NCTPS II M I Circle MPM Unit I Mill 1H Supply fabrication Erection Testing and commissioning after dismantling

Charges for Supply of 6 mm MS plate

Charges for Supply of MS Channel and angles

Charges for dismantling the wornout mill inlet hot air duct at 8 meter level by scaffolding, marking, cutting hot air duct, inspection doors, seal air duct joint & cold air duct joint, leading & lifting, loading and transportation charges and devoluting the retrieved scraps cost of consumables and hire charges for crane , winch and T&P's.

Charges for fabrication, erection of mill inlet hot air duct (from main hot airbus to above 9 meter level as per standards and as per the direction of site incharge. work involves fabrication of duct, venturi, expansion bellows, transition bend duct with stiffner Channels angles as per drawing .Complete welding using leak testing leading lifting, loading and transporting charges special electrodes ,cost of consumables and Hire charges for crane, winch and T&P’s.

Charges for scaffolding, including supporting pipes for arresting the Hot primary air Duct-up stream and down stream of worn-out Expansion Bellow; cutting and removal of worn out Expansion Bellow :gougeing, and edge preparation; leading, lifiting and erection of new/ reconditioned Expansion Below in position ;through welding and providing cover plate inside the Expansion Bellow with one side welding, including cutting and removal of the existing cover plate ;Drawal &devolution of material including the cost of consumables special welding electrodes and hire charges for T&P’s.