MISC REPAIRS TO BOUNDARY WALL, HARD STANDING FENCING AND CERTAIN B/R REPAIR IN MD ACCN UNDER ZONE-I AREA AT JAIPUR MIL STN

Amount

M&L for preparation of old concrete surfaces of any description over 10cm girth or width, not otherwise described and applying one coat of synthetic enamel paint (1st quality) complete all as specified

All as per item No 1 above but two coats of synthetic enamel paint

M & L for preparation of old surface of walls and applying one coat of cement paint of appoved tint all as directed.

All as per item No 3 above but two coats of cement base paint

M&L preparation of old steel surface and applying one coat of synthetic enamel paint (1st quality) all as specified

Demolition of cement concrete in ground floors and pavings not exc 15cm thickness (below or above ground level)

M & L plain Cement Concrete1:4:8 type D-2 (40mm graded aggregate) in sub base of floors

M & L 100 mm thick plain Cement Concrete1:4:8 type D-2 (40mm graded aggregate) in sub base of floors

Demolition stone slabs and tiles of any description or thickness in floors, aprons etc laid, bedded and pointed in cement mortar

M & L Machine pressed precast rubber moulded concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60mm thickness, M-35 Grade, with grey cement laid over and including 25mm thick sand cushion layer complete

M & L Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60mm thickness, M-35 Grade, with grey cement laid over and including 25mm thick sand cushion layer complete

All as per item No 11 above but except tiles

M&L rubber moulded chequered cement concrete tiles 20cm x 20cm x 20mm thick , set , jointed and pointed in neat cement slurry in floors with grey cement and pigment over 20mm thick screed bed in CM 1:6 complete all as directed

All as per item No 13 above but except tiles

M & L precast PCC blocks or slabs 150 mm thick (1:2:4) mix type B-1 using 20 mm graded aggregated with plain or interlocking joints as directed complete in walls setting in CM (1:6).

Demolation of precast RCC jallies of any description any in any position set in cement mortar complete all as specified.

M&L providing precast cement concrete (1:2:4) type B-0 (using 12.5mm graded stone aggregates) louvers and jallies 35mm thick (measured solid) including all mouldings but excluding frame & set in CM 1:4

M&L precast reinforced cement concrete slab type B1, 1:2:4 ( 20mm graded stone aggregate ) as in landing, drain cover slab ( for manholes etc ) , chajjas , drain cover and shelves and similar articles with plain faces . (Reinforcement shall be measured & paid separately.)

Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking , bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as directed

All as per item No 19 above but 6mm to 8mm dia

Demolition of brickwork or stone/boulder masonry, built in cement mortar or cement lime mortar including all quoins, arches, pillars, etc but excluding ashlar facings, dressed stonework and precast concrete articles.

M&L brick work with old size sub-class ‘B’ bricks, straight or curved on plan exc 6.00 metre mean radius, built in cement mortar 1:6 for raising of height of drain, manhole / wall complete all as specified.

All as per item No 22 herein before but except brick

Taking down cement plaster or cement lime plaster on brick / stone surfaces of wall or ceiling including raking outs joints, hacking for key scrubbing down with water etc

M & L rendering 15mm thick on stone masonary surfaces or surface other than fair faces of brick work on wall in CM 1:4 finished even and smooth without using extra cement complete all as directed

M & L rendering 15mm thick on fair faces of brick work or concrete surfacel in CM 1:4 finished even and smooth without using extra cement.

M & L for preparation of new plastered wall surfaces and applying two coats of cement base paint on wall

M&L for granite (of any type), 16mm to 18mm work (table rubbed and polished) in steps, jambs, pillars, window cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite including moulding and making hole complete all as specified and directed.

M & L machine cut Kota stone slab flooring 20-25mm thick,size 450x450 mm laid over and including cement screed bed 20mm thick in CM 1:6 laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete

Dismantling wroght iron of mild steel work including doors, gates but excluding framed truss etc.

S&F mild steel work such as angle iron in posts & struts in fencing including cutting tops to shape hand rail straight portion , drilled and contersunk for balusters , nosing to steps, struts in fencing including cutting tops to shape as directed , drilling holes, notching for wire etc flat iron fillets ( for securing chain link fencing ) including all necessary drilling, bolting or riveting etc and similar work conforming to Fe-290 Gde E-165

S&F framed work as in doors or gates of angle or other section with gusset plates, rails, braces etc complete drilled for fixing of steel sheeting or other covering doors etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and hanging also fastening and fixing complete

S&F mild steel round bars 10mm dia and over, cut to length, bent to shape required including cranking, bending spirally for hooping for chain link fencing.

Excavating in post holes (or similar holes) each not exc 0.50 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers n.exc 25cm, watering, and removing surplus soil to a distance n.exc 50 m and making good surface in soft/ loose soil.

M&L for PCC (1:3:6) type C-1 using 20mm graded stone aggregate as in holdfast/ mass filling

Dismantling galvanised chain link fencing of any description fixed to any type of fencing posts

Supply only chain link fencing 4 mm dia galvanized steel 100mm x 100mm mesh fixed to angle iron fencing post or angle frame complete all as directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire

S&F screw bolts (machine made) with hexagonal or square head at one head and rounded the other or screwed both end each screwed end to be fitted with washers and one hexagonal or square nut exc 10cm nexc 15cm long dia of shank 11 to 15mm.

S&F as in repair galvanized 2 strand, steel barbed wire 2.24mm dia, barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossing with and provision of galvanized mild steel wire, staples or steel pins etc as directed.

M&L preparation of new steel surface of any description n. exc 10cm in width or girth when un connecting to other painting surface and applying two coats of synthetic enamel paint over a coat of red oxide primer all as specified

S&F 2mm thick fibre glass reinforced translucent corrugated sheeting with two corrugation side lap fixed with coarch screw and washer in roof

M&L pre- painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550Mpa as in roof covering / cladding to wall, fixed with self tapping screws as specified

Dismantling plain or corrugated steel / FRP sheeting any gauge, thickness including nainital or similar pattern roof /wall covering

S&F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.1161- 1979 grade St.-240 complete all as directed.

M&L for prearation of new steel surface and applying two coat of synthetic enamel paint over a coat of red oxide primer all as specified

M&L plain cement concrete type B1 1:2:4 ( 20mm graded stone aggregate) as in lintels, cills steps, seismic and other similar bands , copings, kneelers, apex stone bed plates , kerb ,water troughs and like including weathering, slightly rounded or chamfered angles and throating as directed.

M&L for cleaning of open drain and removing of sludge/ debris from MOD land complete all specified & directed.

Dismantling boarding plywood etc of any description and in any position fixed with nails etc all as directed.

S & F 18 mm thick MDWPC (Medium density wooden plastic composite) Kitchen cupboard/door shutter of make approved by GE one side colour/white laminate and other side decorative as in modular kitchen/ cabinets/ door shutter fixed with minifix hardware where ever required including edge band 22 mm wide 0.80 m thick (of pearlwood or equivalent) of matching colour on exposed surfaces of board fixed with polymaster adhessive including trimming edges of edge band to true line of thicknesss of board by manual trimmer, fixed to wall etc complete all as directed

S & F stainless steel handles of size 100 mm fancy type of approved make complete all as specified & directed.

S & F stainless steel Auto clave hinge fancy type of approved make complete all as specified & directed.

S&F 6mm thick looking mirror with 6mm thick plywood as in back support including bevelled edge amd making holes for fixing arrangement complete all as specified.

S&F 25mm stainless steel round headed cap for fixing mirror.

Schedule of Credit

Stuti Trading Company

rathore construction co.

SAI MAX INFRAPROJECTS

M/S ROHIT CONSTRUCTION

JAGDAMBA CONSTRUCTION COMPANY

J.J.ENGINEERING

MSR INFRATECH