PROVN OF OPEN COVERED SHED FOR 22 B VEHS IN DIV CAMP MT AREA AT ITARANA, ALWAR

Amount

Excavation in trenches not exceeding 1.50m wide and not exc 1.50m in depth and getting out in any type of soil complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm complete all as specified and directed.

Removing surplus excavated soil to a distance exc 50 metre and n.exc 100 metre and depositing where directed at a level n.exc 1.5m above the starting point complete all as specified and directed.

M&L PCC 1:4:8, type D-2, (using 40mm graded stone aggregate) as in foundation, mass concrete or sub base complete all as specified and directed.

M&L RCC 1:2:4, type B-1, (using 20mm graded stone aggregate) in foundation including footing, plinth beam, base for column, etc complete all as specified and directed.

M&L RCC 1:2:4, type B-1, (using 20mm graded stone aggregate) as in columns, pillars, piers, posts and struts etc complete all as specified and directed.

M&L TMT bars, 10mm dia and over cut to length, bent to shape required including cranking, bending spirally for hooping for column, hooking ends and binding with and incl MS wire (annealed) not less than 0.9 mm dia complete all as specified and directed.

All as per ser item No 7.00 above but 5mm to 10mm dia as in stirrups, spacers binders etc

M&L form work to side of concrete foundation, footing, bases of columns, raft and raft beams, sides and soffits (If any) of foundation and plinth beams and similar work, vertical or to batter complete all as specified and directed.

M&L form work to side of pillar posts struts piers columns etc complete all as specified and directed.

M&L roof trusses (framed) made of structural steel Fe 410-W (Gde E-250) quality A/squre of hollow section trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (beam, tee, angle, channel or flat sections) including distance pieces, cleats etc complete all as specified and directed.

M&L structure steel post or single stanchions, made of Fe 410-W (Gde E- 250) quality 'A' /built up of hollow section, one beam or channel section with flange plates, caps, bases. splices, angle brackets, cleats and other connections complete all as specified and directed.

S&F plates (Plain or chequered) Chanels square cut or notched made of Fe 410-W (Gde E-250) quality A (ordinary and counter sunk) forming holes, without any attachment complete all as specified and directed.

M&L mild steel screwe bolts (machine made) 16 to 20mm with hexagonal or square heads at one end and screwed the other, or screwed both ends each screwed end to be fitted with washers and one hexagonal or square nut, exc 45.0cm long but n.exc 60cm long and dia of neck not less than 11mm to 15 mm complete all as specified and directed.

S&F preparation of new steel surfaceof any description over 10cm width or girth & applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

S&F Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering /cladding to wall fixed with self tapping screws complete all as specified and directed.

S&F Pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering /cladding to wall fixed with self tapping screws complete all as specified and directed.

M&L hardcore of gauge (broken bricks) n.exc 63mm deposited spread levelled in layers n.exc 15 cm thick watered and rammed to a true surface with gauze broken boulder exc 90cm complete all as specified and directed.

M&L 100mm thick, PCC 1:2:4, type B-1, (using 20mm graded stone aggregate) as in floor, finishing the suface even and smooth with out using exyra cement complete all as specified and directed.

M&L forming 12mm thick expansion joints filled with preformed bitumenous filler and top 30mm primed and sealed with sealing compound grade 'A' complete all as specified and directed.

M&L forming construction joints 65mm deep & 10mm wide filled with preformed bitumenous filler and top 30mm primed and sealed with sealing compound grade 'A' complete all as specified and directed.

Surface dressing not exc 15cm deep and getting out in soft/loose soil, cutting bushes/ shrubs, grass etc complete all as specified and directed.

M&L coloured machine pressed vibration moulded lacquer finished precast concrete interlocking paver block with grey cement and pigment of any shape and size confirming to IS-15658-2006 of 80mm thickness M-40 grade laid over and including 25mm thick layer of sand all as specified and as directed.

M&L point wiring for one light point controlled by one, one way switch with 1.50 Sqmm two single core PVC insulated and unsheathed multistranded copper conductor FRLS cable 1100 Volt grade including 1.50 Sqmm single core PVC insulated and unsheathed multistranded copper conductor FRLS cable 1100 Volt grade as continuous earth wire in green colour to common earth and connected to earth dolly laid/drawn into and including PVC casing & caping with accessories fixed on surface of walls/ceiling by means of PVC sleeves/dash fasteners with cadmium plated screws, all as per IS and including wooden boxes fixed on wall with and including 3mm thick phenolic laminated sheet top cover for mounting switches, sockets, fan regulators etc complete all as specified.

All as per serial item No 24.00 here-in-before but for one 3 pin 5/6 Amp socket outlet controlled by one 5 Amp switch on same board.

All as per serial item No 24.00 here-in-before but for one 3 pin 5/6 Amp socket outlet controlled by one 5 Amp switch on independent board.

All as per serial item No 24.00 here-in-before but for one 3 pin socket outlet 15/16 Amps controlled by one 15/16 Amps switch on independent board with 2.50 Sqmm two single core PVC insulated and unsheathed multistranded copper conductor FRLS cable 1100 Volt grade including 2.50 Sqmm single core PVC insulated and unsheathed multistranded copper conductor FRLS cable 1100 Volt grade as continuous earth wire in green colour.

S&F switch piano flush type, single pole, one way, 5/6 Amp, 230 Volts complete all as specified and directed.

S&F switch piano flush type, single pole, one way, 15 Amp, 230 Volts complete all as specified and directed.

S&F socket outlet for 3 pin (with 2 pin outlet also), 5/6 Amp, flush type 240 Volt complete all as specified and directed.

S&F socket outlet for 2 in 1, 3 pin 5 & 15 Amp, flush type 240 Volt complete all as specified and directed.

S&F ceiling rose surface bakelite 65 x 50mm two or three terminals complete all as specified and directed.

S&F decorative ultra slim liner LED lighting fixture with extruded polycarbonate, environmental friendly, energy efficient suitable for 16 Watt to 20 Watt with LED tube of model E-LITE LED Pride Plus and connecting up with and including three core, PVC insulated, sheathed copper conductore cable of required size and length from ceiling rose to fitting complete all as specified & directed. Make :- Havells Cat Part LHEXBHP71NW018 or equivalent of Philips/ Crompton Greaves /Bajaj/Wipro.

S&F LED type street DRACO SERIES light luminaire 20 Watt, 230 Volts, 50 Hz including all necessary fitting accessories and LED complete all as directed. Make : C&S Cat Part LTESS20WLED or equivalent of Crompton Greaves/Wipro

S&F sheet metal enclosures, double door type, suitable for fixing MCB SPN with 200 Amps rated bus bar, 8 way, 240 volts complete all as specified and directed.

S&F MCB 32 Amps, single pole & neutral, 240 Volts C curve, 10 KA, ISI mark as per IS/IEC 60898-1- 2002 complete all as specified and directed.

S&F MCB 6-32 Amps, single pole, 240 Volts 'C' curve, 10KA ISI marked as per IS/IEC 60898-1 2002 complete all as specified and directed.

S&F 2nd class hard wood rectangular block open recessed of size 30 x 25 x 5cm depth with 3mm thick phenolic laminated sheet top cover fixed with suitable steel screws & PVC rawl plug (4 Nos) complete all as specified and directed.

Supply, laying, jointing and testing XLPE insulated, armoured, heavy duty LT underground electric cable with stranded aluminium conductor 1100 volts grade cross sectional area 10 sqmm 2 core laid in trenches, along poles through pipes etc complete all as specified & as directed. (i) Sand cushioning, cable protection, GI protection pipe, clamps, jointing kits and excavation & earth work shall be measured & paid for separately including taking down old unserviceable XLPE cable. (ii) Road cutting/floor cutting /cutting holes etc in walls required for laying/fixing of cable etc shall be made good as per existing. Nothing extra shall be admissible on this account. Quoted rates shall be inclusive of the above provisions.

M&L brick work with fly ash bricks {As per IS-13757 (1993) burnt clay fly ash building bricks}, (Old size bricks) with width equal to the length of the brick laid dry & flat abutted with each other with gap between adjacent bricks not exc 10 mm over UG cable for protection complete all as specified & directed.

M&L dry sand (tibba sand) and punning for cushioning to under ground cable all as directed. Note :- For the purpose of payment only punned thickness shall be measured.

M&L 40mm grade GI pipe (light grade) for protection of LT cable fixed to wall /pole /road crossing including clamps complete all as directed.

M&L drilling hole under road for laying of U/G cable through pipe of suitable size complete all as specified and directed at site.

M&L earthing complete with galvanized steel earth plate electrode 60cm x 60cm x 6mm thick burried directly in ground (earth pit not less than 2.25 m deep below ground level) with top edge of plate not less than 1.5 m deep below normal ground level and connected to and including galvanized iron earth wire 4 mm dia by means of GI nuts, bolts, check nuts, washers thimbles, etc as shown in electrical plate No 3 of SSR Part-I and connection to main switch board/Test point/panel/ equipment and testing on including excavation and earth work in any type of soil, returning filling in, and removal of surplus spoil to a distance not exc 50 metre, charcoal and salt in alternate layer 15cm thick all around the earth plate electrode, MS funnel with wire mesh, GI pipe medium grade 20 mm bore for watering and 15 mm bore 3.00 metre long GI pipe light grade for earth wire protection fixed with poles with two clamps, made from MS flat 25 mmx3mm, bolts, nuts and washers, PCC chamber (1:3:6) type C1, 40mm thick precast RCC cover 1:2:4 type B1 shall be provided on CI frame etc complete all as specified & as directed.

M/S JINDAL ENTERPRISES

shiva construction

S K BUILDERS