CAMOUFLAGING PAINTING TO CERTAIN BLAST PENS, TRANSVERSE WALL, BLDGS, WSA-I, WSA-II AND PERIMETER WALL AT AF STN

Amount

PCC (1:2:4) type B-2 using 40 mm graded stone aggregates as in foundation filling & mass concrete, complete all as specified.

100 mm thick, cement concrete type D-2, (1:4:8) using 40 mm graded stone aggregate, finished even & rough, as in sub floors, complete all as specified.

Rendering 15 mm thick on fair faces of brick work or concrete surfaces, finished even and fair on walls in cement mortar (1:4) including taking down existing cement plaster, any description on walls etc including raking out joints, hacking for key, scrubbing down with water etc,complete all as specified.

Uprooting tree/plants upto 30 cm girth from wall or any part of building upto double storey buildings completly to the entire satisfaction of Engineer-in-Charge, making good the disturbed portion and filling holes in cement mortar (1:3) or PCC (1:2:4) type B-1 using 20mm graded stone aggregate to match with existing surfaces and removal of rubbish outside MOD land complete all as specified.

Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm of any colour hving tensile strength of 550 Mpa as in roof coverng/ cladding to wall, fixed with self tapping screws comlete all as specified.

Prepration of old plastered or un-plastered surface of ceiling and applying one coat of white wash complete all as specified.

Prepration of old plastered or un-plastered surface of wall and applying one coat of white wash complete all as specified

Prepration of old plastered wall surfaces and applying two coats of interior acrylic distemper complete all as specified.

Two coats of exterior acrylic emulsion over a coat of exterior (water based) primer on new plastered surfaces of wall, pillars, cornices in disruptive/camouflaging pattern of four shades including preparation of surfaces, complete all as specified.

Two coats of exterior acrylic emulsion on old wall surfaces, wall, pillars, cornices in disruptive/camouflaging pattern of four shades including preparation of surfaces, complete all as specified.

Two coats of exterior acrylic emulsion on old treated surfaces of concrete, path and slab in disruptive/camouflaging pattern of four shades, including preparation of surfaces, complete all as specified.

Two coats of exterior acrylic emulsion on old treated surfaces of concrete, pillars, cornices & RCC over head tank in disruptive/camouflaging pattern of four shades, including preparation of surfaces, for height not exceeding 25 metre, complete all specified

Two coats of synthetic enamel on old treated surfaces of CGI sheet, in disruptive/camouflaging pattern of four shades, including preparation of surfaces, complete all as specified.

NOTES APPLICABLE TO SRL ITEM 9 TO 13 HERE-IN-ABOVE: (i) Exterior acrylic emulsion & primer shall be applied only through approved applicators, authorised by the manufacturers for such works. (ii) Entire quantity of material for this work shall be procured by the contractor from manufacturer's Depot & deposit the same with Enginer-in-Charge and same shall be issued to contractor on daily basis as per consumption at site. (iii) RGB value of four shades of disruptive/camouflaging pattern shall be all as shown on Drg No. GE/SK-1/19 sheet 1/2 & 2/2. (iv) The rate quoted by the contractor shall included for scaffolding and necessary formwork.

Two coats of exterior acrylic emulsion over a coat of exterior (water based) primer on new surfaces of concrete, path and slab including preparation of surfaces, complete all as specified.

Two coats of exterior acrylic emulsion over a coat of exterior (water based) primer on new plastered surfaces of wall, pillars, cornices including preparation of surfaces, complete all as specified.

Preparation of old painted wood and wood based surfaces of any description not other wise described over 10cm width or girth and applying one coat (finishing coat) of synthetic enamel paint complete all as specified.

Preparation of old painted steel & iron surfaces of any description not other wise described over 10cm width or girth and applying one coat (finishing coat) of synthetic enamel paint complete all as specified.

Dismantling plain or corrugated steel sheeting, any gauge, thickness, including Nainital or similar pattern roof coverings, complete all as specified.

Demolition of cement concrete (unreinforced) in ground floors and pavings not excceding 15cm thickness (above or below ground level) all as specified

M/s Sahib and Company (BID ID -3085383)

AAR KAY BEE ENTERPRISES (BID ID -3085426)

MALHOTRA AND ASSOCIATES (BID ID -3084522)

LABH SINGH AND SONS (BID ID -3087577)

J.K & Company (BID ID -3086398)