SPECIAL REPAIR REPLACEMENT TO BER COOLING APPLIANCES AT SONEGAON AND PROVN OF ATTACHED VERANDAH AT REAR SIDE OF SINGLE OFFRS LIVING ACCN AT SONEGAON NAGPUR

Amount

Supply installation testing and commissioning high wall split unit indoor & outdoor complete of capacity 1.5 Ton inverter technology split Air Conditioner in white colour single phase AC 230 volts, 50 Hz, 5 Star rating with cordless remote control unit, including necessary gas charging / topping up R-407C/410R with soldering of copper tubes as required at site all as directed by Eng-in-charge including exposed nitrile rubber and refrigerant piping covering filling the wall with plaster of paris compound & making good of Distrubed surface complete all as specified and directed. Note:-(i) Cost of MS stand (25mm x 25mm x 5mm angle iron stand) for installation of out-door unit shall be included in quoted rate. (ii) Contractor shall submit the warranty of 01 Year on Product, 1 year in condenser and 10 Years on Compressor as given by Manufacturer

Supply installation testing and commissioning of steel body desert cooler electric driven (single phase), having nominal air flow capacity of 5000 CuM per hour (or nearest size) complete all as specified and directed. Note:- (i) Contractor shall submit the warranty of 01 Year on Product, 1 year in motor as given by Manufacturer

Supply installation testing and commissioning of steel body desert cooler electric driven (single phase), having nominal air flow capacity of 4000 CuM per hour (or nearest size) complete all as specified and directed. Note:- (i) Contractor shall submit the warranty of 01 Year on Product, 1 year in motor as given by Manufacturer

Supply and fix Voltage stabilizer for automatic operation, single phase naturally air cooled indoor type & designed for input variation between 170 V to 250 V with output voltage stabilized at 230 V with accuracy of ± 2.5% and of capacity 5 KVA complete all as specified and directed.

Supply, installation, testing and commissioning top freezer refrigerator electric driven, inverter based , single phase, 250 ltrs capacity 5 star rating frost free, 230 VOLTS, 50 Hz complete all as specified and directed. Make:- LG / Whirlpool / Haier/ Samsung Note:- (i) Contractor shall submit the warranty card of 01 year on product and 10 years on compressor as given by Manufacturer. (ii) Base frame for installation of refrigerator is also included in quoted rate.

Supply, installation, testing and commissioning top freezer refrigerator electric driven, inverter based , single phase, 310 ltrs capacity 5 star rating frost free, 230 VOLTS, 50 Hz complete all as specified and directed. Make:- LG / Whirlpool / Haier / Samsung Note:- (i) Contractor shall submit the warranty card of 01 year on product and 10 years on compressor as given by Manufacturer. (ii) Base frame for installation of refrigerator is also included in quoted rate.

Supply, installation, testing and commissioning water cooler electric driven single phase having approx storage capacity of 80 litres and nominal cooling capacity 40 ltrs per hour having adjustable cold water thermostat, precoated outer body for better corrosion resistant, auto cut-out, voltage overload compressor protection and seam welded stainless tank. Make:- Voltas , Blue Star Note:- (i) Contractor shall submit the warranty card of 01 year on comprehensive and 01 year compressor as given by Manufacturer

Supply, installation, testing and commissioning water cooler electric driven single phase having approx storage capacity of 60 litres and nominal cooling capacity 40 ltrs per hour having adjustable cold water thermostat, precoated outer body for better corrosion resistant, auto cut-out, voltage overload compressor protection and seam welded stainless tank. Make:- Voltas , Blue Star Note:- (i) Contractor shall submit the warranty card of 01 year on comprehensive and 01 year compressor as given by Manufacturer

Excavation over areas in soft/ loose soil n. exc. 1.50m deep and getting out complete all as specified and directed.

Excavation in trenches in soft/ loose soil n. exc. 1.50m wide and n. exc. 1.50m deep for foundation, or for shafts, wells, cesspits, manholes, etc., n. exc. 10 sqm on plan getting out complete all as specified and directed.

Returning filling in including spreading, leveling, watering & well ramming in layers not exceeding 25cm thick in soft/ loose soil complete all as specified and directed.

Removing excavated soil exceeding 250m and not exceeding 500m and depositing where directed complete all as specified and directed.

M&L for Moorum/red bajri filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled and rammed including watering complete all as specified and as directed.

M&L for hardcore of broken stone or boulders of gauge not exceeding 63mm,deposited, spred and levelled in layer not exceeding 15cm thick, watered and rammed to true surface complete all as specified and as directed.

M&L for PCC 1:4:8, type D2, using 40mm graded stone aggregate as in foundation filling and mass concrete all as specified and as directed.

M & L for Precast reinforced concrete 1:2:4 , type B-O(using 12.5mm aggregate) in 45mm thick jallies or louvres including all mouldings and set in CM 1:4 complete all as specified and as directed.

M&L for providing RCC (1:2:4) type B-1 using 20mm graded stone aggregate as in Beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and directed.

M&L for brick work with fly ash bricks, straight or curved on plan exceeding 6 metre mean radius with old size bricks built in CM 1:6 all as specified and as directed.

Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, including supports, overhangs, etc. also splays between floors and beams complete of flat rough finished surfaces of concrete all as specified.

M&L for PCC (1:2:4) type B-1 using 20mm graded stone aggregate as in coping, kerbs, channels, water troughs and the like including weathering, slightly rounded or chamfered angles and throating etc. complete all as specified and directed.

M&L for mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends & binding with & including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

M&L for mild steel TMT bars 5mm dia and over up to and including 10mm dia in stirrups, spacers and binders cut to length, bent to shape required and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to Fe-500D complete all as specified and as directed.

S&F rolled mild steel framed work as in as in main and cross beams, hip and jack rafters purlins where connected to common rafters and running rails and guides for sliding doors fixed with angle cleats or other connecting plates Fe 410-w (Gde-E-250)quality Bcomplete all as specified and directed.

S&F Pre-painted galvalume aluminium zink coating GI based corrugated steel sheet 0.5mm thick of any colour having tensile strength 550Mpa as in roof covering/ chajja, fixed with self tapping screws as per manufacturer’s instruction all as specified and directed.

M&L rendering 15mm thick in cement mortar (1:4) mixed on fair faces of brick/ concrete surface and the surface finished even and smooth without using extra cement complete all as specified and directed.

M&L rendering 15mm thick in cement mortar (1:6) on fair faces of brick/ concrete surface and the surface finished even and smooth without using extra cement complete all as specified and directed.

M&L 75mm thick PCC (1:3:6) type C-1 using 20mm graded stone aggregate as in plinth protection/ foot path etc. finished fair and even complete all as specified and directed.

M&L for providing 75mm thick PCC 1:3:6, type C2 using 40mm thick aggregate as in sub base of floor / hard standing all as specified and directed.

M&L 40mm thick Cement concrete type B-1, 1:2:4 (20mm graded aggregate) as in sub base of flooring complete all as specified and as directed.

M&L preparation of newly plastered surface of walls and applying two coats of cement base paint over a coat of primer complete all as specified and directed.

Material and Labour for applying 2 to 3mm thick wall care putty and applying two coats of Oil Bound Distemper over a coat of primer including preparation of new plastered surfaces complete all as specified and as directed.

M&L preparation of new steel surfaces of any description not otherwise described over 10cm girth or width and applying two coat of synthetic enamel paint over one coat of red oxide primer complete all as specified and directed.

PURVA ENTERPRISES