DRINKING WATER PUMP NEAR LALIT OROAN HOUSE AT PART NO- 11/116 UNDER MALANGI G.P.ACTIVITY CODE- 88998066/2024-25

Earth work in excavation of foundation trenches or drain in all sorts of soil including setting out, removing, spreading or stacking of spoils within a lead of 75 m. as directed and including trimming the sides of the trenches, leveling, dressing and ramming the bottom bailing out as required complete. (a) Depth of excavation not exceeding 1500mm.

(A) Filling in foundation or plinth by silver sand in layers not exceeding 150 mm as directed and consolidating the same by thorough saturation with water, ramming complete including the cost of supply of sand. (payment to be made on measurement of finished quantity) (Page No-01, Item No-03)

Single brick flat soiling of picked jhama bricks including rammering and dressing bed to proper level and filling joints with local sand.

Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement,if any, in ground floor as per relevant IS codes.(b) River bazree (Page No-24 of 315,ItemNo-4(a)

Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20mm nominal size) excluding shuttering and reinforcement if any in ground floor as per relevant IS codes. b)River Bazree

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction.(a) For works in foundation and upto roof of ground floor/upto 4 m (i) Tor steel/Mild SteelI. SAIL/ TATA/RINL (Page No-44, Item No-40) I) In Ground Floor

Hire and labour charges for shuttering with centering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (upto roof of ground floor).(f) 25 mm to 30 mm shuttering without staging in foundation. (Page No-42, Item No-36)

(a) 25 mm to 30 mm thick wooden shuttering as per decision & direction of Engineer-In-Charge.

125mm thick brick work with 1st class brick in cement mortar (1:4) in ground floor.

(Page No-192, Item No-01) Labour for Chipping of concrete surface before taking up Plastering work.

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface]

(ii) With 1:4 cement mortar (c) 10 mm thick plaster

Artificial stone in floor, dado, staircase etc.with cement concrete (1:2:4) with stone chips, laid in panels as directed with topping made with ordinary white cement (as necessary) and marble dust in proportion (1:2) i/c smooth finishing and rounding off corners and i/c application of cement slurry before flooring works, using cement @ 1.75 kg/sqm all complete i/c all materials and labour. In ground foor ii) 25 mm thick.

M.S.or W.I. Ornamental grill of approved design joints continuously welded with M.S, W.I. Flats and bars of windows, railing etc. fitted and fixed with necessary screws and lugs in ground floor (i) Grill weighing above 10 Kg./sq.mtr and up to 16 Kg./sq. mtr.

Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.(B) Wall With Sand Cement Mortar (1:4) 20 mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m & joint filling using white cement slurry @ 0.20kg/Sq.m (Page No.- 64 Item No. - 35) (b) Area of each tile above 0.09 Sq.m (i) Coloured decorative

Neat cement punning about 1.5mm thick in wall, dado, window sill, floor etc. NOTE:Cement 0.152 cu.m per100 sq.m.

Applying decorative cement based paint of approved quality after preparing the surface including scraping the same thoroughly (plastered or concrete surface) as per manufacturer's specification . (iii) Two coats

(a) Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. (Page No.- 200 Item No. -1)

A)Painting with best quality synthetic enamel paint of approved make and brand including paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc on the surface, if necessary. a)on timber or plastered surface iv)two coat

Earth work in filling in foundation trenches with good earth, in layers not exceeding 15 cm, including watering and rammering layer by layer complete. a)with earth obtained from excavation of foundation.

Installation of Information signe board 900 mm X 1200 mm of vinale sticker on ACP sheet painting letters information and fixing at site. (LS)

Supply & Delevary of submercsible pump directly coupled with 2.0 Hp shingle phase 250 V watered cooled submersible motor for instllation for 80 mm dia Deep tubewell as per fallowing specification

Supply & installation of sutable pump control panel with volt meter,Amp meter & DOL starter with necessary relay and drawing of power line from main maximum up to 25mtr.

Febrication of MS structre with base plate and fustnut / jumpnut on the base Panels on the structure as per standard & approved drawing. The Panels will then be connected to the Pump, Controller which in turn will be connected to the pump as well as the level indicator of the water tank as per direction of the E.I.C. (LMR)

Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting will be made seperately) . PVC Pipes (pump to tank) 32 mm Dia

(tank to tap) 20 mm Dia

Supplying, fitting and fixing Ball Valve, 25 mm (Page No-33, Item No-Q) of S & P Schdl.)

Supplying, fitting and fixing alloy iron with brass spindle bib cock/ stop cock of approved brand and make, spray painted and tested to 21 kg per sq. cm. 20 mm (Page No-07, Item No-g) of S & P Schdl.) (1 stop cock + 2 Bib cock)

Supplying P.V.C. water storage tank of approved quality with closed top with lid (Black) – Multilayer (b) 1000 litre capacity

Supply of PVC pipes & fittings (medium duty) conforming to ASTMD -1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). (i) 100 mm dia. 40 mm Dia

PVC Pipe- 20mm dia.

Reducing Socket (mm X mm) [ Page 18 (S&P) It. 19 (iii) ]100 X 50

Supplying PVC strainer of approved make with adapter conforming to I.S.12818 specifications.(i) 50 mm dia.[ Page 52 (S&P) It.6 ]

Supplying, fitting and fixing steel cutter piece upto 450 mm long with sockets.(i) 50 mm dia [ Page 53 (S&P) It.9 ]

Supplying, fitting and fixing G.I. cap at top [ Page 54 (S&P) It.18 ]50 mm

Making soak well of Precast concrete ring 50 mm thick 750 mm dia (inside) with RCC cover slab including eartwork in excavtion and ramming side after construction (each ring of 300 mm height) (LMR)

GST @ 18% of gross amount

Labour Welfare Cess @ 1% of gross amount