SI-MN LINER OF SIZE 120X25 & 2.5MM

Special Eligibility Criteria

1. 1

   [i] Bulk or Entire Purchase from RDSO approved sources for the supply of Item ID :3100432, Silico- Manganese & Manganese Steel Liners & Wear Plates for Bogie and Couplers ,SubItem ID:3100432001 [ii] The tenderer quoting on behalf of approved sources must upload the tender specific authorization along with e-BID. [iii] Please refer Para 2.1 slip No. 01 of ITT_Rev_1.21_April_2024(alonwith all correction slips)

   Document requiredConfirmation required

Commercial-Compliance

1. 1

   Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items.The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

   Document requiredConfirmation required
2. 2

   No Exemption for EMD will be given to firms except to those firms as mentioned in the Instruction to tenderers ( ITT_Rev_1.21_APRIL_2024 along with all its correction slips ). If the firms, other than those exempted, fail to submit EMD along with the offer, their offer will be summarily rejected.
3. 3

   As para 12.0 of Instruction to tenderer( ITT_Rev_1.21_APRIL_2024), for Contract above 25 Lakhs, Security deposit (SD) Performance Security for stores contracts will be applicable 5% of contract value.
4. 4

   In keeping with the Public Procurement (Preference to Make in India) Order, 2017, as amended, and in terms of clause 2.4.2, 2.4.5 and 2.4.6 of Instructions to Tenderers Rev. 1.21 of April 2024, Public procurement of this item is restricted to Class - I and Class-II local suppliers only. Thus, only class-I and class-II local supplier as defined under the public procurement (preference to Make in India) Order, 2017, as amended shall be eligible to bid in this tender. Offer from vendors who do not quality to be Class - I (Local Content :minimum 50% ) or Class-II (Local Content: minimum 20% but less than 50%) local supplier, shall be summarily rejected and, therefore, such vendors should not participate in the tender. In case any vendor who does not qualify to be a Class - I or Class-II local supplier for the tendered item participates in the tender, such a bidder does so at its own risk and cost and Railways shall not be liable for any loss or damage caused to the bidder on this account.
5. 5

   Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

   Document optional

Other Conditions

1. 1

   Place of Inspection : Bidders to indicate place of Inspection of OEM.
2. 2

   By Third Party Inspecting (TPI) agencies at works/premise of manufacturer.
3. 3

   It is the responsibility of firm that the material should be packed properly so as to reach at destination safely
4. 4

   Warranty/Guarantee - In case, there is a discrepancy regarding warranty period mentioned in specification/description and standard warranty clause as per IRS condition of contract, then warranty period mentioned in specification/description shall prevail

1. 1

   Validity of Offer: No deviation from the offer validity period stipulated in the tender is permitted.