Improvement of Compound wall painting and Art Painting in Rajaji Street and Muthurangan Street Ward No.49 at Zone 4 Tambaram City Municipal Corporation

Providing and laying of Hot Applied Thermoplastic Compound 2.5 mm Thick including Reflectrorising Glass breads@250 Gms per Sqm Area.Thickness of 2.5mm is Exclusive of Surface Appled Glass breads As per Irc:35. The Finished Surface to Be Level Uniform and Free From Streaks and Holes etc Completed As per Morth & Specification No 803

Providing and fixing reflective road studs of ‘category A’ Raised pavement markers made out of poly-carbonate / methyl methercrylate/ABS moulded body confirming to ASTM D 788 and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face with retro reflectance and chromaticity values conforming to ASTM D4280. The reflective raised pavement markers shall also confirm to the MORTH circular No RW / NH. 33023/10/ 97-DO. III dt 11.06.97. The height, width and length shall not be less than 15 mm, 90 mm and 100 mm and with minimum reflective area of 13 Sq.cm on each side and the slope to the base shall be 35 +/- 5 degree. Each reflector shall have a CIL not less than values specified in Table 2 of said MORTH circular. The strength of detachment of the integrated cylindrical shanks, (of diameter not less than 19 +/- 2mm and height not less than 30+/- 2 mm) from the body is to be a minimum value of 500 Kgf. Fixing will be by drilling holes on the road for the shanks to go inside, without nails and using epoxy resin based adhesive as per manufacturer’s recommendation and complete as directed by the engineer. The marker shall support a load of 13635 Kg tested inaccordance with ASTM D4280 and confirming to IRC35 - 2015 guidelines and MoRT&H specification 804 etc., complete

Supply and fixing of Solar raised pavement Markers made of Polycarbonite molded body, solar powered, LED self illumination in active mode, 360 degree illumination and reflective with micro prismatic lens capable to Morth and ASTM D 4280 Type H. The project should be resistance Etc

Supplyng amd laying of Chipping of concrete and roughening the surface

Plastering with Cement Mortar 1:5 (One cement and Five Plastering sand), 12mm thick in all floors including mortar plasticizer at 200ml per 50Kg of cement used, curing etc. complete complying with standard specification and as directed by the departmental officers.

White washing two coats with freshly burnt white shell lime in all floorsincluding cost of lime, blue powder fevicol type gum, brushes,scaffolding charges, etc., complete complying with standardspecification and as directed.

Colour washing two coats in all floors using best freshly burnt white shell lime and best quality of approved variety of colouring pigmentincluding cost of lime, colouring pigments, fevicol type gum, brushes, scaffolding charges etc., completecomplying with standard specification. Mineral colouring pigments not affected by lime should only be used (stainers and colour solutions should not be used.)

Painting and Lettering for child education awarners in the Wall using standard painting necessary colur pigments including cost of all materials ,labour etrc., complete