured LTUG cable with earth connection. (DATA -A)

Supply and fixing of TNEB meter board suitable for 32A three phase service connection with 3 Nos. 32A fuse unit (500V) 32A neutral link and earth link (1" x 1/8" copper flat) on TW plank of size 600mm x 450mm x 19mm with supporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit with 1 No 40 Amp 30 MA Four Pole RCD / RCCB (Lower End) with suitable necessary connection. (SD 129)

Supply and run of 4 of 6 sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with continuous earth Wire connection of 6 sq.mm copper wire with painting of suitable colour. (SD 62)

Supply and run of 4 x 6 sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V grade in 32mm dia GI pipe (Class 'B') suitably bent at both ends with necessary angle iron up right and end supports for mains. (SD 73)

Supply and run of 4 x 6 sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V on 7 / 20 GI bearer wire for service connection mains. (SD 68)

Renewal by supply and fixing of 4 way Vertical Triple pole and neutral MCB sheet steel enclosure distribution board with double door (metal) with 1 no. 40 A 4P MCB as incoming and 1 No 32A TP MCB and 9 nos 6 A to 32 A SPMCB as outgoing on suitable angle iron frame and MS sheet on wall with earth connection only. (DATA B)

Earthing as per the ISI specification with an earth electrode of 2.10 metre Class 'B' GI pipe of dia not less than 40mm with copper earth plate of size 125mm x 50mm x 6mm with necessary funneling arrangements with necessary masonry work and with 38mm RCC cover slab for the brick masonry (SD 221)