Relocation of 01 No. Shed from Old pumping Station to New Pumping station of Maindip including fabrications of covering sheds for 08 motors on pontoons at SOCP , IB Valley Area

Amount

Relocation of Old Shed

Dismantling steel work in built up sections in angles, tees, flats and channels including all gusset plates, bolts, nuts, cutting rivets, welding etc. including dismembering and stacking within 50 metres lead.

Extra for dismantling trusses, rafters, purlins etc. of steel work for every additional height of one metre or part thereof beyond 5 metres.

Extra for marking of structural steel work required to be re-erected.

Dismantling roofing including ridges, hips, valleys and gutters etc., and stacking the material within 50 metres lead of: G.S. Sheet

Re-fixing of Iron Profile Sheet

Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

Providingand laying in position cement concreteof specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:3:6(1Cement :3 manufactured sand derived from Recycled Concrete Aggregate (RCA) :6 graded stone aggregate 40 mm nominal size Recycled Aggregate (RA))

Providingand laying in position cement concreteof specified grade excluding the cost of centeringand shuttering - All work up to plinth level: 1:2:4(1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20mm nominal size derived from natural sources)

Covering of Motors on Pontoons

Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

Providing and fixing precoated galvanised iron profile sheets (size,shape and pitch of corrugation as approved by Engineer-in-charge) 0.50mm(+0.05%) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240mpa steel grade,5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metreoras desired by Engineer- in-charge.The sheet shall be fixed using self drilling/ self tapping screws of size(5.5x55mm) with EPDM seal, complete up to any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafter sand trusses and including cutting to size and shape wherever required.

Total impact of GST plus Labour Cess [@ 1 % (BOCW Cess to be deducted from the RA bill as per the value of the work progress)] for the purpose of CTC

Sangam Enterprises (BID ID -1164649)

RAJESH KUMAR (BID ID -1164633)