Construction of Shiv Dham (Phase-I) at Kangnidhar, Mandi Distt. Mandi (H.P.)

Amount

Clearing jungle including uprooting of rank vegetation, grass,brush wood, trees and saplings of girth upto all heights above ground and removal of rubbish upto a distance of 20 metres outside the periphery of the area cleared as per the direction of Engineer in Charge.

Cutting in earth work in all kinds of soil such as pick, jumper, blasting/chiselling/wedging out hard/soft rock and disposal of excavated earth in all leads and lifts through manual and mechanical means and as per the direction of Engineer-in-Charge and stacking of useful stones in specified dimension.

Excavation in foundations, trenches etc., in earth work, in all kinds of soil such as pick work, jumper work, blasting/chiseling/wedging out of soft/hard rock in all depths including pumping and bailing out water and stacking the excavated in specified manner clear from the edge of the excavation and then returning the stacked soil in 15 cm. layers, foundations etc., consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as directed by the Engineer-in-Charge.

Filling in plinth with sand under floor including watering, ramming, consolidating and dressing complete including carriage of material in all leads and lifts.

Filling earth behind retaining wall including watering, ramming, consolidating and dressing complete including carriage of materials in all leads and lifts.

Providing form work of steel plates 3.15 mm. thick welded with angle iron in frame 30x30x5mm so as to give a rough finish including centering shuttering ,strutting and propping etc.with wooden ballies, height of propping and centering below supporting floor to ceiling not exceeding 4 metres and removal of the same for insitu-reinforced concrete and plain concrete work in. [a] Foundation, footings, bases of columns, etc. and mass concrete.

(b) Flat surfaces such as soffits of suspended floors, roofs, landing and the like Floors etc. upto 200 mm in thickness

(c) Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters buttresses, plinth and string courses and the like.

(d) Sides & soffits of beams,beam haunchings,cantilevers,bressumers and lintels not exceeding 1 mtrs. In depth in all heights from floor.

(e) Columns, Pillars, posts and Struts Square, rectangular or polygonal in plan.

(f) Columns, pillars, posts and struts Circular or curved in plan.

(g) Edges of slabs and breaks , curve surfaces in floors and walls. Under 20 cm. Wide.

Providing and laying mechanicily mixed vibrated cement concrete 1:3:6 Design Mix M-10 (1 cement:3 sand:6 graded stone aggregate 40mm nominal size) excluding cost of centring and shuttering in Foundation and plinth including carriage of materials in all leads and lifts.

(b) Walls including attached buttresses, pilasters and their caps and bases and string courses etc. upto floor two level:

Providing and laying mechanicily mixed vibrated cement concrete 1:4:8 Design Mix M-7.5 (1 cement 4 sand : 8 graded stone aggregate 40 mm nominal size ) and curing complete excluding cost of form work in: (a) Foundation and plinth including carriage of materials in all leads and lifts.

Providing and laying mechanicily mixed vibrated cement concrete Design Mix- M:25 and curing complete excluding cost of form work and reinforcement for feinforced concrete work in:including carriage of materials in all leads and lifts. (a) Foundations, footings, bases of columns and the like and mass concrete.

(b)Suspended floor; roofs landing shelves and their supports balconies ,beams, girders, bressumers and cantilevers upto floor two level.

(c)Columns, pillars, Posts, and struts up to floor two level

Wall (any thickness but not less than 0.1 m thickness) attached pilasters, buttresses, plinth and string courses etc. from top of foundation level upto floor twoy thickness) partition and the like including attached pilasters in all floor level in all heights.

Providing mild steel/Tor steel reinforcement for R.C.C. work including bending, binding and placing in position complete upto floor two level Tor steel up-to all lead and lifts. (TATA/ SAIL Make TMT Fe 500 make or equivelent ) including carriage of materials in all leads and lifts.

Stone filling behind retaining walls including carriage of materials in all leads and lifts.

Stone soling properely hand packed filling interstics with spalls and consolidating with power road roller to the requested gradient and camber including spreading watering and rolling of binding materials moorum or earth etc. complete as per HP.PWD specification. 100mm spread thickness (finished work including materials and labour). including carriage of materials in all leads and lifts.

Steel work welded in built up sections including cutting,hoisting, fixing,in position and applying a priming coat of red lead paint . In trusses and trussed purlins in buildings including carriage of materials in all leads and lifts.

Kunal Structure (India) Pvt. Ltd.