SPL REPAIR TO BDY WALL (SECTION BETWEEN PILLAR NO 205 TO 212, 234 TO 241, 244 TO 259, 555 TO 565, 570 TO 578, 748 TO 773 TOTAL LENGTH OF 230M) AT ENTITY B 61 WEU, HIRANKUDNA UNDER GE (NORTH) DELHI CANTT-10

Amount

Demolition of brick/stone masonry built in CM. all as specified.

Dismantling posts or struts (wood, steel or R.C.C) any section, including taking out embedded portion in concrete, brickwork, masonary, etc. and making good disturbed ground all as specified and directed.

Excavation in trenches n. exc 1.50 m wide and n.exc 1.50 m in depth for foundation etc and getting out in hard & dense soil.

Returning filling in hard/dense soil, including spreading, levelling, watering and well ramming in layer not exc 25 cm in each layer

Removing excavated material (soil) exc 9.00 km but n exc 10.00 km and depositing where directed.

M & L for PCC (1:4:8) type D-2 (using 40mm graded stone aggregate as in foundation etc complete all as specified and directed.

M & L for Pre-cast cement concrete AAC block masonry type with solid blocks set in CM 1:4, exc. 10 cm in width, complete all as specified and directed.

M & L for rendering 15 mm thick in cm (1:4) on fair faces of brick or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed.

M & L for re-inforced cement concrete M-25 (Design Mix) using 20mm graded stone aggregate as in foundations including raft footing plinth beam, bases of coloumns etc complete all as specified and directed.

M & L for re-inforced cement concrete M-25 (Design Mix) using 20mm graded stone aggregate as in coloumn etc.

M & L for re-inforced cement concrete M-25 (Design Mix) using 20mm graded stone aggregate as in beams,cantilevers,bressummers,lintels over 1.5m span. etc.

M&L for form work to sides of concrate pillars, posts, struts columns etc. and similar work.

M&L for form work to sides of concrate foundation bases of coloumn, plinth beams and similar work for rough finish surface of concrete.

M&L for form work to sides and soffits of floor or roof beams,beam haunchings,girders,bressummers,lintels,cantilevers,shelves including supports,overhangs,etc. also splays between floors and beams, etc for rough finished surfaces of concrete.

M & L for framed work such as grills grating etc with end of bars shouldered of revitted framed guard bars raillings etc.and similar works confirming to Fe- 290.Gde E-165.

M & L for TMT bars 10mm dia and over cut to length bent to shape required including cranking bending and binding with MS wire annealed not less than 0.9mm or securing with clips.

All as per item no 16 above here in before but 5 mm dia and over including 10mm dia as in sitrups, spacers etc.

M & L for two coats of synthetic enamel paint over a coat of red oxide primer on new steel surfaces including preparation of surfaces complete all as specified and directed.

M & L preparation of newly plastered surfaces of wall and applying two coats of cement base paint etc complete all as specified and directed.

S&F galvanised 2 starand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including securing or tying at crossing with and provn of galvanised mild steel wire staples or steel pins including taking down the existing barbed wire etc as directed.

S&F in repair 600mm dia concertina coil with razor blade of 0.40 thickness (min) and 2.6mm GI wire (min) with 50 rounds of coils extended into 6m of running length and minimum weight of 8.5 kgs per 50 rounds completed all as specified and directed by Engineer-in-charge.

M/S HARINDER SINGH (BID ID -3466408)

MOHIT ENTERPRISES (BID ID -3466765)

PUNEET CONSTRUCTIONS CO. (BID ID -3466259)

J.P. Enterprises (BID ID -3465847)

M/S SURINDERAS CONSTRUCTION CO. (BID ID -3471822)

QUALITY CONSTRUCTIONS CO (BID ID -3467151)