REPAIR TO DRAINS CHAIN LINK FENCING FOOTPATH COMPOUND WALL AND HARDSTANDING ETC AT VIMAN NAGAR AND CHANDAN NAGAR FOR SMQS AND OTMS AND TECH AREA IN SOUTHERN PART OF RUNWAY UNDER AGE BRII OF GE AF LOHEGAON AT AIR FORCE STN PUNE

Amount

Demolition of brick work or stone boulder masonry built in cement or cement lime mortar complete all as specified and directed.

M&L for Pre-cast cement concrete block masonry with solid blocks, exc. 10 cm of type C1 1:3:6 using 20mm graded aggregate in width and setting in mortar 1:6 , complete all as specified and directed.

Ditto- all as per item ser No 2 above except block or slabs set in cement mortar 1:6 complete all as specified and directed.

Demolition of cement concrete (Unreinforced) in ground floors and pavings n exc 15cm thickness (Below or above Ground level) as in surface channel, coping etc. complete all as specified and directed.

M&L for Cement concrete C2 1:3:6 (40mm graded aggregate) in surface channels and drains complete all as specified and directed.

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped complete all as specified and directed.

Ditto all as per Srl Item No 6.00 but add or deduct for each for 25 mm girth or part thereof over or under 30cm

Providing Cement concrete type D2 1:4:8 (40mm graded aggregate) as foundations, filling and mass concrete complete all as specified and directed.

Taking down cement plaster any description and the like on brick or stone walls, etc including raking out joints,hacking for key, scrubbing down with water etc. complete all as specified and directed.

M&L for 15mm thick in CM 1:4 rendering on brick or concrete surfaces finished even & smooth on wall complete all as specified and directed.

Providing, cement concrete type B1 1:2:4 (20mm graded aggregate) as in coping kneelers, apex stones, bed plates, kerbs complete all as specified and directed.

Demolition of cement concrete (Reinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed.

M&L for Providing precast cement concrete Type B1 1:2:4 using 20mm graded stone aggregate as in cover slabs set in cement mortar 1:4 complete all as specified and directed.

Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc. laid, bedded and pointed in cement motar complete all as specified and directed.

M&L for 15mm thick Screed bed or bedding layer for laying floor finishes in CM 1:6 complete all as specified and directed.

M&L for 25mm thick plain cement concrete 1:2:4 type B0 using 12.5mm graded aggregate to receive tiles complete all as specified and directed.

S & F Chequered cement concrete tiles 20cm x 20cm x 25mm/ 30cm x 30cm x 25mm thick, pre-polished set, jointed and pointed in neat cement slurry with grey/colour cement and pigment in floors complete all as specified and directed.

M&L Machine pressed precast conctete interlocking paver block any shape and size confirming to IS 15658-2006 of 80 mm thickness M-35 Grade with grey cement & pigment complete all as specified and directed.

M&L 25mm thick Sand filling under precast concrete inter locking paver floors or in foundations including watering and consolidation complete all as specified and directed.

M&L 75 thick Cement concrete type D- 2, 1:4:8 (40mm graded aggregate) laying as in Sub base complete all as specified and directed.

Preparation of old painted surfaces and applying one coat synthetic enamel paint of Concrete/plastered Surfaces of any description over 10cm girth or width, not otherwise described complete all as specified and directed.

Preparation of new or previously untreated surfaces and applying two coat synthetic enamel paint over priming paints plaster coat on Concrete/plastered Surfaces of any description over 10cm girth or width, not otherwise described complete all as specified and directed.

M&L Cement concrete work in pavement/ hard-standing of flexural strength 40 kg/per square centimetre in field using 400 kg of cement per cubic metre, thickness of concrete 25 cm or less complete all as specified and directed.

Demolition of cement concrete (Reinforced) in Roofs, floors (other than ground floors), beams, staircases, landing, chajjas and similar suspended work complete all as specified and directed.

Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports,overhangs, etc. also splays between floors and beams, etc Form work to soffits of suspended slabs such as roof slabs, floor slabs landings and similar works not exceeding 200mm thick rough finished complete all as specified and directed.

M&L Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed

Ditto- all as per item ser No 26.00 above but 6 to 8 mm dia bar.

M&L for reinforced cement concrete 1:2:4 type B1 using 20mm graded stone aggregate as in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and directed.

M&L for reinforced cement concrete 1:2:4 type B1 using 20mm graded stone aggregate as in Columns, pillars, piers, posts and struts complete all as specified and directed.

M&L for prepartion of newly plastered surfaces and applying two coats of cement based paint over Chalk whiting, on plastered surfaces, prepara-tory to distempering complete all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed.

S&F for Joist, channel, angle, or tee sections, fixed independently, without connecting plates, etc. (cut to ordinary lengths i.e. within 20mm of the length indicated) Fe-410- W(Gde- E-250) quality-A complete all as specified and directed.

S&F Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other or screwed both end each screwed end to be fitted with washers and one hexagonal or square nut, exc 10 cm but n exc 15 cm long of 5 to 10 mm dia of neck complete all as specified and directed.

Dismantling Fencing wire mesh, any type complete all as specified and directed.

S&F punched tape concertina coil of 1050 mm dia, 56 loops, 2.5 mm core wire, heavy galvanised (wire-275 GSM), tensile strength of wire 1450- 1500 N/Sqmm, (weight 15.20 Kg/Coil +/- 5%), stretchable length 15 m including securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins etc complete all as specified and as directed by Enginner-in-Charge.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

Supply only Chain link MS galvanisd fencing, having nominal pitch size 75 X 75mm and 5mm dia wire complete all as specified and directed

S & F Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. complete all as specified and directed. (Note :- Each line of wire to be measured)

Excavating in post holes (or similar holes) in hard/dense soil each n exc 0.5 cu. m, getting out, returning filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, complete all as specified and directed.

M & L for Cement concrete type B2 1:2:4 (40 mm graded aggregate) in foundations, filling and mass concrete complete all as specified and directed.

S & F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, fordoors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

R k construction

S.R.M.K Enterprises