Annual shutdown works of Electrical control equipments of Wheel shop 2025-2026

1-Inspection and Replacement of Insulation of Electrode Arm, Bus

1.Inspection of insulation of Electrode Arm and Bus Tubes 2.Inspection of tightness of 1 all bolts of Electrode Arm and Bus Tubes 3.Replacement of damaged insulation of Electrode Arm and Bus Tubes 4.Replacement of damaged bolts of Electrode arm and Bus Tubes 5.Insulation of bus tube supporting structure and alignment of bus tubes. Rates are inclusive of GST

2-Inspection of Bus tubes at transformer secondary side (inside &

1.Inspection of tightness of all bolts of all bus tubes and copper drop plates. 2.Replacement of damaged bolts of all bus tubes and copper drop plates. Rates are inclusive of GST

3-Purging of Water Cooled Cables in EAF- A, B and C

1.Replacing damaged Bumpers 2.Purging of all Water Cooled Cables. 3.Pressure testing of all Water Cooled Cables. Rates are inclusive of GST

4-Inspection and Servicing of Heat Exchanger in EAF-A,B & C

1.Inspection of all the Valves for proper working 2.Dismantling of existing heat exchanger and servicing 3.Replacing of all the damaged Gaskets and Valves 4.Assembling back the serviced heat exchanger 5.Checks for any leakage, if any rectify the same. Rates are inclusive of GST

5-Cleaning and servicing of DSL (EAF, MRS and Sand Plant)

1.Inspection of DSL and it's alignment, Bus Angles, Supporting Insulators, Joints, 5 Jumpers and Sectional Supports of DSL throughout the Length. 2.Proper Alignment of misaligned DSL. 3.Rectification/replacement of damaged Bus Angles, Supporting Insulators, Joints, Jumpers and Sectional Supports of DSL throughout the Length. 4.Cleaning of DSL throughout the Length. Rates are inclusive of GST

6-Replacement of operator cabin ACs of EOT-2,3 and 4

1.Releasing and shifting of defective indoor and outdoor unit from EOT crane to RWF designated location. 2.Rising of new 2 ton split AC unit (indoor and outdoor unit) from ground level to EOT crane. 3.Mounting of the AC indoor unit properly in operator cabin on fabricated MS frame. 6 Including Fabrication of frame, if required. 4.Mounting of AC condenser unit properly in electrical girder on fabricated MS frame. . Including Fabrication of frame, if required. 5.Supply of brazing rods and brazing wherever required. 6.Supply of brazing rods and brazing wherever required. 7.Pressure testing, leakage testing and vacuum zing testing of the system. 8.Supply and charging the suitable gas as required. 9.Testing of the system. Rates are inclusive of GST