GENERAL FUND-2024-2025

Amount

Geo physical survey charges

Drilling of 150mm (6") dia vertical clear bores in hard rode in any habitation to required depth on directed by the offices concred including labour charges for insuting PVC casing pipes as per standard specification.

upto 100m Pipe depth

Above 100 m Pipe depth

Supply of 165mm OD PVC 6 KSC casing pipe as per standard specification

Supply and delivery of wet type 50LPMx250m Headx7.50 HP mm submersible pumpset with motor and confirming to IS 8034/89 and IS 9283/79 with ISI marking

Single phase panel board (7.5 HP) with D.O.L as per standard specification. The pump set should be supplied with 5M flat submersible copper cable.

Supply and delivery of 4.00 sq mm Water Proof cable.

Supply and delivery of following pipe pipe line materials(with ISI mark) etc complete.

50 mm GI pipe with B class

50mm dia G.I Elbow

50mm G.I Capling

50mm G.M Non Retrun valve

UPVC - Column pipe 50 mm

19mm nylon rope

G.M. Gate valves

90 mm HDPE PIPE

Labour charge for the erection of submersible pump set in bore well including fixing and joint submersible cable with proper clamps upto stater to require depth and also fixing of raiser pipes to the required depth valve erection clamp pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPICN switches starter Voltmeter, Ammeter, three pilot(indicating) lamps capacitor single phase preventor, water level guard and laying and jointing the cable and twin earthing as per IS rules etc complete.

Supply and Run of 2x4 sq.mm(84/0.3) PVC insulated Sc unsheathed Cu.Conductor of 1100V grade in 25mm dia G.I pipe (Bclass) suitable bend at both ends with necessary angle iron up right and end supports for mains.

Supply and Run of 2x4 sq.mm(84/0.3) PVC insulated Sc unsheathed Cu.Conductor of 1100V on 7/20 Gibearer wire for service connection mains.

Supply and fixing of following electrical materials

16Amps MTPC Switch

16 Amps fuse carrier

Supply and delivery of MS Kiosk of size 0.75m x 0.45m x 0.75m made up of MS angle of size 50mm x 50mmx 4mm alround covered with 16 gauge MS sheet and kiosk door made up of MS plates of size 25 mm x 3 mm including cutting, welding, grinding, locking arrangements and labour charges etc.,

S& Fixing of M.S bore well Dummy

S&F M.S bore clamp

Earth work excavating and deposting on bank with initial lead of 10m& intial lift of 2m in hard stiff clay, stiff black cotton, hard red earth shales ,murram, gravel, stoney earth mixed with small size boulders etc completed as per std specification.

Plain Cement Concrete 1:4:8 Mix (one part cement, four part sand and Eight part of aggrigate) using 40 mm size ISS HBG metal from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing. Laying and curing etc., complete as per TNDSS NO : 28 & VI (S2) VI (S5A) VII standard specifications as directed by Engineer incharge.

Brick work in cement motor 1:5 mix(one cement and five sand) using 2nd class country brick of size 9"x41/2"x3" including curing finishing and cost and conveyance of materials and labour charge etc complete as per std specification.

Plastering Cemend mortor 1:5 mix (one cement and five sand) 12mm thick including cost and conveyanace of materials and labour charge etc completed as per std specification.

Lowering HDPE pipes and specials to trench and laying to proper grade and alignment and as directed by the TWAD Officers

Re filling the Excavated earth including cost and conveyance of gravel to work site and all labour charges foe stacking them to departmental gauge at road sides for preparmental officers and spreading and compacting in layers as directed by the dept officers. As per clause 301 & 305 of Morth Specification.

Writing Name board with schemes details

K Sundaramoorthy (BID ID -1234934)