Renovation of Bahu Fort Park Near Bawe Wali Mata Mandir Jammu

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade, one or more coats on old work

CEMENT PLASTER (IN FINE SAND) 12mm Cement plaster of mix: 1 : 4 ( 1 cement : 4 fine sand)

Fixing glazed/Ceramic/Vitrified floor tiles with cement based high polymer modified quick-set tile adhesive (water based) conforming to IS:15477, in average 3mm thickness

Providing and fixing Aluminium Composite Panel (ACP) cladding of approved shade, colour and texture, consisting of 3mm/4mm thick ACP sheets with PVDF coating on exterior surface, fixed on aluminium/galvanized iron framework using approved stainless steel screws, rivets, cleats and brackets, including cutting, bending, grooving, routing, sealing with silicone sealant, edge finishing, necessary scaffolding, labour, tools and tackles complete as per drawings and direction of Engineer-in-Charge.

Chequerred terrazzo tiles 22mm thick with graded marble chips of size upto 6mm in floors, jointed with neat cement slurry mixed with pigment to match the shade of the tiles, including rubbing, polishing and curing complete, on 20 mm thick bed of cement mortar 1:4 ( 1 cement : 4 coarse sand) . Light shade using white cement

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with: 1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size).

Providing and laying of cement concrete flooring 50mm thick with cement concerete 1:2:4 (1Cement 2 Coarse sand 4: aggregate stone Agg. ) including complete)

Providing and fixing benches of cast iron and tubular pipe assembled with nuts and bolts of approved make three seater standered size ( 6 feet) and weight should not be less than 65 kg.

Providing, fabricating, supplying and fixing stainless steel dual dustbin (dry & wet waste) of 60 litre total capacity (30L + 30L) made out of SS 202/304 grade sheet of 0.8–1.2 mm thickness, with two separate compartments duly marked for dry and wet waste, complete with lids (swing/open/pedal type), inner removable buckets, supported on MS/SS frame or central pole, including cutting, bending, welding, polishing, necessary fittings, base plate with anchor fasteners for fixing in ground/floor, all complete in all respects as per site requirements and directions of Engineer-in-charge.

Providing and fixing precoated galvanized iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.