PROVISION OF HIGH MAST WITH LED OF 250 WATT LIGHT FITTINGS 06 NOS EACH AT EAPL WAPL CAPL MAGAZINE AREA 02 NOS AND DSC PT GROUND AT TECH AREA TAKU CPE ITARSI UNDER GE BHOPAL

Amount

Note :(i) Please refer Sch A/ BOQ Notes before quoting the tender for all phases/ items mentioned below. (ii) Amount of Schedule of credit shall be deducted offline

Excavation in trenches in hard/dense soil not exceeding 1.5 mtr wide and not exceeding 1.5 mtr in depth and getting out for foundation, laying under ground cables, hard standing etc complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc. 250 mm thick complete all as specified and directed.

Removing of surplus excavated materials to a distance not exc. 50 Mtr away and depositing where directed at a level not exc. 1.50 mtr above the starting point complete all as specified and directed.

M&L for dry sand cushioning in trenches for protection of UG cables (below, above and around the cable) and consolidated (punned) complete all as specified and directed. Note: Punned thickeness of sand will be measured for payment purpose.

M&L for reinforced precast concrete cable cover, class LV, Type I, flat, size 250 x 150 x 40mm for cable protection complete all as specified and directed.

Supply, errecting, testing and commissioning of High Mast pole system consisting of two section suitable for 55 m/s wind speed alongwith head frame, made out of hot dip galvanised steel structure 16 Mtrs long, steel wire rope 6mm dia 97/19 gauge, double drum winch, luminiaries carriage suitable for 06 luminiaries in symmetrical arrangement and other accesories manufactured in factory with raising lowering system comprising double drum winch, trailing cable, connector, integral power tool motor, manual handle, junction box, lightining finial with and including supply of foundation bolts, nuts, washers, anchor plate and common template and outdoor stand mounted feeder pillar with 32 A, TPN, MCB incomer, single dial time switch, 25 A TP contactor for the automatic switching of luminiaries, power tool control with 2 No 9A contactors and raise lower push button, incoming 25 sqmm and out going 2.5 sqmm terminals with all connected items as required at site complete all as specfied and directed with and including of following specifications:-. Note: (i) High Mast pole system shall be of approved make. (ii) All materials incorporated in pole system shall be as per recommedation of manufacturer. (iii) Cost of Aviation light, feeder piller box, copper cable from feeder piller box to LED light fitting is deemed to be included in the quoted rate. (iv) Cost for excavation, RCC foundation etc. shall be born by the contractor and design should be as per manufacturer recommendations & no extra amount will be paid to the contractor on this account. (v) Wiring material from junction boxes to individual luminiare & MCB in base compartment are not included in quoted rate. (vi) High Mast pole shall be of make: Bajaj/ GE/ Crompton/ Philips/ Havells.

HIGH MAST SYSTEM Height of mast : 16 Meter No. of Section : Two Material Construction : S355 Grade as per IS 2062/BS-EN10 025 Base dia and top diameter (A/F) : Top : 150mm & Botton : 460 mm Cross section of Mast : 20 side polygon Standard for Galvanisation : A per BS EN ISO 1461 Size of Opening and door at base : 1200 x 2500 mm Diameter of base plate : 570 mm Thickness of base plate : 25 mm Lighting protection finial : GI single spike of length 1200mm Max. wind speed : 55m/s as per IS 875 (Part III) Number of foundation bolts : 12 Nos PCD of foundation bolts : 590 mm Type / diameter / length of foundation bolts : TS 600/30mm dia/ 850 mm long

LUMINAIRES CARRIAGE Material of construction : 50 NB ERW Class B-M.S Pipe Diameter of carriage ring (mm) : 535 mm (ID) Construction : 08 Arm, Welded, 2 Sections Load carrying capacity : 16 Luminaire

TRAILING CABLE Conductor : Copper, 5 core, 2.5 Sqmm Insulation : PVC Flexible No.of circuits per mast : One No cable per mast

WINCH / POWDER TOOL Type /SWL of winch : Double drum, SWL 750 Kg Method of Operation : Integral Motor Motor Capacity : 1.0 HP ( Including suitable starter) No of Speeds : 6 Pole, Single speed Torque Limitor : With Mechanical Tripping Facility

STAINLESS STEEL WIRE ROPE Grade / construction : AISI 316, 7/19 Construction Number of Ropes : Two Continuous Diameter (mm) : 6 mm, 97/19 guage, Breaking load Capacity : 2350 Kg x 2

Supply and fixing LED flood light 250 Watt 230 V AC outdoor type with thermal management in multiple optics and equipped with IP66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply, installation, commissioning and testing factory made, CPRI approved, outdoor type distribution panel board of adequate size, made of mild steel sheet of 3.15 mm thick, powder coated, dust & vermin proof, front and rear openable, double door, compartmentalized, general construction confirming to latest IS with locking arrangements, suitable for 3 phase, 4 wire, 415 V, 50 Hz with 400 Amps rated copper bus bar, including mounting on angle iron frame made using angle iron 50 x 50 x 6mm (30cm below & 45cm above GL) with two coat of synthetic enamel paint over a coat of red oxide primer and grouted in PCC 1;2:4, B-1 (using 20mm graded stone aggregate) fixed with bolts, nuts, washers and making necessary connection complete all as specified and as directed and shall be comprising the following :-

INCOMER :- (a) MCCB 125 Amp, FP, Thermal Magnetic release, 35 KA, 415 Volts - 01 No OUTGOING :- (a) MCCB 63 Amp, TPN, Thermal Magnetic release, 25 KA, 415 Volts - 02 Nos (b) MCB SPN 32 Amps - 01 Nos (c) Indicating lamps (Set of 03 Nos) - 01 Set.

M&L for earthing complete with galvanised steel earth plate electrode 600x600x6mm thick, buried directly in ground vertically at a depth not less than 2.25 m and top edge of plate at a depth not less than 1.50 m below GL, connected to earthing lead of galvanized steel strip 25x4mm by means of bolts, nuts, check nuts and washers of galvanised steel from earth plate to test oint upto 7.5m including all as shown in electrical plate No. 3 of SSR Part I (2009) including necessary concrete chamber in cement concrete M15 (Nominal Mix) using 20 mm nominal size coarse aggregate, precast RCC cover slab in cement concrete M15 (Nominal mix) using 20 mm nominal size coarse aggregate of size 40 cm X 40 cm X 5 cm reinforced with 8 mm dia TMT bars @ 150 mm c/c both ways with one handle for lifting made out of 8 mm dia bar, GI funnel, GI wire mesh filter, 20 mm dia GI pipe medium grade for watering, 40 mm dia GI pipe medium grade for protection of earthing lead, charcoal or coke and salt in alternate layers including necessary excavation and earth work in any type of soil/ strata and testing compelete all as specified and directed.

S&L of XLPE cable 1100 Volts grade, heavy duty of cross-sectional area 25 Sqmm, 3.5 core with aluminium stranded conductor served with an inner sheathing of PVC tape armoured with galvanised steel strip and overall PVC sheathed, connecting and testing complete all as specified and directed.

S&L of 40mm bore GI tubing light grade for cable protection laid under road/ floor or fixed to poles complete all as specified and directed.

SIYA ASSOCIATES

pyarelal galar

RAGHAVAY CORPORATION

M/S RAKESH TRADERS

M/S HARSH VIKAS GALAR ENGINEERING

M/s Prayag Construction

Oasis Infosystem Private Limited

TANUJ CONST. CO.

Paragon Electrotechnics

kay pee construction

HARNAM SINGH ANIL SINGH