REPAIR TO BOUNDARY WALL, OPEN BRICK DRAIN AND RCC CULVERTS AT CQA (I) ESTATE, LADPUR RAIPUR UNDER GE(I) (P) FY KANPUR.

Amount

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles.

Demolition reinforced cement concrete of any description and in any position not otherwise specifically provided for

Demolition of concrete in ground floors and pavings exc 15 cm thickness (below or above ground level)

Dismantling of existing wrought iron or mild steel work of any description not otherwise provided for.

Dismantling of old rusted/damaged barbed wire from fencing post upto 3 mtr height all as specifed as directed.

Excavating of soft/loose soil in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out.

Excavating over areas, soft/loose soil n exc 1.5 m deep and getting out.

M&L for cement concrete in 1:4:8 (40 mm graded aggregate), Type D 2 in foundations, filling and mass concrete.

S&F Mild steel TMT bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips.

S&F Mild steel TMT bars 5 mm dia and over upto and including 10 mm dia in stirrups, spacers and binders, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips.

M&L formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter with flat and rough finished surface of concrete.

M&L formwork to sides of pillars, posts, struts, piers, columns and stanchions, with rough finished surfaces of concrete in square, rectangular or polygonal shape.

M&L formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. with flat and rough finished surface of concrete

M&L formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter with flat and rough finished surface of concrete.

M&L fair finish surface of formwork to faces of walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc.; vertical or to batter.

M&L Reinforced cement concrete (nominal mix) in 1:2:4 (20 mm graded stone aggregate) for foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm.

Removing excavated material exc. 250 m but n exc. 500 m and depositing where directed

M&L Reinforced cement concrete (nominal mix) in 1:2:4 (20 mm graded stone aggregate) for columns, pillars, piers, posts and struts.

M&L for cement concrete in 1:3:6 (40 mm graded aggregate), Type C 2 in foundations, filling and mass concrete.

M&L brickwork with subclass ‘B’ bricks, straight or curved on plan exc 6 m mean radius built in 1:4 cement mortar.

M&L for providing, cement concrete 1:2:4 (20 mm graded aggregate) type B1 in roof kerbs or mud stops, cills coping etc.

M&L reinforced cement concrete (nominal mix) in 1:2:4 (20 mm graded stone aggregate) for walls, retaining walls, basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilaster and buttresses.

M&L Type C1, 1:3:6 (20 mm graded aggregate) providing, cement concrete in kerbs, coping or mud stops, rounded or chamfered on edges water troughs and the like including weathering, slightly rounded or chamfered angles and throating, as directed

M&L for plain cement concrete in type B 1 (1:2:4) 20 mm graded aggregate for surface channels and drains finished smooth without using extra cement.

M&L Rendering 15 mm thick on fair faces of brick work or concrete surfaces finished even and smooth without using extra cement in 1:4 cement mortar.

Applying two coat of cement base paint over and after preparation of newly plastered surface.

M&L for mild steel for post and stuts, etc including screwing bolts, cutting tops to shape, drilling holes, notching for wire etc.

M&L framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165

M&L for applying two coat of synthetic enamel paint over a coat of primer (red oxied) over and after preparation of untreated steel surfaces of any description over 10 cm width or grith.

M&L for Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured).

S&F concertina coil galvanized 600 mm dia (50 turn per coil) blade thicknes 0.50 mm fixed on angle iron post over RCC column or brick wall including necessary fixing elemnts.

S&F 110 mm dia bore PVC (SWR) pipes single socketed, in any length with rubber ring joints, laid in trenches or in floors.

sidh builders

P K ASSOCIATES

M/S P K ARORA

Tridev Construction Company

DEEP ENTERPRISES