SPECIAL REPAIR TO MES INSTALLATION SHED AND ADJACENT IN AFCME COMPLEX AT CAMERO COMPLEX, PROVN OF PARTITION OF CABIN LOCATED AT FOYER OF RECORDING WING AND ASSOCAITED WORKS SERVICES AT AFRO BUILDING, ADDN/ALTN/IMPROVEMENT TO CERTAIN CAMERO L/IN BILLE

Taking down Chowkats or frames with shutters (without taking off shutters from the frame) area n exc 1.5 sqm each and inclu removing from site complete all as specified and directed.

Taking down Chowkats or frames with shutters (without taking off shutters from the frame) area exc 1.5 sqm and not n.exc 4.0 sqm each and incl removing from site complete all as specified and directed.

S&F for windows/ventilators fabricated from 0.60mm thick roll formed section made of galvanised steel powder coated (Base steel as per IS-513 "D" quality), galvanised as per IS- 277 with zinc of 120 gms/ Sqm). Window/ ventilator having frame suitable for dual shutter i.e. inner and outer shutter with grill, glazed and wiremesh and all fittings fixtures accessories including 6x12mm flat iron with 10mm MS square bar grills etc complete all as specified and shown in drg No CEAF/STD-191/2014 Sheet No 1/2 and 2/2 dated 11-12-2014 (4000 series) Note:- (i) Glazed shutter with 4mm thick glass, mesh shutter with 32 gauge stainless steel mesh and MS grill is deemed to be inclusive in the rate quoted for unit (ii) Glass, Stainless steel mesh will be fixed to window by authorised rep of manufacturer of window only. rate including making good the surface complete all as specified and directed.

S&F for size 105mmx60mm Pressed steel frames for doors with one or more rebates including necessary fixing lugs, hinges, hold fast, lock strike plate, and including making good with CM 1:4 and hold fast etc complete all as specified and directed.

S&F for size 125mmx60mm Pressed steel frames for doors with one or more rebates including necessary fixing lugs, hinges, hold fast, lock strike plate, and including making good with CM 1:4 and hold fast etc complete all as specified and directed.

M&L for PCC 1:3:6 type C-O (using 12.5 mm graded crushed stone aggregate) as in back filling, coping, benching on corner of joints etc complete all as specified and directed.

S&F for 35mm factory made plain framed, Flush shutters, solid core construction, with block board core and plywood face panels, commercial particle board with type on both faces complete all as specified and directed.

S&F for 35mm thick 2nd class hardwood Glazed and skeleton shutters, open rebated and prepared to receive glass, gauze, etc. (without sash bars), edges of framing plain, chamfered or rounded. fitted with cut and mitred beads for securing glass, etc.; sizes of members of shutters as specified in SSR Part I, Section 8, clause 8.24 (a); supplied and fitted to chowkats complete all as specified and directed.

M&L for Preparation of new wooden surfaces of any description, over 10 cm in width or girth, not otherwise described and applying two coat of synthetic enamel paint over a coat of pink primer complete all as specified and directed.

S&F for Stainless steel wire cloth 0.36mm nominal dia of wire and average width of aperture 1.40mm and fixed with stainless steel wire staples complete all as specified and as directed.