eNIT-26

Amount

Dismantling of the Engine after decoupling the pump from the Engine.

Providing and fitting of ring set.

Providing and fitting of gasket set complete including head gasket set(HA394)

Providing & fitting of main oil seal set (HA394).

Providing and fitting of fuel filter element with gaskets. (HA394).

Providing & fitting of diesel filter top cover

Providing and fitting of lube oil filter element with gaskets (HA394).

Providing and fitting of fuel flexible pipe set (HA394).

Calibration/overhauling of Inline fuel pump and injectors with replacement of spares (HA394).

Providing and fitting of Dynamo belt.

Complete M.oil change to the engine after flushing the chamber with HSD to remove all un-dissolved impurities and then filling of 11.5 litres fresh M.oil (Preferred make: Indian Oil Servo/ HPCL/ BPCL Mak/ Shell Mobil)(HA394).

Dismantling of the self-starter and reassembling of the same after repairs

Providing & fitting of Carbon brush set

Providing & fitting of Carbon brush holder.

Complete servicing washing and greasing of the equipment and filling of 7 litres HSD for idle run testing and full load testing. The job further includes inspection of the entire diesel unit & checking for any loose nuts / bolts & replacing the damaged ones wherever necessary, tappet setting etc.. The HSD shall be provided by the contracting agency (HA394).

Providing & fitting of Head gasket (HA394).

Providing & fitting of Engine packing set (HA394).

Re-coupling engine after carrying out repairs & replacement.

Repairs to 05 cusec pump coupled to Diesel driven engines:-

Extraction of damaged studs of gland housing. Manufacturing, providing and fitting of 02 No’s. M.S. gland studs with nuts as per the old sample. The job shall include retapping of stud holes.

Re-metaling of pump shaft at worn-out places and then turning and finishing it to desired profile with keyway and fabrication of key

Fabrication, providing and fitting of S.S pump shaft sleeve as per old sample.

Manufacturing, providing & fitting of studs for gland housing after extracting old damaged studs and taping the threaded holes in the gland housing to accommodate the new studs as per old sample. Manufacturing, providing and fitting of Nuts is included in the job

Manufacturing, providing & fitting of G.M cooling ring as per old sample.

Providing and fitting of nuts/bolts of assorted size to the flanged joints of the suction/delivery pipes of said diesel driven pumping unit.

Providing and fitting of rubber washers/gaskets to the flanged joints of the suction/delivery pipes of the unit. 8 inch

To & fro carriage of pump by coupling the pump engine trolely to tractor from zainakote to workshop and back.

REGAL ENGINEERING WORKS (BID ID -2346991)

M/S FAROOQ AHMAD MECHINICAL WORKS (BID ID -2347088)