ADDN/ALTN TO THREE BATHROOMS OF KHINSAR BLOCK (BLDG NO P-285) AT MIC and S AHILYANAGAR

Dismantling kota, granite, cudappah stone slabs and interlocking tiles of any description or thickness in floors, aprons etc laid, bedded and pointed in any mortor complete all as specified and as directed.

M&L for machine cut Kota stone flooring 20 to 22 mm thick (minimum size of kota stone slab 22"x18") laid over and including 20 mm thick bedding layer of cement mortar 1:6, jointed with grey cement slurry mixed with pigments to match the shade of slab including cutting, rubbing and mirror polishing including removing dust complete all as specified and as directed.

M&L for machine cut cudappah stone slab 20-25mm thick for cooking platform, wash basin, sink etc including cutting chases in wall and fixing the slab in cement mortar including rubbing and polishing complete all as specified and as directed.

M&L 18 to 20mm thick pre-polished granite stone slab of approved shade and colour as in table top, top of WHB, kitchen slab/platform, gate pillars, cills etc or on vertical surfaces including vertical projection, urinal partition, including full round moulding the edge, laid over and including screed bed 15mm thick in cement mortar 1:4 jointing, pointing in white cement 1:2 using marble dust with admixture or pigment to match the shade of granite and rubbing, polishing to achieve mirror finish complete all as specified and as directed. Note: Colour and shade shall be as approved by GE.

Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing) removing rubbish off the premises complete all as specified and directed.

M&L for glazed coloured ceramic tiles in vertical surfaces as dado of size 450x300x6-7mm, thick set and jointed in neat cement and pointed in white or coloured cement to match over and including 10mm thick rendering in CM 1:3 on other than fair faces of brick work etc complete all as specified & directed. Note: Color, size and shade shall be as approved by Engineer-in-charge

M&L for non skid coloured ceramic tiles 7-8mm thick (square or rectangular) area of each tile exceeding 0.06 sqm but not exceeding 0.11 sqm in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match over and including 15mm thick screed bed in CM 1:6 etc complete all as specified & directed. Note: Color and shade shall be as approved by Engineer-in-charge

Demoltion of cement concrete (un-reinforced) in ground floors and paving not exc 15cm thickness (below or above ground level) complete all as specified & directed.

M&L for 75mm thick PCC 1:3:6, type C2 (using 40mm graded stone aggregate) as in plinth protection, etc finished the surface even and smooth without using extra cement including provision of joint of size 10 mm wide & 10 mm deep and filling with bitumen mastic joint filling at every 3m length and at corners complete all as specified and as directed.

M&L for 75mm thick plain cement concrete 1:4:8 type D-2 (using 40 mm graded stone aggregate) as in sub base of floors and pavings complete all as specified and as directed.